含有多孔载体的环流曝气塔处理污水的研究

利用环流塔式曝气装置并且在曝气体系中投入聚亚氨酯载体以固定微生物,可以用来同时去除污水中的COD、氨氮和硝酸氮.在气速为0.117～0.156 m³/(min·m³)之间,实验装置对氨氮具有较高的去除效率;而当气速大于0.039 m³/(min·m³)时,COD可以在1h之内得到较完全的降解.研究了载体在整个体系中的填充率对COD和氮的脱除效果的影响,当载体填充率达到15%时,可以得到较高的COD和氨氮去除水平.通过实验确定了处理过程合适的温度范围在25℃左右.     

序批式气升环流反应器处理硝基苯废水

采用序批式气升环流反应器(SAR)处理硝基苯废水,研究了硝基苯浓度和COD/N对处理过程的影响,分析了缺氧段COD和硝基苯降解动力学。结果表明,硝基苯在缺氧段被还原为苯胺,而苯胺在好氧段得到快速降解。硝基苯与基质(葡萄糖-COD)最佳质量比为1∶35~1∶25,该条件下反应器对硝基苯和COD去除率分别可达99%~100%和92%~94%。由于受传质限制,进水需要维持106 mg/L的氨氮(葡萄糖-COD/N比值为100∶10)以满足缺氧段微生物对氨氮的营养需要。缺氧段COD的降解符合二级动力学,反应速率常数k2为2.7×10-4L·mg/h;硝基苯的降解符合一级动力学,反应速率常数k1为0.14 h-1。研究表明,序批式气升环流反应器可作为一种简单而有效的反应器用于处理硝基苯废水。     

硝化微颗粒污泥快速培养及其亚硝化功能快速实现

在连续流气提内循环反应器中接种絮体硝化污泥,研究硝化颗粒污泥快速培养及其亚硝化功能快速实现过程.结果表明,通过逐步缩短HRT(由5 h降至2.5 h),3周内基本实现污泥微颗粒化;污泥微颗粒化过程中污泥颜色先由黄褐色转为米白色最后变成浅黄色;污泥沉降性能经历了由好变差再转好的变化过程,试验末期污泥SV_(30)=SV_5为4%～5%且SVI_(30)=SVI_5为12～13 mL·g~(-1);所得硝化微颗粒污泥平均粒径在134μm(第27 d时)其中近70%的微颗粒污泥粒径在59～163μm狭窄范围,即微颗粒污泥粒径分布均匀性高.随后,逐步提升反应器进水氨氮浓度(由50升至200 mg·L~(-1)),微颗粒污泥在1周内实现亚硝化率达90%以上且亚硝化负荷达1.34 kg·(m~3·d)~(-1);分析认为出水中较高的剩余氨氮浓度(27～50mg·L~(-1))或较低的DO/NH_4~+-N(0.03～0.09)是该微颗粒污泥反应器快速实现亚硝化的主要原因.     

新型内构件内循环三相流化床流体力学和氧传质特性的研究

对一种导流筒内置静态混合元件的改进型内循环三相流化床 (MITFB)的流体力学和氧传质特性进行了试验研究。结果表明 :相对于普通流化床 (CITFB) ,MITFB上升区气体含率增大 1 8— 3 7倍 ,体积氧转移系数KLa和氧转移效率EA 值平均增大 72 5 % ;而液体循环流量则减小了 2 5 6 %— 37 0 %。上升区气含率和液体循环流速可分别用Fan公式和Chisti公式预测 ,并求出了相应的参数     

气提式循环反应器处理污水试验研究

主要探讨了气提式循环反应器处理污水的几个有关问题 :载体选择 ,提升区的截面大小选择 ,载体生物膜和游离活性污泥的特点。试验结果表明 :载体材料中 ,焦炭稍优于炉渣 ,塑料效果最差 ;提升区应该存在最优截面尺寸 ,使载体的提升循环量最高 ;载体生物膜的存在 ,增加了生物量 ,提高了处理效率 ,而且是促进硝化作用的主要因素     

