厌氧氨氧化微生物颗粒化及其脱氮性能的研究

利用厌氧颗粒污泥作为种泥,启动SBR反应器,旨在培养厌氧氨氧化颗粒污泥以及研究其脱氮性能.结果表明,水力停留时间(HRT)是富集厌氧氨氧化微生物的1个重要控制因素,以HRT为30 d,第58 d时,SBR反应器就出现厌氧氨氧化现象,与此同时,颗粒污泥由灰黑色变为棕褐色,粒径减小.到第90 d时,成功培养出厌氧氨氧化颗粒污泥,NH⁺₄-N和NO^-₂-N同时被去除,最大去除速率分别达到14.6 g/(m³·d)和6.67 g/(m³·d).从第110　d开始,逐步降低HRT,以提高基质负荷促进厌氧氨氧化菌生长.到目前t＝156　d,HRT降到5　d,氨氮和亚硝酸氮的去除率分别达到60.6%和62.5%,亚硝酸氮/氨氮的比率为1.12.污泥也由棕褐色变为红棕色,形成红棕色的具有高厌氧氨氧化活性颗粒污泥,总氮负荷达到34.3 g/(m³·d).     

好氧亚硝化颗粒污泥特性的研究

对在小试曝气上流式污泥床反应器中成功培养出的好氧亚硝化颗粒污泥的特性进行了研究.工艺稳定运行时,亚硝化颗粒污泥的VSS/SS稳定在80%左右,粒径大于1.0 mm的颗粒污泥约占总数的70%,粒径大于0.8 mm的颗粒污泥的湿密度约为1?022 kg/m³.荧光原位杂交结果表明,亚硝化细菌主要分布在颗粒污泥的表层,而硝化细菌则分布在表层之下;最大可能数结果显示,亚硝化工艺稳定运行时亚硝化细菌的数量远多于硝化细菌,甚至可高于硝化细菌4个数量级以上.上述结果表明,硝化细菌（AOB和NOB）以接种的产甲烷颗粒污泥或其碎片为载体,通过在其表层附着生长,最终形成好氧亚硝化颗粒污泥.     

好氧颗粒污泥膜生物反应器污泥性状研究

采用厌氧-好氧运行方式的颗粒污泥膜生物反应器（GMBR）,连续运行近120　d表现出良好的有机物去除及同步硝化反硝化能力.对GMBR中污泥粒径分布变化研究表明,GMBR中污泥浓度的增加主要是由于粒径0.18～0.45　mm的小颗粒污泥及小于0.18　mm的絮状污泥的增加造成的,粒径大于0.45　mm的颗粒污泥能够基本稳定维持其颗粒形态,反应器运行末期,GMBR中颗粒污泥（粒径大于0.18　mm的污泥）含量稳定在污泥总量的60％～65％以上.污泥表面电荷量随着污泥组成形态的变化电负性逐渐增加,80　d后稳定在-0.42～-0.80　meq·g^-1之间.污泥表面电荷的负电性增加主要是由小于0.45　mm的污泥造成的,其中小于0.18　mm的絮状污泥对其影响最大.并且,污泥粒径越大污泥表面负电荷量越少,两者具有较好的线性关系.另外,GMBR中SVI稳定在60～90 mL/g之间,并且随着污泥表面电荷负电性的增加污泥SVI值增加,两者之间具有一定的相关性.     

进料负荷调控培养好氧颗粒污泥的试验研究

采用厌好氧交替的SBR反应器,以进料负荷（即进水浓度）作为主要控制参数,研究了好氧颗粒污泥的关键培养技术.结果表明,在30 min的较长污泥沉降时间下,通过进料COD 0～900 mg·L^-1的负荷调控,可以有效控制反应器内污泥生长.初始接种污泥的沉降性能对颗粒污泥产生很重要,SVI值保持在20～50 mg·L^-1才能有助于颗粒污泥形成和培养.应用“空曝”这种强力负荷调控方式可大大改善污泥沉降性能,并促进颗粒污泥的形成.通过进料减负荷运行可很好实现污泥的“完全颗粒化”培养.颗粒化转变出现在进料浓度COD 400～500 mg·L^-1,污泥浓度约8～10 g·L^-1.“完全颗粒化”污泥的性能优异,粒径约1.0 mm,SVI值25～35 mg·L^-1,最大沉降速率60 m·h^-1.污泥颗粒过程的发生可能决定于SBR的独特间歇式运行,即基质浓度的贫富交替,减负荷运行可强化基质贫富交替并增大颗粒化过程的驱动力.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

