土壤与酸的反应时间对土壤酸度及土壤溶液中铝离子形态分布的影响

用两种土壤研究土壤与酸的反应时间对土壤酸度及土壤溶液中铝离子形态分布的影响。结果表明，土壤溶液pH随反应时间增加而增加，安徽红壤pH的增幅大于江西红壤。在pH3.0的HNO3溶液中，土壤溶液中的总铝及Al3 均随反应时间增加而减少，而在pH3．5的HNO3溶液中，土壤溶液中总铝及Al－F络合物先随反应时间的增加而减小．然后又有所增加。     

The use of physiological characteristics for comparison of organic compounds phytotoxicity

The influence of intact (FLT) and photomodified (phFLT) fluoranthene (0.05, 0.5 and 5 μmol l⁻¹) and herbicide Basagran (5, 20, 35 and 50 nmol l⁻¹) on the germination, growth of seedlings and photosynthetic processes in pea plants (Pisum sativum L., cv. Garde) was investigated. The germination was significantly inhibited already by the lowest concentration (0.05 μmol l⁻¹) of FLT and phFLT, while Basagran caused inhibition only in higher concentrations (35 and 50 nmol l⁻¹). The growth of roots was significantly inhibited by higher concentration 5 μmol l⁻¹ of both FLT and phFLT and the shoot of seedlings was significantly influenced only by photomodified form. The length of root and shoot was inhibited already by concentration 5 nmol l⁻¹ of Basagran. Organic compounds applied on chloroplasts suspension influenced primary photochemical processes of photosynthesis. In chlorophyll fluorescence parameters, the significant increase of F₀ values and the decrease of F_V/F_M and Φ_II values by application of FLT (0.5 and 5 μmol l⁻¹) and phFLT (0.05, 0.5 and 5 μmol l⁻¹) was recorded. The maximum capacity of PSII (F_V/F_M) was influenced by the highest (50 nmol l⁻¹) and the effective quantum yield of PSII (Φ_II) already by the lowest (5 nmol l⁻¹) concentration of Basagran. Hill reaction activity decreased and was significantly inhibited by higher concentration (0.5 and 5 μmol l⁻¹) of FLT and phFLT and already by the lowest concentration (5 nmol l⁻¹) of Basagran.     

北京夏季典型PM2.5与O3相继重污染事件分析

根据北京市环境保护监测中心发布的PM2.5和O3小时质量浓度及气象、卫星遥感数据,分析了2013年7月2日至10日北京典型PM2.5及O3重污染过程的质量浓度特征及在大气边界层过程各个阶段的质量浓度演变.结果表明,北京夏季O3质量浓度先于PM2.5达到峰值,而天气型演变是导致这一现象的主要原因.具体过程为:1)重污染初始阶段,高压天气型利于前体物积累,PM2.5及O3质量浓度升高;2)在反气旋中部,由于各种污染物质量浓度较低,对大气紫外波段辐射的吸收较弱,导致该阶段紫外辐射强,因而加快了O3生成的光化学反应,O3质量浓度最先达到峰值;3)在反气旋后部,随PM2.5质量浓度增加,辐射变弱,因此O3质量浓度增加速度下降,而受高压后部影响,区域内PM2.5经东南风输送通道进入北京,导致北京PM2.5质量浓度相继达到峰值;4)在重污染清除阶段,在北方反气旋前部的冷锋清除作用下,PM2.5及O3质量浓度同时降低至谷值.     

前车突然切入时驾驶人应激生理特性研究

为研究前车突然切入对驾驶人生理负荷的影响,利用MP150生理监测系统对22名被试进行虚拟驾驶试验。采集记录前车突然切入时被试的生理参数。研究驾驶人心率增长率和心率变异性(HRV)指标与车速、应激距离之间的关系。结果表明:自车速度为100 km/h时,随着前车切入距离从55.6 m减小到27.8 m,被试的平均心率增长率从16.21%增大到23.27%,HRV参数低频(LF)值也呈现下降趋势。前车切入距离一定,随着自车车速从60 km/h增加到120 km/h,被试的平均心率增长率存在显著性差异,平均从13.05%上升到21.85%。差异性检验结果表明,前车切入距离和自车速度发生变化时驾驶人的生理负荷变化趋势一致,但自车速度因素对驾驶人生理负荷的影响程度高于切入距离因素。     

反应气氛对绿色合成纳米铁的组分及其活性的影响

成本低廉和无二次污染的"绿色"合成纳米材料是发展原位纳米环境修复技术的前沿研究课题之一.本文以绿茶提取液为还原剂和稳定剂进行"绿色"合成纳米铁,探讨在不同的气氛下"绿色"合成的纳米铁颗粒的主要成分,以期为调控合成纳米铁系材料提供基础研究.首先,利用扫描电子显微镜(SEM)、X射线能谱(EDS)、X射线光电子能谱分析(XPS)和傅里叶变换红外光谱(FTIR)等表征手段对不同反应气氛下合成的纳米铁颗粒的表面微观形貌、尺寸和价态结构进行分析.结果发现,在通入N2情况下,合成的纳米铁颗粒粒径为(84.7±11.5)nm,其主要成分以纳米零价铁为主;在通入空气情况下,合成的纳米铁粒径为(117.8±26.2)nm,其主要成分是纳米零价铁、氧化铁和四氧化三铁的混合物;通入O2时,合成的纳米铁粒径为(141.2±26.3)nm,其主要成分以四氧化三铁为主.其次,评价在不同气氛条件下合成纳米铁颗粒对去除亚甲基蓝(MB)的反应活性.结果表明,在反应温度313 K下降解初始浓度为50 mg·L-1的MB溶液,反应5 min时已达到平衡,通入N2合成的纳米铁降解MB,去除率高达98.7%,而通入O2合成的纳米铁反应效率低,对MB的去除率仅为65.3%.最后,从以上发现提出不同气氛下可以调控"绿色"合成的铁系纳米材料成分,从而导致不同的纳米修复环境中污染物的能力.     

