含硫化合物对Methylosinus trichosporium OB3b生长和合成聚-β-羟基丁酸酯的影响

为了将人类活动排放的含有甲烷的废气用于聚-β-羟基丁酸酯(PHB)合成过程,以M.trichosporium OB3b为菌种,考察硫化氢(H2S)和甲硫醚(DMS)对甲烷氧化菌生长和PHB合成的影响。实验结果表明,H2S浓度高达2 500μmol/mol时对甲烷氧化菌生长及甲烷单加氧酶(MMO)活性基本无影响,含H2S时的PHB含量和产率比无H2S时高,甲烷氧化菌经H2S培养后PHB合成能力增强。然而,DMS浓度为200μmol/mol时即可明显抑制甲烷氧化菌的生长及MMO活性。在DMS存在条件下,PHB含量和PHB产率都明显降低,经DMS培养后甲烷氧化菌的PHB含量进一步降低。     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

Potential particulate pollution derived from UV-induced degradation of odorous dimethyl sulfide

UV-induced degradation of odorous dimethyl sulfide (DMS) was carried out in a static White cell chamber with UV irradiation. The combination of in situ Fourier transform infrared (FT-IR) spectrometer, gas chromatograph-mass spectrometer (GC-MS), wide-range particle spectrometer (WPS) technique, filter sampling and ion chromatographic (IC) analysis was used to monitor the gaseous and potential particulate products. During 240 min of UV irradiation, the degradation e ciency of DMS attained 20.9%, and partially oxidized sulfur-containing gaseous products, such as sulfur dioxide (SO2), carbonyl sulfide (OCS), dimethyl sulfoxide (DMSO), dimethyl sulfone (DMSO2) and dimethyl disulfide (DMDS) were identified by in situ FT-IR and GC-MS analysis, respectively. Accompanying with the oxidation of DMS, suspended particles were directly detected to be formed by WPS techniques. These particles were measured mainly in the size range of accumulation mode, and increased their count median diameter throughout the whole removal process. IC analysis of the filter samples revealed that methanesulfonic acid (MSA), sulfuric acid (H2SO4) and other unidentified chemicals accounted for the major non-refractory compositions of these particles. Based on products analysis and possible intermediates formed, the degradation pathways of DMS were proposed as the combination of the O(1D)- and the OH- initiated oxidation mechanisms. A plausible formation mechanism of the suspended particles was also analyzed. It is concluded that UV-induced degradation of odorous DMS is potentially a source of particulate pollutants in the atmosphere.     

Carbonyl sulfide and dimethyl sulfide fluxes in an urban lawn and adjacent bare soil in Guangzhou, China

Carbonyl sulfide (COS) and dimethyl sulfide (DMS) fluxes from an urban Cynodon dactylon lawn and adjacent bare soil were measured during April–July 2005 in Guangzhou, China. Both the lawn and bare soil acted as sinks for COS and sources for DMS. The mean fluxes of COS and DMS in the lawn (–19.27 and 18.16 pmol/(m2 sec), respectively) were significantly higher than those in the bare soil (–9.89 and 9.35 pmol/(m2 sec), respectively). Fluxes of COS and DMS in mowed lawn were also higher than those in bare soils. Both COS and DMS fluxes showed diurnal variation with detectable but much lower values in the nighttime than in the daytime. COS fluxes were related significantly to temperature and the optimal temperature for COS uptake was 29°C. While positive linear correlations were found between DMS fluxes and temperature. COS fluxes increased linearly with ambient COS mixing ratios, and had a compensation point of 336 ppt.     

感应电芬顿降解二甲基砷的效果与机理研究

二甲基砷作为甲基砷的主要种类之一,主要由含砷废水的排放和农药滥用进入环境水体,进而严重威胁着人类的健康.通过改进电芬顿反应中Fe~(2+)的投加方式,构建了以铁棒为感应阳极、RuO_2/Ti网为阳极、2个活性炭纤维为双阴极的感应电芬顿体系.为探究感应电芬顿体系对二甲基砷的降解效果与机理,考察了反应过程中初始pH、电流密度、反应物初始浓度等因素对二甲基砷去除效果的影响.结果表明,在初始pH值为3,电流密度为2 m A·cm~(-2),二甲基砷初始浓度为5 mg·L~(-1)的最佳条件下,经感应电芬顿反应240 min后,二甲基砷去除率高达94.4%.在此体系中,感应铁电极不断释放的Fe~(2+)与阴极产生的H_2O_2发生电芬顿反应产生羟基自由基将二甲基砷降解为一甲基砷、As(Ⅲ)和As(V),同时,铁离子水解生成的铁的羟基络合物将二甲基砷、一甲基砷、As(III)和As(V)吸附在其表面,从而达到二甲基砷的高效去除.     