Control strategy of shortcut nitrification

Shortcut nitrification for ammonium-rich wastewater is energy-saving and cost-effective procedure that has become one of the hotspots in the field of biological denitrogenation. An orthogonal experiment was performed to study the combined effects of operational parameters on the performance of internal-loop airlift bioreactor for shortcut nitrification. The optimum operational parameters for the shortcut nitrification were fotmd as temperature 35 ℃, pH 8.0, dissolved oxygen concentration 1.0 mg/L, ammonium concentration 4 mmol/L and HRT 16 h, which have different influence on the performance of shortcut nitrification reactor. The pH, temperature and dissolved oxygen concentration have significant bearing on the process. The results showed that the shortcut nitrification reactor could be successfully started up within 42 d, and the reactor performance is steady with minimum NO2-/NOx- of 85.2%, maximum 93.4% and average value of 91.4% in effluent. Based on the analysis of experimental data, a new control strategy named “priority ＋ combination” for shortcut nitrification was suggested. Through this strategy, the startup and operation of shortcut nitrification for ammonium-rich sludge digester liquids were optimized. The control strategy works well to keep the reactor operation in steady state and in achieving high-efficiency for shortcut nitrification.     

气提式内循环膜生物反应器试验研究

针对膜生物反应器存在的膜污染和能耗高的问题，结合气提式内循环和一体式膜生物反应器处理废水的工艺特点，提出圆柱形套筒气提式内循环膜生物反应器。试验结果表明，同等曝气强度和曝气方式下，气提式内循环膜生物反应器中氧传质系数（KLa）高于一般膜生物反应器；膜间水流流速是一般膜生物反应器的1．53～2．44倍，提高了膜面的水力冲刷作用，可减缓膜污染；对反应器膜过滤性能的考察，表明气提式内循环膜生物反应器较一般膜生物反应器有更好的膜过滤性能和抗污染能力。反应器中添加内循环，污泥活性有所下降，但对实际废水的去除效果影响不大，污泥活性较为稳定。     

微孔塔式曝气用于石化废水处理的研究

利用微孔气体分布器对石化工业废水进行活性污泥曝气 ,并和传统曝气池进行了对比。考察了温度、气速、初始CODCr浓度和反应器结构 (鼓泡塔和环流塔 )对这种废水生物降解过程的影响。结果表明 ,微孔塔式曝气与传统的曝气池相比 ,具有降解时间短 ,占地面积小 ,有利于保持曝气过程的适宜温度等优点     

Flow characteristic and wastewater treatment performance of a pilot-scale airlift oxidation ditch

A pilot-scale airlift oxidation ditch using bubble diffuser and baffle as aerator was operated in a wastewater treatment plant (WWTP) to investigate its flow characteristic and wastewater treatment performance. Compared with the conventional oxidation ditch process, effective depth and oxygen utilization efficiency of this new process was improved by underwater aeration. Furthermore, it had a reversed velocity distribution, which decreased from the bottom to the top on vertical section. Velocity measurement showed that a velocity over 0.2m/s at the bottom was sufficient to prevent sludge settlement during long term operation. Application of these concepts would save land area and energy consumption by about 25%―50% and 55%, respectively. In this new system, organic biodegradation and nitrification could be well achieved. Denitrification could occur steadily in the straight part by adjusting the airflow rate. An average TN removal rate of 63% was achieved with dissolved oxygen (DO) concentrations between 0.6mg/L and 1.5mg/L. The main pollutants in the effluent could meet the strictest discharge standard (COD<50mg/L, NH₄⁺―N<5mg/L, and TN<15mg/L) in China now.     

水解-三相生物流化床处理生活污水的研讨

通过对水解－三相生物流化床处理生活污水的实验研究,以探求降低曝气池、水解池高度的可能性;同时对载体的沉降规律作动力学分析,建立载体免于流失的出流控制流速方程式,为设计运转提出理论依据。