镀液循环流量对封闭循环电沉积Ni-SiC复合镀层的影响

目的 研究封闭式镀液循环装置中不同镀液循环流量对Ni-SiC复合镀层的影响规律,优化镀液循环流量参数.方法 以Q235管状工件为待镀基体,以添加SiC颗粒的改良瓦特镀液为母液,在自主研发的封闭式镀液循环电镀装置中以0.3、0.5、0.7 m3/h的镀液循环流量于管件内壁制备Ni-SiC复合镀层,通过SEM检测、XRD测试、硬度测试和摩擦磨损性能测试等手段,对各Ni-SiC复合镀层宏微观形貌、厚度、成分、结构、硬度和耐磨性进行分析研究.结果 在0.5 m3/h流量条件下,镀层厚度为32.98μm,SiC颗粒含量为15.37％,镀层晶粒尺寸和硬度分别为10.84 nm和704HK0.245,该条件下制备的Ni-SiC复合镀层具有最佳耐磨性,摩擦系数为0.41,体积磨损率仅2.83×10–5 mm3/Nm.结论 在不同镀液循环流量参数下,采用该封闭式循环电镀装置,均可制得均匀完整的Ni-SiC复合镀层.随镀液循环流量的升高,镀层厚度和SiC颗粒体积含量均降低,镀层颜色金属光泽增强,镀层晶粒尺寸先减小、后增大,镀层硬度则先升高、后降低.     

故障安全控制系统在催化裂化装置的应用

介绍霍尼韦尔公司故障安全控制系统FSC的技术特点以及在我厂重油催化裂化装置的应用情况，说明了该装置故障安全控制系统组成和操作界面，并总结了应用效果。     

用MnSO4-Ce(SO4)2协同催化快速测定COD的研究

本文探讨了以MnSO4-Ce(SO4)2复合催化剂代替标准重铬酸钾法中的Ag2SO4，用密封消解法测定废水COD值的可行性，研究了复合催化剂总量、配比、消解时间、溶液酸度等因素对COD测定的影响。通过对各种废水COD值的测定表明，用MnSO4-Ce(SO4)2做催化剂，在165℃，较低酸度，密封消解15min是可行的。     

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

A superimposed wire-plate dielectric barrier discharge reactor was used to remove toluene in this study. The effects of oxygen content, gas flow rate, gas initial concentration and with/without catalyst on toluene decomposition were investigated. It was found that an optimal toluene removal was achieved when the oxygen content was about 5%. Under this condition, the highest toluene removal efficiency of 80.8% was achieved when the gas concentration was 80 mg/m^3. The toluene removal efficiency decreased with the increase of the gas flow rate and the initial concentration of toluene. In addition, the ozone concentration decreased with the increase of the initial concentration of toluene. It suggested that combining DBD （dielectric barrier discharge） with Co3O4/Al2O3/foam nickel catalyst in-situ could improve the toluene removal efficiency and suppress ozone formation. Products analysis showed that the main products were CO and CO2 when oxygen was more than 5%.     

用于燃料电池的甲醇水蒸气重整反应制氢的研究

研究了甲醇水蒸气重整制氢反应过程中各种因素对Cu／ZnO／Al2O3催化剂的活性和选择性的影响。结果表明：Cu／Zn比为2．0的催化剂在250℃反应时，催化剂效果较好，最合适反应条件是：压力0．1MPa，温度250℃，n(H2O)：n(CH3OH)=1．0-1．2，液体流速0．1mL／min。在Cu／ZnO／Al2O3)，催化剂上，甲醇水蒸气重整、甲醇分解和水气转换反应随反应条件的不同而发生相互抑制或促进作用。     

改性催化裂化废催化剂吸附水中氨氮的研究

考察了振荡时期温度、ＰＨ吸附效果的影响，通过吸附热力学实验，探讨了吸附机理，结果表明，温度是影响吸附效果的主要因素；等温吸附规律可用Ｆｒｅｕｎｄｌｉｃｈ模式和Ｌａｎｇｍｕｉｒ模式较好地描述；可能的吸附机理为：一是ＮＨ分子通过偶极力和氢键方面吸附，二是ＮＨ４通过离子交换面吸附。     

利用XPS研究复合氧化物催化剂在汽车尾气净化中硫中毒及抗硫中毒机理

运用ＸＰＳ分析方法研究一系列复合氧化物催化剂中毒前后硫在其表面的各种形态及催化剂活性组分中毒前后的组成，价态，化学机理及其变化。结果表明，ＳＯ２在催化剂活性中心进行化学吸附，然后一部分ＳＯ２与活性组分生成相应的亚硫酸盐和硫酸盐，从而使催化剂失活。     

An assessment of how distance and diesel oxidation catalyst will impact thermal decomposition behaviors of particles

Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, C_xH_y fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm^?1 was only detected without a DOC, while the NO₂ peak at 1634 cm^?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less C_xH_y fragments were seen in the second-stage.     

超临界水氧化技术处理有机废水的研究

超临界水是处理难氧化有机污染物的一种很好媒介,因为在超临界状态下有机污染物和氧化剂能够互溶而加快反应速度,具有去除率高,反应时间短且无污染等特点,因而受到了越来越多的关注。本文主要概述了超临界水氧化的特点、机理、工艺流程和存在的问题,介绍了当前超临界水氧化处理难降解污染物的效果、动力学、催化剂研究等情况,并展望了其应用前景。     

水泥土桩复合地基桩土应力参数研究

本文首先通过理论分析，认为桩土应力比、桩土荷载分担比等是反映水泥土桩复合地基工作性状的重要参数。然后通过现场试验，研究桩土应力比、桩土荷载分担比随荷载变化的规律。结果认为：随着荷载增加，桩土应力比逐渐减小，当比值达到某一特征值后，不再发生明显变化；桩土应力比、桩土荷载分担比不为常数，其变化是桩土变形协调的结果。最后得出有一定参考价值的结论。