超滤处理含聚污水过程中通量衰减机理的研究

研究了超滤处理含聚合物污水过程中操作压力、膜面流速、聚合物浓度、料液流变性、阻力等影响因素对膜通量的影响,并进行理论分析,揭示了通量衰减机理.研究结果表明,通量衰减的机理是聚合物的浓差极化和凝胶层的形成,其次是原油和无机物对膜孔的堵塞.     

Studies on the use of power ultrasound in solid–liquid myrobalan extraction process

Focus on eco-friendly processing techniques makes vegetable tanning a viable option in leather processing and establishes the subsequent need for the more efficient methods of extraction in tannin manufacture. Application of ultrasound has been tried in the extraction of tannins from myrobalan nuts in order to improve the extraction efficiency, to perform the extraction under milder process conditions and to reduce the process time. The influence of process parameters such as ultrasonic output power, time and temperature has been studied. Scale-up trials and the use of ultrasound in pulse mode have also been attempted. The results show that a three- to fivefold improvement is possible with ultrasonic output from 20 to 100 W. Extraction efficiency has been calculated from the maximum extractable materials from myrobalan nuts. Extraction efficiency is found to be 90% for ultrasound, 100 W without external heating as compared to 77% for control process at 70 °C for 4 h. Therefore, ultrasound could be employed even dispensing with provision for temperature controls. The use of ultrasound in pulse mode offered 70% extraction efficiency of continuous mode. Scale-up trials indicate that there exists an optimum ultrasonic output power depending on the amount of nuts used, to achieve better extraction efficiency. The effectiveness of ultrasonically extracted tannin solution has also been tested in the tanning process for its applicability. The degree of tanning efficacy has been assessed by shrinkage temperature measurement. The results indicate that ultrasonically extracted tannin solution is suitable for tanning process. Therefore, application of ultrasound in tannin extract manufacture is a viable option with added advantages.     

渣油－水乳化液作为路面抑尘剂的研究

为了有效抑制汽车运输路面的扬尘，选择低浓度渣油－水乳化液作为抑尘剂，通过在实验室大量的试验，掌握了一组渣油乳化的最佳配方及其制备工艺，即渣油３％－６％，乳化剂约０．５％，水９３．５％－９６．５％，制备温度＞７０℃．经过室内和现场大规模试验表明，当路面喷洒量达到２．２ｋｇ／ｍ２时，其有效抑生时间达到１０ｄ以上，并且在一定程度起到养路的作用，长期使用可取得显著的综合经济效益．     

低浓度渣油-水系乳化液的抑尘性能现场试验研究

本文介绍了作者用渣油－水系乳化液做路面抑尘剂在某矿露天坑３种不同类型路面进行的大规模工业性试验。现场测定结果表明：这种路面抑尘剂可以获得比较理想的防尘效果，长期使用该乳化液可取得显著的综合经济效益。     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

含纤维素废水生物水解的应用研究

提取植物或动物纤维所产生的高浓有机废水，含短小纤维、木质素、纤维素、半纤维素、蜡质、果胶及其分解产物(糖、脂肪酸、醇等)，较难生物处理，属含纤维素废水。试验研究和生产应用表明，生物水解对含纤维素废水中高分子有机物，可予分解并提高度水可生化性：在常温、PH约9．5时，水解池污泥浓度达6．5～16．0g/L，容积负荷达2．9kgCOD／m^3．d，COD去除率为24—36％，VFA提高3．9—5．1倍，BOD／COD提高12～16％。分析认为：中温、酸性，纤维素、木素含量低时，水解效果应更好。     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

生物膜反应器处理洗涤污水的试验

介绍了采用生物膜反应器处理洗涤污水的试验研究方法，研究了COD、LAS和NH3-N的去除效果。试验结果表明：整个系统出水稳定，水质良好（COD〈38．7mg／L、NH3-N〈1．1mg／L、LAS〈0．9mg／L，且无色无味、无SS），符合国家建设部生活杂用水回用水质标准，且具有较强的抗冲击负荷能力。在生物膜反应器中，微生物对污染物的去除起主要作用，而中空纤维膜对维持系统的稳定出水起重要作用。     

陶瓷微滤膜过滤黑液的清洗与再生

对无机陶瓷微滤膜过滤草桨黑液的膜清洗及再生的方法进行了研究。考察了物理和化学方法的再生效果、单种清洗剂的清洗效果、复合方法的清洗效果和效果的可重复性。结果表明物理冲洗、高温灼烧、单一的化学清洗剂清洗均可以提高陶瓷膜的再生通量；但是复合方法对陶瓷微滤膜的再生效果较好，其中按氢氧化钠溶液清洗、硝酸溶液清洗、次氯酸钠溶液清洗的实验步骤，膜的再生渗透通量高．且重复性强，可望在工业生产的在线清洗中应用。     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.