内循环厌氧反应器流动模型及反应过程模拟

为揭示内循环厌氧反应器放大过程中所出现的规律,本文对反应器中流动模型和反应过程进行了模拟研究,通过对主反应区的停留时间分布的实验研究,确定了主反应区流型可用一平推流与两个并联的全混流进行串联的三参数组合模型进行模拟.在实验范围内,平推流区所占的体积分数约为36%,两个全混流区所占的体积分数分别为53%和11%.结合厌氧反应动力学方程,应用组合模型模拟了实际反应器的状态,并和实验值进行了对比,发现反应器出口处CH_4体积流量最大误差为9.67%,在可允许的范围内.同时,模拟了基质初始COD和温度变化对反应器出口状态的影响.研究表明,与其它模型相比,组合模型计算简洁,同时又有较好的精度,能够满足反应器的设计需要.     

Heterogeneous oxidation of SO2 by O3-aged black carbon and its dithiothreitol oxidative potential

Ozone (O₃) is an important atmospheric oxidant. Black carbon (BC) particles released into the atmosphere undergo an aging process via O₃ oxidation. O₃-aged BC particles may change their uptake ability toward trace reducing gases such as SO₂ in the atmosphere, leading to different environmental and health effects. In this paper, the heterogeneous reaction process between O₃-aged BC and SO₂ was explored via in-situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS). Combined with ion chromatography (IC), DRIFTS was used to qualitatively and quantitatively analyze the sulfate product. The results showed that O₃-aged BC had stronger SO₂ oxidation ability than fresh BC, and the reactive species/sites generated on the surface had an important role in the oxidation of SO₂. Relative humidity or 254 nm UV (ultraviolet) light illumination enhanced the oxidation uptake of SO₂ on O₃-aged BC. The oxidation potentials of the BC particles were detected via dithiothreitol (DTT) assay. The DTT activity over BC was decreased in the process of SO₂ reduction, with the consumption of oxidative active sites.     

A thermal hazard risk evaluation of emulsion polymerisation and vinyl acetate monomers in the latex manufacturing process

Latex is extensively used in industrial products. However, completing some processes at scale leads to unacceptable levels of risk that need to be quantified and mitigated. Systemic risks must be eliminated wherever possible, and safety takes priority over efficiency and quality. To assess the process risks accurately, four raw materials were examined in this study: polyvinyl acetate (PVA), latex process-initiator-ammonium persulfate (APS) and hydrogen peroxide (H₂O₂), and vinyl acetate monomer (VAM). The physicochemical composition of the PVA latex process was determined via calorimeters, including differential scanning calorimetry (DSC) and vent sizing package 2 (VSP2). The calorimetry results showed that the protective colloid was a critical component in the polymerisation reaction. In addition, when adding initiators to the system, it is vital to observe the normal ratio of materials and keep the stirring system operating. The scenario system also simulated the effects of shutting down various inhibitory programs, including the build-up of free radicals that could result in a runaway reaction when the initiator was added in excess. On the other hand, the result of the risk matrix displayed as a medium level, indicating that although the probability of an accident is low, the resulting severity is at disaster level. As a result, this study provides process safety engineers with a reliable frame of reference for assessing the potential dangers in the PVA latex manufacturing process.     

蒙脱土原位生长MoS2复合材料光催化降解罗丹明B的机理研究

通过在Na⁺-MMT表面生长MoS₂来提高窄带隙半导体光生电子分离速率及稳定性.利用阳离子填充法及水热法成功制备了复合光催化剂Na⁺-MMT/MoS₂,并通过FT-IR、SEM、TEM、Raman、XRD、TG、XPS、UV-DRS和ESR等表征进一步证明了材料的成功负载及光、电化学性能. 同时,以有机染料罗丹明B为待降解染料来评价光催化剂的催化性能,发现其在80 min可有效降解罗丹明B,降解率达96%.经过5次循环使用后,Na⁺-MMT/MoS₂复合光催化剂仍具有较好的光催化性能.因此,利用MMT的表面电负性及稳定的片层结构负载MoS₂,可形成光生电子迁移通道进一步提高电荷迁移速率及光催化剂的稳定性.本研究可为黏土材料调控窄带隙半导体制备环境友好型光催化剂提供新思路.     

街道峡谷内车辆流动对反应性污染物传播特性影响的模拟研究

采用CFD（计算流体力学）数值模拟的研究方法,使用动网格技术,分析简单光化学反应下车辆流动及不同来流风速对双车道三维街道峡谷内污染物传播特性的影响.结果表明,车辆移动改变了峡谷内气流结构,以及背风侧与迎风侧活性污染物浓度分布的相对大小,有利于污染物在峡谷中的传播扩散;来流风使机动车尾气向建筑背风侧汇聚,并随着风速增加而加强,对近迎风侧车道车辆尾气淹没射流的影响比近背风侧车道大.在车辆移动与来流风的综合作用下,污染物的扩散能力得到显著增强.