原子吸收法测定土壤中铅的方法

通过湿法消解土壤样品,利用石墨炉原子吸收分光光度法(GAAS)和火焰原子吸收分光光度法(FAAS)测定不同土壤样品中铅的含量,以验证2种方法的有效性并加以对比。实验结果表明:2种方法均满足土壤中铅含量的测定要求,测定的标准土样含量均在标准值的不确定度范围内,GAAS方法测定结果更接近保证值。二者的相对标准偏差(RSD)值均低于1.5%,FAAS方法的精密度更高,且具有快速简单等优势。     

前驱物结晶体升华成膜法制备TiO2薄膜及其光催化性研究

采用“前驱物结晶体升华成膜法”工艺，使含钛前驱物结晶体草酸氧钛酸以升华的方式，均匀地在玻璃表面形成前驱物薄膜；经过热处理，制备出外观平整透明的玻璃基TiO2薄膜，其薄膜厚度为80-100nm，粒度≤50nm。初步研究了制备条件、薄膜性能和本工艺制备的玻璃基TiO2纳米薄膜对甲基对硫磷的光催化降解性能。     

玻璃弹簧负载镶嵌纳米粒子TiO2膜光催化降解活性深蓝K-R

以玻璃弹簧负载镶嵌纳米粒子的TiO2膜降解活性深蓝K-R模拟废水,考察了pH值和温度对脱色率的影响以及CODCr去除率与脱色率之间的关系,并用XRD和SEM对催化剂进行了表征.结果表明,pH值和温度对脱色率均有显著影响,CODCr去除率与脱色率的比值约为70%左右;XRD表明,TiO2矿相主要为锐钛型,SEM表明,镶嵌TiO2粒子均匀,粒径约50nm.     

生物膜法降解甲苯废气过程的探讨

采用陶粒为填料的生物滤池降解甲苯废气，并对清水试验和生物膜试验的结果进行分析，发现生物膜法降解甲苯这样的挥发性有机物（VOCs)具有良好的效果，已不再是清水试验中单纯的物理吸收过程，而是伴有生化反应的吸收过程，是以气膜控制为主的传质过程。     

高浓度苯酚在石墨电极上电解特性的研究

研制了数据在线采集记录系统对高浓度苯酚在石墨电极上电解过程的循环伏安行为进行了研究。采用连续循环伏安法考察了体系电解的特点,并考察了支持电解质、扫描速率、苯酚的浓度对反应体系的影响。结果表明:峰电流密度与扫描速率的平方根及苯酚浓度呈线性递增关系,支持电解质的添加量在苯酚电解过程存在最佳值,多次扫描过程中峰电流密度有下降趋势。实验推断电解效率下降是由于电极表面被聚合物污染导致,这一现象对电解处理有机物种的系统控制过程具有重要意义。     

曝气生物滤池去除有机物与反应常数及膜厚的关系

推导了BAF前置反硝化工艺简化动力学模型,揭示了BAF去除有机物与反应速率常数与膜厚的关系。同时以生物膜中活性物质与非活性物质增长生物数学模型体系为基础,从理论上推导了BAF最佳膜厚的范围。     

Performance and mechanism of Cr(VI) removal by zero-valent iron loaded onto expanded graphite

Zero-valent iron (ZVI) was loaded on expanded graphite (EG) to produce a composite material (EG-ZVI) for efficient removal of hexavalent chromium (Cr(VI)). EG and EG-ZVI were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier-transform infrared (FTIR) spectroscopy and Brunauer–Emmett–Teller (BET) analysis. EG-ZVI had a high specific surface area and contained sub-micron sized particles of zero-valent iron. Batch experiments were employed to evaluate the Cr(VI) removal performance. The results showed that the Cr(VI) removal rate was 98.80% for EG-ZVI, which was higher than that for both EG (10.00%) and ZVI (29.80%). Furthermore, the removal rate of Cr(VI) by EG-ZVI showed little dependence on solution pH within a pH range of 1–9. Even at pH 11, a Cr(VI) removal rate of 62.44% was obtained after reaction for 1 hr. EG-ZVI could enhance the removal of Cr(VI) via chemical reduction and physical adsorption, respectively. X-ray photoelectron spectroscopy (XPS) was used to analyze the mechanisms of Cr(VI) removal, which indicated that the ZVI loaded on the surface was oxidized, and the removed Cr(VI) was immobilized via the formation of Cr(III) hydroxide and Cr(III)–Fe(III) hydroxide/oxyhydroxide on the surface of EG-ZVI.     

Influences of working pressure on properties for TiO2 films deposited by DC pulse magnetron sputtering

TiO2 films were deposited at room temperature by DC pulse magnetron sputtering system.The crystalline structures,morphological features and photocatalytic activity of TiO2 films were systematically investigated by X-ray diffraction (XRD),atomic force microscopy and ultraviolet spectrophotometer,respectively.The results indicated that the working pressure was the key deposition parameters influencing the TiO2 film phase composition at room temperature,which directly affected its photocatalytic activity.With increasing the working pressure,the target self-bias decreases monotonously.Therefore,low temperature TiO2 phase (anatase) could be deposited with high working pressure.The anatase TiO2 films deposited with 1.4 Pa working pressure displayed the highest photocatalytic activity by decomposition of Methyl Orange solution,which the degradation rate reached the maximum (35%) after irradiation by ultraviolet light for 1 h.     

Photocatalytic degradation of methyl orange over ITO/CdS/ZnO interface composite films

ITO/CdS/ZnO interface composite films were successfully prepared by subsequent electrodeposition of CdS and ZnO onto indium tin oxide (ITO) glass substrates. The obtained ITO/CdS/ZnO composite films were characterized with X-ray diffraction (XRD), scanning electron microscopy (SEM), and UV-Vis spectroscopy. The photocatalytic activity of ITO/CdS/ZnO composite films were investigated using methyl orange (MO) as a model organic compound under UV light irradiation. The influence of operating parameters on MO degradation including initial concentration of MO, pH value of solution, and inorganic anion species over the composite films were examined. A blue shift of absorption threshold was observed for the ITO/CdS/ZnO film in comparison with ITO/ZnO film. ITO/CdS/ZnO composite films prepared under specific conditions showed a higher photocatalytic activity than that of ITO/ZnO films. It was also found that the photocatalytic degradation of MO on the composite filing followed pseudo-first order kinetics.     

一种新型石墨电极的制备及其对苯酚的去除

为了探索一种对有机废水处理有效、廉价、来源广泛、环境友好的电极,以石墨、环氧树脂、固化剂和丙酮为原料,研究制备了一种新型石墨电极 (NGE). 分别采用热水浸泡、乙醇溶液回流、丙酮回流、超声-丙酮回流以及电化学法对制备的石墨电极进行预处理,前三者效果较差,超声-丙酮回流可改善处理效果,但不够理想,电化学法可取得满意的效果.苯酚降解的UV光谱分析表明,尽管商品石墨电极 (CGE) 比NGE具有更高的苯酚氧化效率,但其电解液积累大量的苯醌,而NGE电解液中苯醌积累量少,并且电解过程中逐渐降低. NGE比CGE具有更好的TOC去除效果,两者TOC去除率分别为40%和31%. SEM分析结果表明,CGE被严重腐蚀,NGE无明显变化,表现出良好的稳定性.