催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

非均相催化臭氧处理高浓度制药废水的研究

非均相催化臭氧是一种对高浓度制药废水进行预处理的有效方法.本研究采用单一活性炭吸附、单一臭氧氧化和臭氧/活性炭联用3种体系对实际制药废水进行预处理,并对处理过程中的工艺参数进行优化.结果表明,相比单一活性炭吸附和单一臭氧降解体系,臭氧/活性炭联用体系能显著提高COD、TOC的去除率及BOD5/COD值,并显示出良好的协...     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

Complete catalytic oxidation of o-xylene over Ce02 nanocubes

The activities of CeO2 nanocubes calcined at different temperatures were tested for catalytic oxidation of o-xylene. Using CeO2 nanocubes as catalysts, complete catalytic oxidation of o-xylene was achieved below 210℃. The CeO2 nanomaterials were characterized by means of BET, X-ray diffraction (XRD), transmission electron microscopy (TEM), and high-resolution transmission electron microscopy (HRTEM). From the TEM images, all Ce02 nanocubes displayed cubic morphology irrespective of calcination temperature. The HRTEM images revealed that these nanocubes were enclosed by reactive {001}planes, which may contribute to the intrinsically catalytic property of o-xylene oxidation. The higher activity of Ce02 nanocubes calcined at 550℃ than those calcined at above 550℃ was attributed to their smaller crystallite size and larger surface area. The influences of reaction conditions were also studied, which found that a higher reaction temperature was necessary for complete catalytic oxidation of o-xylene at higher weight hourly space velocity (WHSV) and o-xylene concentration.     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

火焰原子吸收法测定地表水中钾钠钙镁的方法改进

用空气—乙炔火焰原子吸收测定地表水中钾钠钙镁时,将测钾钠用的消电离剂和测钙镁用的释放剂配成混合溶液,加入待测试样中,便可连续测定其中的钾钠钙镁。与现在常用的火焰原子吸收方法测得的结果一致,精密度和准确度符合规范要求,且方法简单快速。     

水中总氮测定相关问题的实验探讨

通过对国家标准测定方法《碱性过硫酸钾消解紫外分光光度法》进行水样中总氮的测定,进一步理解在220nm、275nm波长处进行吸光度测定的重要性。并提出：在已经知道水样中没有氨氮、亚硝酸盐氮,只有硝酸盐氮的情况下．就能通过快速的方法一即不加氧化剂、不加压,可以进行总无机氮的测定。快速测定无机总氮对于工程应用来说很有意义。因为国标的方法需要半天时间测定。而用此方法则仅需几分钟就可完成测定。、另外对于有机物对于测定结果的影响,参考吸光度比值（A275／A220×100％）应小于20％,越小越好,超过时应予鉴别。     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

活性炭催化过氧化氢去除荧光增白剂

研究了活性炭(activated carbon,AC)吸附、改性活性炭(activated carbon modified,ACM)吸附、过氧化氢(H2O2)氧化、AC催化H2O2等方法对水体中荧光增白剂VBL的处理效果,并通过自由基俘获剂叔丁醇、催化过程气体分析等探讨了AC催化H2O2分解VBL的机制.结果表明,经硝酸铁[Fe(NO3)3]改性过的ACM对VBL的吸附去除率高于未改性的AC.活性炭催化H2O2对VBL的去除效果明显,但未改性AC催化去除率高于ACM.60 min时,AC催化氧化去除率即可达到95%以上,而ACM仅为58%.叔丁醇的加入降低了AC和ACM催化氧化对VBL的去除率,表明AC催化H2O2氧化能促进H2O2形成羟基自由基(·OH)和原子氧参与反应.AC催化H2O2分解及释放气体分析表明,AC能催化H2O2形成氧气并放热,且ACM明显快于AC.结合催化H2O2去除VBL效率的结果分析,ACM催化反应时活性中间物(自由基和原子氧等)产生速率快于AC,活性中间物自身消耗形成氧气,而不是用于分解VBL.催化反应中活性中间产物的形成速率与反应物供给速率的不匹配可能是导致ACM催化效果弱于AC的重要原因.