A product analysis-based study on the mechanism of inflammable gas explosion suppression

To study the mechanism of the suppressing effect of Expanded Aluminium (EA) on the premixed gas explosion, premixed methane-air and propane-air gases were undergone explosion reaction in the presence of EA in a self-designed closed pipeline with the overpressures and the compositions, rates and sensitivities of products analyzed. The results showed that the 9.5% methane-air and 5% propane-air explosions produced peak pressures decreased by 79.3% and 65.6%, and residual methane and propane contents increased by 270% and 560% respectively than without EA. In addition, the results revealed that the explosions of propane in the presence of EA produced less methane and carbon oxides contents, but more ethylene and propylene contents. The simulation showed that H, O, and OH are the key factors affecting the rate of products. The product compositions, together with other parameters, suggested that EA decreased temperature, inhibited chain initiation and propagation reaction, but facilitated chain termination reaction by advancing and accelerating the gas phase and wall destruction reaction of radicals, especially collisions and concentration of key free radicals. This new research method based on the analysis of explosion products can be used for in-depth research into gas explosion features and shed light on the suppressing mechanism of EA in flammable gas explosion.     

受限空间内惰性气体对CH4爆炸抑制特性研究

N2和CO2是常用的惰性抑爆气体,为研究两种气体的抑爆特性,采用20L球形爆炸试验装置,分析了不同浓度配比条件下N2/CH4/空气以及CO2/CH4/空气混合气体的爆炸压力,同时采集爆炸后的气体样品,对比分析爆炸后残留气体的主要成分。结果显示:随CH4浓度从5%增加至12.5%时,完全抑制CH4爆炸需要的惰性气体最小量先增大后降低,CH4浓度在6.5%~7.5%之间时,抑爆需要的惰性气体的量最大;在同一CH4浓度条件下,抑爆需要N2的量大于CO2,并且CH4浓度在5%~6.5%时,抑爆需要两种惰性气体的量值差别最大;当CH4浓度一定时,随着加入惰性气体量的增大,爆炸最大超压逐渐降低,惰性气体浓度和爆炸超压之间基本呈线性关系;在同样条件下,相对于N2,CO2为抑爆气体时,爆炸后腔体内残留的CH4浓度较高。研究成果为惰性气体抑爆技术提供技术支撑,同时为揭示惰性气体抑爆机理有一定作用。     

某型机车牵引电机传动端轴承低速轻载无飞溅润滑试验研究

主要根据客户要求,在低速(1 km/h)及轻载工况下,测量传动端轴承无飞溅润滑条件下的温升等参数,而进行相关的电机试验,为某型机车牵引电机传动端轴承在低速及轻载工况下,无飞溅润滑提供试验验证及技术支撑。     

Water saving effect on integrated water resource management

This study proposes an improved integrated water resource management (IWRM), in which water conservation was analyzed for the entire water use process. A multi-objective optimization method was applied to optimize the IWRM, which investigated the reduction of freshwater consumption and the total water supply cost. Customer's preference for saving water and an end use analysis (EUA) was applied in the water conservation analysis. Taking Tianjin as the study area, a reduction in customer's economic pressure (EP) was utilized to evaluate the degree of the customer's preference for saving water. The results revealed that agriculture had a greater preference for saving water than other sectors, where as the public had the weakest motivation for saving water. Improving the transportation method could contribute 62.1% of the total water savings in the agriculture sector. The optimization of the IWRM demonstrated that the local freshwater savings would be 21.5%, and the total cost for water supplies would decrease by 13%. However, a government subsidy of 87.5 million Yuan would be needed. Additionally, by analyzing the change in the amount of water savings affected by water price, the appropriate water price increase range was suggested to be 1.5–1.7 times the original price.     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

PLC控制系统在钢渣热焖工艺中的应用

利用PLC控制系统,实现在钢渣热焖工艺中的恒压供水和钢渣热焖定时定量喷水的自动控制要求,具有国际先进水平,取得了良好的经济效益、社会效益和环境效益.     

