Emissions from RDF/coal blended fuel combustion

The significant volume and weight reduction along with the energy potential of MSW, in the form of refuse derived fuel (RDF), has made its incineration an attractive alternative. However, the gaseous emissions such as, CO₂, CO, NO_x and SO₂, which are the byproduct of the combustion process pose serious environmental problems. These problems are compounded by the presence of certain highly regulated hazardous wastes such as, dioxins and furans in the exhaust stream. In the present investigation, different compositions of RDF/Coal blends were examined and the gaseous emissions from the combustion of the briquetted fuel were measured. Also, a direct comparison of emissions from RDF/coal blend incineration with coal combustion is presented in this paper. The potential for recovery of ferrous and non- ferrous metals provides an additional economic motivation for the use of RDF/Coal blended briquettes.     

Influences of working pressure on properties for TiO2 films deposited by DC pulse magnetron sputtering

TiO2 films were deposited at room temperature by DC pulse magnetron sputtering system.The crystalline structures,morphological features and photocatalytic activity of TiO2 films were systematically investigated by X-ray diffraction (XRD),atomic force microscopy and ultraviolet spectrophotometer,respectively.The results indicated that the working pressure was the key deposition parameters influencing the TiO2 film phase composition at room temperature,which directly affected its photocatalytic activity.With increasing the working pressure,the target self-bias decreases monotonously.Therefore,low temperature TiO2 phase (anatase) could be deposited with high working pressure.The anatase TiO2 films deposited with 1.4 Pa working pressure displayed the highest photocatalytic activity by decomposition of Methyl Orange solution,which the degradation rate reached the maximum (35%) after irradiation by ultraviolet light for 1 h.     

Photocatalytic degradation of methyl orange over ITO/CdS/ZnO interface composite films

ITO/CdS/ZnO interface composite films were successfully prepared by subsequent electrodeposition of CdS and ZnO onto indium tin oxide (ITO) glass substrates. The obtained ITO/CdS/ZnO composite films were characterized with X-ray diffraction (XRD), scanning electron microscopy (SEM), and UV-Vis spectroscopy. The photocatalytic activity of ITO/CdS/ZnO composite films were investigated using methyl orange (MO) as a model organic compound under UV light irradiation. The influence of operating parameters on MO degradation including initial concentration of MO, pH value of solution, and inorganic anion species over the composite films were examined. A blue shift of absorption threshold was observed for the ITO/CdS/ZnO film in comparison with ITO/ZnO film. ITO/CdS/ZnO composite films prepared under specific conditions showed a higher photocatalytic activity than that of ITO/ZnO films. It was also found that the photocatalytic degradation of MO on the composite filing followed pseudo-first order kinetics.     

太阳电池阵基板原子氧防护膜试验评价研究

对太阳电池阵基板用涂有有机硅／SiO2杂化涂层的Kapton膜进行的工程化应用试验评价研究进行了介绍。通过真空下材料的出气试验,对材料的总质量损失（TML）和可凝挥发物（CVCM）进行了测试。进行了温度冲击试验、粒子辐照试验,对涂层的环境耐受性进行了研究。通过原子氧试验,对带涂层薄膜的原子氧剥蚀率进行了研究。此外还对涂层薄膜进行了力学性能试验和粘接性能试验,对带涂层薄膜的拉伸强度、胶接剪切性能及与基板胶接后的剥离性能进行了测试。试验结果表明防护涂层满足工程应用的技术要求。     

基于风险的中国电影产业安全管理初探

随着我国电影产业的发展,各种安全事故层出不穷,电影产业的安全生产已经是一个无法回避的问题。在分析电影产业安全事故特点的基础上,结合风险预警理论,系统地探讨了电影产业安全风险管理的基本框架,对提高电影产业安全生产水平提出了建议。     

TC4钛合金厚板电偶腐蚀与防护研究

目的研究TC4钛合金厚板与铝合金、钢之间发生电偶腐蚀的敏感性。方法通过测定TC4钛合金厚板与铝合金、钢组成的电偶对的电偶电流方法,研究TC4钛合金厚板与上述异种材料之间发生电偶腐蚀的敏感性。结果 TC4钛合金厚板与铝合金、钢接触时极易发生电偶腐蚀,不能直接接触使用,必须采取有效的防护措施。对钛合金和铝合金进行阳极氧化处理,可降低电偶腐蚀敏感性;对钛合金进行阳极氧化处理,同时对钢进行电镀镉-钛处理可以在一定程度上降低电偶腐蚀敏感性。结论 TC4钛合金厚板与铝合金及钢的电偶腐蚀敏感性高,表面处理可以有效降低异种材料的电偶腐蚀敏感性。     

城市垃圾填埋场覆膜内的甲烷及恶臭物质特征研究

卫生填埋是常用的固体废弃物处置方法。部分填埋场对已经封场和暂时不填埋垃圾的区域覆盖高密度聚乙烯膜(HDPE),便于雨水分流、减少垃圾渗滤液产生量。通过在华北地区某城市生活垃圾卫生填埋场设置采样点,监测分析了HDPE覆膜内积聚的甲烷及恶臭物质的浓度和成分,研究在不同季节、填埋时间产生的甲烷及恶臭物质特征。结果表明:填埋场覆膜内甲烷的平均浓度为15.6%;硫化物、胺类以及恶臭浓度分别为153.9 mg/m3,16.0 mg/m3以及4 322 OU。主要的恶臭物质为硫化氢和氨。总挥发性有机物的浓度为0~147.2 mg/m3,苯系物、烷烃和烯烃是挥发性有机物的主要成分。恶臭浓度与硫化物、胺类浓度具有明显的相关性。环境温度、垃圾填埋龄和填埋量对甲烷及恶臭物质的产生与释放有明显影响。夏季甲烷及恶臭浓度分别达到81.2%和20 943 OU,明显高于其他季节。随着垃圾填埋龄和填埋量的增加,恶臭物质的浓度和成分均发生显著变化。     

生物膜法处理地表水研究与应用进展

介绍了目前中国地表水的污染概况,指出地表水污染情况依然不容乐观,主要污染指标为总氮和总磷,修复受污染地表水的主要方法为生物法,论述了生物技术中的生物膜法处理地表水的原理,总结并分析了国内外相关生物膜法处理技术及其优缺点,并列举了相关应用实例,最后根据国外河道整治的发展历程,对该技术的发展趋势作了展望,因生物膜-生态联合治理技术综合了生态系统方法及生物净化技术的优点,认为生物膜-生态联合治理技术将是今后地表水处理技术发展的一大趋势。     

再生纤维素膜的微生物降解

采用田间掩埋、平皿培养和ＣＯ２释放试验分别测试了再生纤维素膜的生物降解性。试验结果表明：膜的失重随掩埋时间而增加;不同试验菌株对膜有不贩降解活性,其顺序为木霉Ｔ－３１１〉黑曲霉Ａ－３０５〉青霉Ｐ－３０７;掩埋或用菌株Ｔ－３１１接种４２ｄ后,膜的生物降解率可超过７０％;在膜的微生物降解过程中,失重、菌株在膜表面的可见生长和ＣＯ２释放分别是膜不同降解程度的表征,彼此既相关又有区别。     

丰沛铜地氟病区大气环境中氟的分布

利用石灰滤纸法和滤膜电极法测试了徐州丰沛铜地区大气环境中的氟含量,结果表明：由城区至城效到农村,大气环境中的氟含量趋向下降,采煤、煤的燃烧和铝厂等企业是大气中氟的主要污染源,该区地氟病与大气环境中的氟含量未见明显联系,不属燃煤污染型