深型地下土壤渗滤系统中氮的去除途径

为了系统研究氮在深型地下土壤渗滤系统中的去除途径,本次实验采用直径30cm,高200cm的有机玻璃柱模拟地下土壤渗滤系统;柱内分层装填取自北京顺义的土壤。在水力负荷为8cm／d的条件下,取得了较好的脱氮效果;氨氮去除率为99．80％;TN去除率为83．68％。通过观察氮沿土柱深度的变化规律发现,在1．30m以上的区域随着氨氮浓度的降低硝氮浓度逐渐增大,同时总氮浓度也在不断降低,约有30．55％在此区域被去除;通过氮元素质量平衡证明这部分氮是通过厌氧氨氧化反应去除的。在1．30m以下反硝化反应是脱氮的主要途径,在此过程中难降解有机物被利用。     

Evaluating Infiltration Requirements for New Development Using Extreme Storm Transposition: A Case Study from Dane County,WI

Changes in land use and extreme rainfall trends can lead to increased flood vulnerability in many parts of the world, especially for urbanized watersheds. This study investigates the performance of existing stormwater management strategies for the Upper Yahara watershed in Dane County, WI to determine whether they are adequate to protect urban and suburban development from an extreme rainfall. Using extreme storm transposition, we model the performance of the stormwater infiltration practices required for new development under current county ordinances. We find during extreme rainfall the volume of post‐development runoff from impervious surfaces from a typical site would increase by over 55% over pre‐development conditions. We recommend the ordinance be strengthened to reduce vulnerability to flooding from future urban expansion and the likely increase in the magnitude and frequency of extreme storms.     

生态土壤渗滤系统启动周期研究

利用室内模拟试验装置,考察了4种生态土壤渗滤系统在0.1 m3/(m2·d)的水力负荷条件下对生活污水中TP、COD和NH3-N的去除效果及启动周期; 同时对整个系统及同类生态工艺启动周期的判断方法做了探讨.研究结果表明,生态土壤渗滤系统对TP、COD和NH3-N的启动周期分别为15～27 d、24～40 d和24～26 d; 土壤渗滤系统对TP的启动周期最短,对COD的启动周期最长; 处理系统启动周期的判断原则是综合考察系统对主要污染物各自的启动周期,以最长的作为系统启动周期.4组试验中,1#和2#系统的启动周期为40 d; 3#和4#的为24 d.     

APPLICATION OF THE GREEN-AMPT INFILTRATION EQUATION TO WATERSHED MODELING1

ABSTRACT: A computer model was developed, based on the Green-Ampt infiltration equation, to computed rainfall excess for a single precipitation event. The model requires an estimate of parameters related to hydraulic conductivity, wetting front section, and fillable porosity of the soil layers. Values of parameters were estimated from soil textural averages or regression equations based on percent sand, percent clay, and porosity. Average values of effective porosity and wetting front suction were largely acceptable due to the relatively low variability and low model sensitivity to the parameters. Hydraulic conductivity was the most erratic constituent of the loss rate computation due to the high variability and the high sensitivity of the computed infiltration to the parameter. The performance of the Green-Ampt infiltration model was tested through a comparison with the SCS curve number procedure. Seven watersheds and 23 storms with precipitation of one inch or greater were used in the comparison. For storms with less than one inch of rainfall excess, the SCS curve number procedure generally gave the best results; however, for six of the seven storms with precipitation excess greater than one inch, the Green-Ampt procedure delivered better results. In this comparison, both procedures used the same initial abstractions. The separation of rainfall losses into infiltration, interception, and surface retention is, in theory, an accurate method of estimating precipitation excess. In the second phase of the study using nine watersheds and 39 storms, interception and surface retention losses were computed by the Horton equations. Green-Ampt and interception parameters were estimated from value sin the literature, while the surface retention parameter was calibrated so that the computed runoff volumes matched observed volumes. A relationship was found between the surface retention storage capacity and the 15-day antecedent precipitation index, month of year, and precipitation amount.     

