铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

Simulating dairy liquid waste management options as a nitrogen source for crops

Large scale dairy operations are common. In many cases the manure is deposited on a paved surface and then removed with a flushing system, after which the solids are separated, the liquid stored in ponds, and eventually the liquid applied on adjacent crop land. Management of liquid manure to maximize the fertilizer value and minimize water quality degradation requires knowledge of the interactive effects of mineralization of organic N (ON) to NH₄⁺, crop uptake of mineral N, and leaching of NO₃⁻ on a temporal basis. The purpose of the research was to use the ENVIRO-GRO model to simulate how the amount of applied N, timing of N application, ON mineralization rates, chemical form of N applied, and irrigation uniformity affected (1) yields of corn (Zea mays) in summer and a forage grass in winter in a Mediterranean climate and (2) the amount of NO₃⁻ leached below the root zone. This management practice is typical for dairies in the San Joaquin Valley of California. The simulations were conducted for a 10-year period. Steady state conditions, whereby an equivalent amount of N applied in the organic form will be mineralized in a given year, are achieved more rapidly for materials with high mineralization rates. Both timing and total quantity of N application are important in affecting crop yield and potential N leaching. Major conclusions from the simulations are as follows. Frequent low applications are preferred to less frequent higher applications. Increasing the amount of N application increased both the crop yield and the amount of NO₃⁻ leached. Increasing irrigation uniformity increased crop yields but had variable effects on the amount of NO₃⁻ leached. A winter forage crop following a summer corn crop effectively reduced the leaching of residual soil N following the corn crop.     

采用钙钛矿型催化剂(La0.8K0.2Cu0.05Mn0.95O3)同时催化去除NOx和碳烟的研究

将钙钛矿型催化剂与碳烟均匀混合后置于固定床连续流动反应体系中,利用程序升温反应技术,在模拟柴油机尾气的情况下对同时催化去除氮氧化物(NOx)和碳烟的反应进行了实验研究.通过改变含Cu原料的用量,得到不同Cu取代量的催化剂La0.8K0.2CuxMn1-xO3,性能评价结果表明,La0.8K0.2Cu0.05Mn0.95O3催化剂的综合性能较好,碳烟的起燃温度及NO向N2的最大转化率分别为280℃和58.0%.采用该催化剂,进一步考察了进气中NO浓度、O2浓度、进气总流量及催化剂与碳烟的接触状况对反应的影响.研究结果表明,进气中NO浓度、O2浓度、气体总流量和催化剂与碳烟之间的接触状况对NO的去除率的影响比较明显,而对碳烟起燃温度的影响较小.O2浓度从5%变为7.5%时,碳烟的起燃温度及最大NO转化率分别从280℃和53.8%变为270℃和96.7%.碳烟与催化剂松散接触时,碳烟的起燃温度及最大NO转化率分别为290℃和48.4%,紧密接触时分别为275℃和70.4%.而进气中NO浓度、气体总流量的变化对碳烟的燃烧基本上没有影响,虽然NO的转化率有明显变化,但生成的N2总量基本不变.     

脱氮-混凝气浮-UASB-接触氧化法处理垃圾填埋渗滤液

采用脱氮—混凝气浮—UASB—接触氧化工艺处理高氨氮、高浊度的垃圾渗滤液，使处理后出水的各项指标完全达到国家《污水综合排放标准》(GB8978—1996)二级新扩改标准。对废水处理系统的工艺作了简单介绍，并对系统的调试、运行过程进行了技术总结。     

应用被动扩散管监测分析葫芦岛市环境空气NO2时空分布特征

被动扩散技术以其低成本、操作简单、空间覆盖率较高等优点已在西方国家广泛应用于环境空气质量监测与调查,辽宁省环保局通过欧盟项目引进,本技术在葫芦岛市环境空气质量监测应用有4年时间.依据4年环境空气被动扩散管监测基础数据,分析了解葫芦岛市城区大气中NO2时空分布特征:高浓度值出现在交通区,季节上呈现春季明显低于其它季节.     

胶州湾入海污染物总量控制研究

在胶州湾水质数值模拟的基础上,建立了污染物总量控制模型.计算了各个点源的响应系数,分担率及环境容量.结果表明,胶州湾内COD各入海污染源均有余量,不需要削减.胶州湾东北部N、P污染较严重,污染物入海总量已经超过海域的环境容量.研究结果将为胶州湾污水排海、海域水质管理、总量控制规划编制提供科学依据.     

铜铁矿井下采掘工程的环境影响及生态保护

对铜铁矿井下采掘工程产生的环境影响进行了分析，外排井下涌水下的铜可对鱼类养殖业水体的地表水质带来不利影响，采用帷幕注浆堵水工艺可防止大面积地表塌陷的发生，对难以避免的局部，小规模塌陷提出了生态安全的预警措施。     

活性炭吸附与生物活性炭脱臭效果的比较研究

针对污水收集与处理系统中恶臭气体的组成与特性,比较分析不同情况下活性炭吸附与生物活性炭的脱臭效果。当干活性碳总处理气量达到1.3m~3/g时,出现穿透。将吸附饱和的活性炭填料塔转为生物滴滤反应器后,仍能较快的实现挂膜生长,达到满意的处理效果。直接运行的生物活性炭滴滤器对H_2S的处理效率在95％以上,并具有较强的恢复能力。H_2S平均出口浓度为0.052mg/m~3。循环液pH值与盐度在一定范围内对系统影响不大。