活性氧化铝对水中磷的去除与回收研究

使用活性氧化铝作为吸附剂研究其对磷的吸附特性,并对不同提取剂对磷的回收效果进行了讨论.结果表明,活性氧化铝对使用蒸馏水、自来水及洱海入湖河流罗时江水配制的磷溶液有不同的磷吸附效果,其对3种不同磷溶液的吸附等温线模型均符合Langmuir模型,经计算得到理论最大吸附量分别为20.88、32.15和29.85 mg·g-1.通过吸附试验表明,电解质的存在对吸附效果有促进作用.pH值越低,活性氧化铝表面的Zeta电位越高,越有利于磷吸附.对比使用4种不同提取剂的试验结果表明,使用0.1 mol·L-1NaOH基本可以完全提取活性氧化铝吸附的磷.     

砂状氧化铝技改项目安全管理特性及措施

砂状氧化铝项目是中国铝业公司改善氧化铝产品质量、提高市场竞争力的重大技术改造项目，在山西分公司有3个砂状氧化铝技术改造项目同时施工，与生产交叉进行，时间紧、任务重、技术含量高、点多面广，安全管理难度很大，但通过采取有效措施，就能够保证砂状氧化铝技改项目安全稳定、顺利地进行。     

Decomposition of hexachlorobenzene over Al2O3 supported metal oxide catalysts

Decomposition of hexachlorobenzene (HCB) was investigated over several metal oxides (i.e., MgO, CaO, BaO, La₂O₃, CeO₂, MnO₂, Fe₂O₃, and Co₃O₄) supported on Al₂O₃, which was achieved in closed system at a temperature of 300°C. Catalysts were prepared by incipient wetness impregnation with different metal oxides loading and impregnating solvents. The decomposition efficiency of different catalysts for this reaction depends on the nature of the metal oxide used, and Al₂O₃ supported La₂O₃ was found to be the most active one. Pentachlorobenzene (PeCB), and all tetrachlorobenzene (TeCB), trichlorobenzene (TrCB), and dichlorobenzene (DCB) isomers were detected after the decomposition reaction, indicating that the decomposition was mainly a dechlorination process. The detection of all lower chlorinated benzenes suggested the complexity of decomposition and the presence of more than one dechlorination pathway.     

混合气液两相放电对水中有机物降解的机理研究

采用混合气液两相放电的方法来处理水中的有机物.结果表明,这种新型的水处理方法对于苯酚具有较好地去除效果．随着电压的增加和空气的通入,苯酚的去除率都有所增加. 对放电区域内产生的活性物种——过氧化氢和臭氧进行了定量的测定,并发现随着电压和空气的通入量的增加,这2种物质的量都有所增加．对于反应过程中的能耗进行分析得到随着电压的增加,能耗增加的幅度要大于苯酚降解率增加的幅度,能量效率增加较小. 空气的通入增加了能耗, 输入总能量中一部分能量使反应溶液温度升高,导致了能量的损耗.     

N-doped mesoporous alumina for adsorption of carbon dioxide

N-doped mesoporous alumina has been synthesized using chitosan as the biopolymer template. The adsorbent has been thoroughly investigated for the adsorption of CO₂ from a simulated flue gas stream (15% CO₂ balanced with N₂) and compared with commercially available mesoporous alumina procured from SASOL, Germany. CO₂ adsorption was studied under different conditions of pre-treatment and adsorption temperature, inlet CO₂ concentration and in the presence of oxygen and moisture. The adsorption capacity was determined to be 29.4 mg CO₂/g of adsorbent at 55℃. This value was observed to be 4 times higher in comparison to that of commercial mesoporous alumina at a temperature of 55℃. Basicity of alumina surface coupled with the presence of nitrogen in template in synthesized sample is responsible for this enhanced CO₂ adsorption. Adsorption capacity for CO₂ was retained in the presence of oxygen; however moisture had a deteriorating effect on the adsorption capacity reducing it to nearly half the value.     

过渡金属负载γ-Al2O3对HCN催化水解性能的影响

为高效催化水解净化废气中的HCN,采用等体积浸渍法改性γ-Al₂O₃制备HCN水解催化剂,考察不同金属组分及其负载量对HCN催化水解效率的影响. 结果表明:不同金属对HCN的催化水解活性依次为Cu>Cr>Fe>Zn>Ni>Co,Cu/γ-Al₂O₃系催化剂中Cu的最佳负载量为15.0%,添加1.0%的Ni有助于增加该催化剂对HCN的催化水解性能. 空速为18 000 h-1时,Cu/Ni/γ-Al₂O₃型催化剂在6 h内净化效率均能保持在91%以上,尾气中ρ(NH₃)为16.6 mg/m3. 采用X线衍射(XRD)、扫描电镜与能量色谱(SEM/EDS)、N₂物理吸附(N₂-BET)对Cu/Ni/γ-Al₂O₃系催化剂表征可知,CuO是Cu/Ni/γ-Al₂O₃系催化剂的主要活性成分,与未改性γ-Al₂O₃相比,Cu、Ni改性后催化剂微孔和中孔(孔宽为1.7~15.0 nm)的孔体积有所降低,其中直径较小的中孔对HCN的催化水解起主导作用.      