双效精馏-吸附联合工艺处理DMF废水

提出以双效精馏-吸附联合工艺处理DMF废水。采用双效精馏将DMF废水中的DMF回收为99.8%以上的产品;采用大孔树脂对双效精馏后产生的少量DMA和DMF进行吸附,使其达到国家排放标准,并例举了该工艺在工程上的应用实例。     

Pollution levels and characteristics of phthalate esters in indoor air of offices

The pollution status and characteristics of PAEs (phthalate esters) were investigated in indoor air of offices, and PAEs of both gas-phase and particulate-phase were detected in all the samples. The concentration (sum of the gas phase and the particulate phase) was 4748.24 ng/m³, ranging between 3070.09 and 6700.14 ng/m³. Diethyl phthalate, dibutyl phthalate, and di(2-ethylhexyl) phthalate were the most abundant compounds, together accounting for 70% of the Σ6PAEs. Dividing the particulate-phase PAEs into four size ranges (<2.5, 2.5-5, 5-10, >10 μm), the result indicated that PAEs in PM_2.5 were the most abundant, with the proportion of 72.64%. In addition, the PAE concentration in PM_2.5 correlated significantly with the total particulate-phase PAEs (R² = 0.85). Thus, the amount of PAEs in PM_2.5 can be estimated from the total amount of particulate-phase PAEs using this proportion. In a comparison between the offices and a newly decorated study room, it was found that pollution characteristics were similar between these two places. Thus, it is implied that the PAE concentration decreased by 50% 2 yr after decorating.     

Pollution levels and characteristics of phthalate esters in indoor air of offices

The pollution status and characteristics of PAEs(phthalate esters) were investigated in indoor air of offices, and PAEs of both gas-phase and particulate-phase were detected in all the samples. The concentration(sum of the gas phase and the particulate phase) was4748.24 ng/m3, ranging between 3070.09 and 6700.14 ng/m3. Diethyl phthalate, dibutyl phthalate, and di(2-ethylhexyl) phthalate were the most abundant compounds, together accounting for 70% of the ∑ 6PAEs. Dividing the particulate-phase PAEs into four size ranges( 2.5, 2.5–5, 5–10, 10 μm), the result indicated that PAEs in PM2.5were the most abundant,with the proportion of 72.64%. In addition, the PAE concentration in PM2.5correlated significantly with the total particulate-phase PAEs(R2= 0.85). Thus, the amount of PAEs in PM2.5can be estimated from the total amount of particulate-phase PAEs using this proportion. In a comparison between the offices and a newly decorated study room, it was found that pollution characteristics were similar between these two places. Thus, it is implied that the PAE concentration decreased by 50% 2 yr after decorating.     

Pollution levels and characteristics of phthalate esters in indoor air in hospitals

The concentrations of phthalate esters(PAEs) in Chinese hospitals were investigated by simultaneously determining concentrations of gas- and particle-phase PAEs. PAEs were detected in two third-class first-grade hospitals, two second-class first-grade hospitals, and a community health service center. Hospital drugstores had the highest concentration(24.19 μg/m3), which was 1.54 times that of newly decorated houses. The second highest concentration was found in the transfusion rooms, averaging 21.89 μg/m3; this was followed by the concentrations of PAEs in the nurse's workstations, the wards, and the doctor's offices, with mean concentrations of 20.66, 20.0, and 16.92 μg/m3, respectively. The lowest concentrations were found in the hallways(16.30 μg/m3). Of the six different kinds of PAEs found, major pollutants included diethyl phthalates, dibutyl phthalates, butylbenzyl phthalates and di(2-ethylhexyl) phthalates, comprising more than 80% of all PAEs present.Meanwhile, a comparison between different wards showed that PAE concentrations in the maternity wards were 1.63 times higher than in the main wards. Based on known health hazards, our results suggest that the PAEs seriously influence the health of the pregnant women and babies; therefore, it is of great importance to take the phthalate concentrations in hospitals into consideration. In addition, hospital indoor air was more seriously contaminated than the air of newly decorated houses.     

Occurrence and migration of microplastics and plasticizers in different wastewater and sludge treatment units in municipal wastewater treatment plant

● Reduce the quantifying MPs time by using Nile red staining. ● The removal rate of MPs and PAEs in wastewater and sludge were investigated. ● MPs and PAEs were firstly analyzed during thermal hydrolysis treatment. ● The removal of PAEs from wastewater and sludge was mainly biodegradation. Microplastics (MPs) and plasticizers, such as phthalate esters (PAEs), were frequently detected in municipal wastewater treatment plants (MWTP). Previous research mainly studied the removal of MPs and PAEs in wastewater. However, the occurrence of MPs and PAEs in the sludge was generally ignored. To comprehensively investigate the occurrence and the migration behaviors of MPs and PAEs in MWTP, a series of representative parameters including the number, size, color, shape of MPs, and the concentrations of PAEs in wastewater and sludge were systematically investigated. In this study, the concentrations of MPs in the influent and effluent were 15.46±0.37 and 0.30±0.14 particles/L. The MP removal efficiency of 98.1% was achieved and about 73.8% of MPs were accumulated in the sludge in the MWTP. The numbers of MPs in the sludge before and after digestion were 4.40±0.14 and 0.31±0.01 particles/g (dry sludge), respectively. Fourier Transform Infrared Spectroscopy (ATR FT-IR) analysis showed that the main types of MPs were polyethylene terephthalate (PET), polypropylene (PP), polyethylene (PE), and polystyrene (PS). Six PAEs, including phthalate (DMP), diethyl phthalate (DEP), diisobutyl phthalate (DIBP), ortho dibutyl phthalate (DBP), butyl benzyl phthalate (BBP), and bis(2-ethyl) hexyl phthalate (DEHP), were detected in the MWTP. The concentrations of total PAEs (ΣPAEs) in the influent and effluent were 76.66 and 6.28 µg/L, respectively. The concentrations of ΣPAEs in the sludge before and after digestion were 152.64 and 31.70 µg/g, respectively. In the process of thermal hydrolysis, the number and size of MPs decreased accompanied by the increase of the plasticizer concentration.