一次监测值用于水质评价的研究

以2003年长江和淮河水系为例,通过计算各个评价项目的单月监测值分别与季均值和年均值的相对误差及其分布,以及水质类别相同的断面比例,认为对于旬报、月报短期水质评价,采用一次监测的数据评价水质是可靠的;对于季报和年报中、长期水质评价,采用一次监测数据评价的可靠程度较差,应采用2次或2次以上的监测数据平均值进行评价。     

地表水环境质量定性评价

针对目前缺乏统一的地表水环境质量定性评价准则的现状,根据我国主要水体的污染程度,提出了断面、河流、水系水质定性评价方法。     

Assessing protected area effectiveness using surrounding (buffer) areas environmentally similar to the target area

Many studies are based on the assumption that an area and its surrounding (buffer) area present similar environmental conditions and can be compared. For example, in order to assess the effectiveness of a protected area, the land use/cover changes are compared inside the park with its surroundings. However, the heterogeneity in spatial variables can bias this assessment: we have shown that most of the protected areas in Mexico present significant environmental differences between their interior and their surroundings. Therefore, a comparison that aims at assessing the effectiveness of conservation strategies, must be cautioned. In this paper, a simple method which allows the generation of a buffer area that presents similar conditions with respect to a set of environmental variables is presented. The method was used in order to assess the effectiveness of the Calakmul Biosphere Reserve, a protected area located in the south-eastern part of Mexico. The annual rate of deforestation inside the protected area, the standard buffer area (based upon distance from the protected area only) and the similar buffer area (taking into account distance along with some environmental variables) were 0.3, 1.3 and 0.6%, respectively. These results showed that the protected area was effective in preventing land clearing, but that the comparison with the standard buffer area gave an over-optimistic vision of its effectiveness.     

Monitoring of Butter and Ghee (Clarified Butter Fat) for Pesticidal Contamination from Cotton Belt of Haryana, India

Butter (45) and ghee (55) samples were collected from rural and urban areas of cotton growing belt of Haryana and analysed for detecting the residues of organochlorine, synthetic pyrethroid and organophosphate insecticides. The estimation was carried out by using multi residue analytical technique employing GC-ECD and GC-NPD systems equipped with capillary columns. Butter samples were comparatively more contaminated (97%) than ghee (94%), showing more contamination with organochlorine insecticides from urban samples. About 11% samples of butter showed endosulfan residues above MRL value and 2% samples had residues of synthetic pyrethroids and organophosphates each above their respective MRL values. In ghee, residues of HCH & DDT both and of endosulfan exceeded the MRL values in 5 and 20% samples, respectively. Among organophosphates, only chlorpyriphos was detected with 9% samples showing its residue above MRL value. Irrespective of contamination levels, residues above the MRL values were more in ghee. More extensive study covering other agricultural regions/zones of Haryana has been suggested to know the overall scenario of contamination of milk products.     

Ecological Risk Assessment of Abandoned Shrimp Ponds in Southern Thailand

The potential ecological risks associated with contaminants from 15 abandoned shrimp ponds in southern Thailand were assessed at the screening level. Shrimp ponds reported as out of production for more than 2 years were selected as sampling sites. The assessment endpoint was identified as the protection of aquatic life from hazard of multiple agents or stressors in water or sediment from the ponds. The measurement endpoints were amount of toxic phytoplankton species, Yellow Head Viruses, SEMB viruses, oxytetracycline, cadmium, copper, and manganese. Data from field measurements and laboratory analyses obtained primarily from April to June 2003 were used in the risk analysis. The results showed that insignificant amounts of stressors were present, except for the metals. So, only concentration values of the metals were used in the calculation of hazard quotients (HQ) for risk characterization. The highest potential ecological risk characterized by the highest HQ value observed for each metal was 19 for manganese, 4.3 for cadmium, and 1.8 for copper. These findings indicated a need for further ecological risk assessment at a more detailed level to focus on the bioavailability and effects of metals from abandoned shrimp farms, with manganese the highest priority.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Environmental benchmarks vs. ecological benchmarks for assessment and monitoring in Canada: Is there a difference?

Environmental benchmarks are widely used in Canadian environmental assessment as a standard against which to monitor air or water quality in response to human activities in the environment. Recent work in Canada has developed the concept of ecological benchmarks as a complement to environmental benchmarks. However, implementation of ecological benchmarks may be challenging. This paper presents an analogy between ecological benchmarks and the more commonly used environmental benchmarks, as an attempt to increase understanding and use of ecological benchmarks in resource management, assessment, and monitoring. Ecological benchmarks, and their corresponding indicators, will be challenging to identify and use. However, through the use of the principles of adaptive management, effective ecological indicators and benchmarks can be established. Although it is essential that ecological benchmarks are site-specific, the analogy and general principles outlined here are applicable to assessment and monitoring in any part of the world.     

Can health feasibly be considered as part of the planning process in Scotland?

The planning system is significant because of its capacity to determine the quality of the built environment as well as the health, well-being and quality of life of the individuals and communities therein. Development planning is especially important because of the long-term impact of the decisions. This paper was developed in response to increasing recognition amongst HIA practitioners in Scotland of the importance of planning for health. It focuses on the relationship between the planning system in Scotland, specifically the Development Planning element of it, and population health and considers how the health impact assessment (HIA) approach can facilitate and support joint working with planners. In particular, consideration is given to the potential impact of the introduction of Strategic Environmental Assessment (SEA) on the linkages between health, HIA and planning.     

Equity-focused health impact assessment: A tool to assist policy makers in addressing health inequalities

In Australasia (Australia and New Zealand) the use of health impact assessment (HIA) as a tool for improved policy development is comparatively new. The public health workforce do not routinely assess the potential health and equity impacts of proposed policies or programs. The Australasian Collaboration for Health Equity Impact Assessment was funded to develop a strategic framework for equity-focused HIA (EFHIA) with the intent of strengthening the ways in which equity is addressed in each step of HIA. The collaboration developed a draft framework for EFHIA that mirrored, but modified the commonly accepted steps of HIA; tested the draft framework in six different health service delivery settings; analysed the feedback about application of the draft EFHIA framework and modified it accordingly. The strategic framework shows promise in providing a systematic process for identifying potential differential health impacts and assessing the extent to which these are avoidable and unfair. This paper presents the EFHIA framework and discusses some of the issues that arose in the case study sites undertaking equity-focused HIA.     

A modular approach to Integrated Assessment modeling

In this paper, we present a new approach to model coupling that probably forms the methodological basis of a new generation of Integrated Assessment models. This approach respects the knowledge and expertise that is embodied in existing models and encourages their gradual evolution. Modularity is the guiding principle. Our approach is distinguished by the way modules are coupled which is based on an interplay of a job control module, a numerical coupling module, and a couple of stand-alone functional modules. The numerical coupling module - the core component - serves to treat the feedbacks between the functional modules. A first implemented example that couples an economic and a climate module by means of a two-phase meta-optimization is presented here. The algorithm and mathematical structure behind are discussed as well as important features such as convergence behavior and reliability.