INFILTRATION EVALUATION OF FOUR MECHANICAL RAINFALL SIMULATION TECHNIQUES IN SIERRA NEVADA WATERSHEDS1

ABSTRACT: Little quantitative site-specific infiltration, runoff and sediment transport data for Tahoe Basin soils under varying storm events or stage of development are available. Modular (Ml), F-type (M2), Impact nozzle (M3), and Impact-Fan nozzle (M4) rainfall simulators were evaluated as to their practicality and ability to characterize infiltration for the Cagwin Soil Series within the Tahoe Basin. Three slope (0–15,15–30, >30%) and four plot conditions (natural with duff [P1], natural without duff [P2], disturbed without duff [P3], and disturbed with duff [P4]) were studied. The measured data were incorporated into a modified Philip's infiltration model and multiple non-linear regression analyses were used to examine relationships between method, slope, plot condition, and infiltration characteristics.^t Simulation methods Ml and M4 produced statistically similar (P=0.01) infiltration data, as did M2 and M3 which produced lower infiltration rates. All were found suitable for use in Sierra Nevada watersheds. Ml was considered most practical. Slope had negligible effect on infiltration. The plot condition was found to significantly influence infiltration, and the effect of each plot condition was significantly different. Final infiltration rates ranged from 4.7 to 6.2 cm/hr. Thus, the Cagwin soil demonstrated moderate to high infiltration rates even when exposed to extreme storm conditions (8–10 cm/hr).     

A DISTRIBUTED DYNAMIC WATERSHED MODEL1

ABSTRACT: A distributed watershed model was developed to mathematically simulate overland and channel flow for a single-event storm. The modeled watersheds in the study were subdivided into rectangular grid elements. All hydrologically significant parameters, such as land slope, rainfall and precipitation excess, were assumed to be uniform within each element. The Green-Ampt method was adopted to generate precipitation excess for each element during the simulation period. A two-dimensional diffusion wave model was used for overland flow routing and an iterative Alternative Direction Implicit scheme was used to solve the simultaneous overland flow equations. Once the overland flow became inflow to the channel, a one-dimensional dynamic wave flood routing technique, based on a four-point, implicit, non-linear finite difference solution of the St. Venant equation of unsteady flow, was applied. A limited number of comparisons were made between simulated and observed hydrographs for areas of about one square mile. Given the appropriate parameters, the model was able to accurately simulate runoff for single-event storms. This paper describes a distributed watershed model developed to simulate overland and channel flow. Comparisons were made between simulated and observed hydrographs for three watersheds. The model was able to accurately simulate the runoff for single-event storms using 61-m by 61-m (200 ft by 200 ft) watershed grid elements.     

徐州市奎河河流--地下水渗流系统处理水体中氮

基于污水土地处理系统可以渗漏形式补给地下水的特点，利用现场调查分析的方法，提出了一种新的污水土地处理方式－河流－地下水渗流系统去除污水中氮。结果表明，河流－地下水饱和渗流系统对氮污染组分具有很高的去除作用，在距河流４０ｍ处对污水中氮的去除率达９５％以上，且不受季节变化的影响。     

低负荷间歇运行燃煤锅炉烟尘排放规律的探讨

通过对不同负荷情况下运行的燃煤锅炉烟尘排放浓度测试，探讨了低负荷间歇运行燃煤锅炉的烟尘排放规律。随着锅炉负荷的降低，过量空气系数变大，烟尘排放浓度和排放量也变大。在相近低负荷条件下运行的不同出力的锅炉，额定出力大的锅炉烟尘排放量大。在燃煤量相近而在不同负荷状态下运行的两台锅炉，额定出力大的锅炉烟尘排放量大。对于常年低负荷运行时的锅炉，环境管理部门在对其烟尘排放进行监督管理时宜以低负荷运行时的烟尘测试数据为依据。     

焦作市某赤泥堆放场周围地下水水质评价

焦作市某赤泥堆放场一期工程采用了在堆放场底部铺设赤泥加石灰垫层和防渗膜的工程防渗处理措施.基于其防渗处理现状,文章探讨了该区域地下水对赤泥冲灰水的日最大允许入渗量,和赤泥冲灰水的实际日渗透量.评价了该防渗处理措施的可行性和在地下水日活动量稳定的状况下,该赤泥堆放场对周围地下水的影响.结果表明:将赤泥加石灰垫层用作防渗的措施值得大力推广;该堆放场在使用年限内不会对周围区域地下水水质造成太大的影响.     

浮动生物床/地下渗滤联合工艺处理校园污水的设计与管理

结合沈阳师范大学的校园污水处理实例,阐明地下渗滤与浮动生物床联合工艺的设计和运营管理的问题.实践证明,采用浮动生物床/地下渗滤工艺对生活污水进行深度处理,投资运行费用低、管理简单、出水水质稳定且优于所要求的回用水水质.