Thermodynamics and kinetics of cadmium adsorption onto oxidized granular activated carbon

Cadmium sorption behavior of granular activated carbon oxidized with nitric acid was systematically studied by sets of the equilibrium and time-based experiments under various conditions.The cadmium adsorption capacity of oxidized granular activated carbon enlarged with an increase in pH,and reduced with an increase in ionic strength.Experimental data were evaluated to find out kinetic characteristics.Adsorption processes were found to follow pseudo-second order rate equation.Adsorption isotherms correlate well with the Langmuir isotherm model and the maximum sorption capacity of cadmium evaluated is 51.02μmol/g.Thermodynamic parameters were calculated based on Van't Hoff equation.Equilibrium constant Kd was evaluated from Freundlich isotherm model constants,Langmnir isotherm model constants,and isotherms,respectively.The average change of standard adsorption heatΔH~0 was -25.29 kJ/mol.NegativeΔH~0 andΔG~0 values indicate the adsorption process for cadmium onto the studied activated carbon is exothermic and spontaneous.The standard entropyΔS~0 was also negative,which suggests a decrease in the freedom of the system.     

利用紫外预处理加强氯苯的生物滴滤净化

试验采用主波长为185nm的低压汞灯为紫外光源、醚型聚氨酯海绵(PU-foam)为填料的紫外-生物滴滤塔联合装置净化氯苯废气.进气氯苯浓度为600mg·m-3、停留时间分别为92、69和46s时,联合装置的平均去除率分别达到99%、95%和80%;最大去除负荷达到59.6g·(m3·h)-1;联合装置和单独生物滴滤塔生物膜形成时间分别为20d和27d;联合装置的抗冲击能力较好,停留时间缩短至30s,联合装置去除效率可达75%以上,高于单独生物滴滤塔的去除效率(25%).对紫外-生物滴滤塔联合装置机制初步探讨表明,紫外氧化氯苯形成了水溶性较好的可生物降解的物质,降低生物滴滤塔氯苯的处理负荷,同时紫外辐照过程中产生的O3能有效地控制生物滴滤塔内微生物的过量生长,从而维持整个装置的最佳运行状态.     

纳米铁强化的混凝-沉淀-过滤工艺对典型印染废水中有机物去除

以东江流域某典型印染企业尾水为研究对象,将混凝剂与少量的纳米铁进行复合投加,再结合多介质过滤器对印染尾水进行深度处理实验研究.结果表明,新型混凝剂HPAC-9对极性有机物具有较强的去除能力,但对非极性或弱极性有机物去除效果不很理想.通过将纳米铁与HPAC-9复合投加并结合多介质过滤工艺,对印染企业尾水中的有机污染物进行...     

连续流膜生物反应器中好氧颗粒污泥的形成及机制探讨

为了探讨好氧颗粒污泥在连续流膜生物反应器(MBR)中的形成过程和机制,采用连续流试验的方法,研究了好氧颗粒污泥形成过程中膜反应器内污染物的去除效果和好氧颗粒污泥特性的变化,并对连续流MBR中好氧颗粒污泥的形成机制进行了探讨.结果显示,连续流MBR中好氧颗粒污泥的形成增强了MBR的运行稳定性和抗冲击能力.废水中微生物抑制...     

半干法脱硫配套布袋除尘器的特殊要求

由于半干法脱硫工艺对布袋除尘器的特殊要求,使得其配套的布袋除尘器构造不同于以往常规的布袋除尘器.从布袋除尘器的过滤风速、滤料选择、沉降室设置、布风均匀性、灰斗特性、旁路系统的要求做详细的说明.