煤矸石中的铝、铁在高浓度盐酸中的浸出行为

考察了煤矸石中Al2O3和Fe2O3在不同浓度盐酸中的浸出行为,着重探讨了Al2O3和Fe2O3在高浓度盐酸中的溶出规律。通过与文献中AlCl3和FeCl3在不同浓度盐酸中的溶解度数据对照,发现煤矸石中Al2O3的溶出率受AlCl3溶解度的影响显著,而Fe2O3的溶出则基本不受FeCl3溶解度影响。进一步的研究结果表明,在高浓度盐酸中,煤矸石中Al2O3的溶出率显著降低,高浓度的盐酸不影响Fe2O3的溶出。当煤矸石的煅烧温度为700℃、酸浸温度为33℃时,酸浸固液比为1∶1(g/mL),利用37%的高浓度盐酸酸浸,Fe2O3和Al2O3的溶出率分别为48.7%和7.3%,可实现煤矸石中铁铝的有效分离。     

球形氧化铝负载Ni-Co双金属催化剂上沼气重整制氢——操作条件的影响

前期研究开发出了活性、稳定性和抗积碳性能都较好的沼气重整制氢Ni-Co/La2O3-Al2O3催化剂。在此基础上选用商业球形氧化铝作为载体(4~5 mm)并掺杂La2O3,用浸渍法制备了Ni-Co/La2O3-Al2O3球形催化剂,以CH4/CO2体积比为1的混合气模拟沼气,考察了操作条件对工业尺度催化剂沼气重整反应性能的影响。结果表明:负载活性组分的γ-Al2O3球形催化剂的沼气重整活性基本达到小试的水平。反应温度升高有利于提高催化剂的重整活性,850℃以上催化剂的活性趋于稳定。反应温度升高有利于减少催化剂的表面积碳,却加速了金属颗粒的团聚。随着空速的增加,催化剂的活性显著降低。较好的催化剂还原方式为用纯H2在700℃下还原2 h,用该方式还原的催化剂反应后金属粒径较小,平均积碳速率较低。     

酸浸法提取煤矸石中Al2O3的研究

煤矸石是主要的煤系固体废物,其中Al2O3质量分数约占35％左右.以某煤矿的煤矸石为原料,通过单因素实验比较盐酸和硫酸对Al2O3的浸取率,研究各因素对Al2O3浸取率的影响,确定浸取煤矸石中Al2O3的最佳酸浸介质为硫酸.利用正交实验确定酸浸取的最佳条件为:液固比(酸溶液体积与煤矸石样品质量比)15 mL/g、硫酸摩尔浓度3 mol/L、浸取时间120min、助样比(助溶剂与煤矸石样品质量比)0.20,在此条件下硫酸对煤矸石中A12O3的浸取率可达79.6％.     

Simultaneous determination of fenitrothion and aminocarb in blueberry foliage and fruits: Application to the analysis of residues in field samples

Abstract

Samples of blueberry foliage and fruits were collected from spray blocks in Ontario after aerial application of fenitrothion and aminocarb at dosage rates of 210 g active ingredient (AI)/ha and 70 g AI/ha respectively. Residues were extracted from the samples by homogenizing with ethyl acetate, cleaned up by microcolumn chromatography using alumina as adsorbent, and analyzed by GLC‐AFID with a glass column packed with 1.5% OV‐17 and 1.95% OV‐210 on 80–100 mesh Chromosorb W‐HP. Average recoveries for fenitrothion and aminocarb from foliage at three fortification levels (1.0, 0.10 and 0.01 ppm) were respectively 99 and 96%. The corresponding values for the fruits were 99 and 95%. Foliage samples collected 1 h post‐spray contained on average 1.13 ppm of fe‐nitrothion and 1.14 ppm of aminocarb. However, residue levels reached below the detection limit (<0.01 ppm) in foliage collected 15 d after treatment. In addition, the fruit samples collected after 15 d post‐spray contained extremely low levels (0.03 ppm for fenitrothion and 0.02 ppm for aminocarb) of residues, and were barely above the detection limit.