北京电动出租车与燃油出租车生命周期环境影响比较研究

燃油机动车尾气排放是导致城市包括雾霾在内的大气环境问题的主要来源之一.以电动汽车替代传统燃油车是当前各国解决城市大气污染问题的重要举措.北京于2011年启动了电动出租车推广计划.为比较北京市迷迪电动汽车和现代燃油车生命周期的环境影响,运用生命周期评价方法,基于Ga Bi4.4软件,选用CML2001和EI99影响评价模型对两款车的生产、使用和报废回收全生命周期过程的环境影响进行了定量评价,并针对汽车报废里程和电力能源结构进行了敏感性分析.结果表明,从全生命周期视角,根据EI99评价模型,迷迪电动汽车环境影响总体上优于现代燃油车,尤其在削减化石能源消耗方面优势凸显,但在生态系统质量影响及人体健康影响方面却略有增大的趋势;利用CML2001模型对比分析得出迷迪电动汽车比燃油出租车在对非生物资源消耗、全球变暖以及臭氧层损耗等方面有明显改善;但在生产阶段尤其是动力系统生产方面在非生物资源消耗、酸化、富营养化、全球变暖、光化学臭氧合成、臭氧层损耗、生态毒性等生态环境影响却均有增大趋势.使用阶段电力生产是迷迪电动汽车非生物资源消耗、酸化、富营养化、全球变暖、光化学臭氧合成、生态毒性等环境影响的主要来源;而现代燃油出租车使用阶段的环境影响主要来源于尾气排放和汽油生产,其中尾气排放是造成现代燃油车在富营养化和全球变暖等方面影响潜值较大的主要原因;基于清单数据库,针对致霾因子影响分析得出,在2010年北京市电力能源驱动下,迷迪电动车明显增加了超细颗粒物(PM2.5)、氮氧化物(NOx)、硫氧化物(SOx)、挥发性有机物(volatile organic compouds,VOCs)等因子的全生命周期的排放,而同时降低了氨气(NH3)的排放量,使用阶段排放的差别是造成上述趋势的主要原因.对关键因素敏感性分析发现,随着报废里程以及清洁能源比例的增加,迷迪电动汽车相对现代燃油车的单位里程碳减排量呈现增加的趋势.清洁电力能源的使用可大幅降低迷迪电动汽车致霾污染物的排放量.根据分析结果,为北京市电动车的推广提出了对策建议.     

水平对置活塞发动机高空热平衡特性研究

目的研究不同海拔大气压力特别是高空条件对水平对置活塞汽油机热平衡性能的影响。方法利用内燃机高空模拟试验台进行不同海拔高度(0~7000 m)下水平对置活塞汽油机的热平衡试验,测得不同海拔下排温、缸体表面温度等特征参数,计算热流量分配特性,并对比分析热流量分配特性随海拔高度的变化规律。结果随海拔升高,汽油机排温和缸体表面温度逐渐下降,且海拔愈高,缸体表面温度下降幅度愈大。汽油机有效功率随海拔升高逐渐下降,余项损失百分比逐渐上升,且在低转速下,变化幅度增大。在6000 m模拟海拔、3000 r/min转速下,汽油机有效热效率不到5%,而余项损失达到了30%以上,此时部分汽油甚至并未燃烧。结论高空环境对水平对置汽油机热平衡性能造成严重影响,成为制约其高海拔性能恢复的关键因素。     

中国低中放近地表处置场环境评价方法研究

放射性废物的处置是对其管理的最终步骤.放射性废物处置的基本安全目标是保护人类和环境免受电离辐射的有害影响.开展处置场环境影响评价可以量化它对人体健康和环境潜在影响.通过与IAEA近十几年的最新研究成果相比较,分析了中国低中放近地表处置场现行评价方法的不足,提出了改进方式,并对中国近地表处置场环境影响评价技术研究下一步应开展的工作进行了探讨.     

太湖流域污水处理厂低温生物脱氮运行模式研究

以苏州工业园区第二污水厂在冬季低温下的实际运行为例,重点分析了低温生物脱氮的影响因子,并探讨影响低温生物脱氮的因素.根据污水处理厂冬季水温特征和低温脱氮影响规律,结合污水厂运行经验和数据分析提出太湖流域污水厂低温生物脱氮的适合措施,以达到低温下保证运行效果使出水达标,并结合冬季低温下太湖流域污水厂的特点,为保证总氮出水达标提出来了相应的解决方案和措施.