Degradation of polyacrylamide (PAM) and methane production by mesophilic and thermophilic anaerobic digestion: Effect of temperature and concentration

• PAM degradation in thermophilic AD in comparison with mesophilic AD. • PAM degradation and its impact on thermophilic and mesophilic AD. • Enhanced methane yield in presence of PAM during thermophilic and mesophilic AD. • PAM degradation and microbial community analysis in thermophilic and mesophilic AD. Polyacrylamide (PAM) is generally employed in wastewater treatment processes such as sludge dewatering and therefore exists in the sludge. Furthermore, it degrades slowly and can deteriorate methane yield during anaerobic digestion (AD). The impact or fate of PAM in AD under thermophilic conditions is still unclear. This study mainly focuses on PAM degradation and enhanced methane production from PAM-added sludge during 15 days of thermophilic (55°C) AD compared to mesophilic (35°C) AD. Sludge and PAM dose from 10 to 50 g/kg TSS were used. The results showed that PAM degraded by 76% to 78% with acrylamide (AM) content of 0.2 to 3.3 mg/L in thermophilic AD. However, it degraded only 27% to 30% with AM content of 0.5 to 7.2 mg/L in mesophilic AD. The methane yield was almost 230 to 238.4 mL/g VSS on the 8th day in thermophilic AD but was 115.2 to 128.6 mL/g VSS in mesophilic AD. Mechanism investigation revealed that thermophilic AD with continuous stirring not only enhanced PAM degradation but also boosted the organics release from the sludge with added PAM and gave higher methane yield than mesophilic AD.     

土壤中7种重金属和砷测定的精密度控制指标研究

通过对浙江省近700组实际土壤样品进行分析,研究了土壤中铜、铅、锌、铬、镍、镉、砷、汞7种重金属和砷测定的精密度控制指标(实验室内相对偏差和实验室间相对偏差),并与行业标准分析方法和文献进行了比较,旨在为环境监测质量控制与质量保证工作提供参考。经统计分析,建议实验室内相对偏差控制指标如下:铜,≤15%;铅,≤15%;锌,≤15%;铬,≤15%;镍,≤15%;镉,≤20%;砷,≤15%;汞,≤50%。建议实验室间相对偏差控制指标如下:铜,≤25%;铅,≤25%;锌,≤20%;铬,≤20%;镍,≤25%;镉,≤35%;砷,≤25%;汞,≤55%。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

绍兴市典型印染废水中重金属锑排放现状及排放源调查

分析和统计的86家印染工业企业当中,废水总排口中的总锑超标率为25.6%,质量浓度0.050 mg/L以下较低排放浓度所占比例最大,达62.8%。印染废水锑排放源主要有涤棉和涤纶化纤类布料的染色、印花工艺废水,碱减量工艺废水等,工业液碱、废酸以及硫酸铝污水处理剂等原料当中含锑浓度较高。印染废水经污水处理厂集中纳管深度处理后,锑排放浓度较低,锑去除效率最高达到88.0%,大大降低了环境地表水体锑污染的风险。     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

厌氧系统中碱处理对污泥减量的影响

碱解预处理污泥和原污泥按一定比例进行混合后,投入厌氧反应器中进行消化,研究其对污泥减量化的影响。结果表明,该处理既可以提高污泥减量率,又能改善污泥厌氧消化性能,提高污泥产气量。当碱处理污泥和原污泥混合比为1∶3时,在混合初期由于稀释作用和水解中和作用,溶液的pH能迅速恢复到中性。SS减少48%,较对照组提高了10%;SCOD减少约80%,较对照组提高20%,而空白对照组因未发生溶胞作用,各参数值均处于较低水平,降解率也维持在较低水平。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺，氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时，在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下，处理后废酸中的氯离子质量浓度为0.22 g/L，氯离子去除率为98.59%，铜离子质量浓度为0.45 g/L，铜离子去除率为95.08%，其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

Full-scale blending treatment of fresh MSWI leachate with municipal wastewater in a wastewater treatment plant

Fresh leachate, generated in municipal solid waste incineration (MSWI) plants, contains various pollutants with extremely high strength organics, which usually requires expensive and complex treatment processes. This study investigated the feasibility of blending treatment of MSWI leachate with municipal wastewater. Fresh MSWI leachate was pretreated by coagulation–flocculation with FeCl₃ 2 g/L and CaO 25 g/L, plate-and-frame filter press, followed by ammonia stripping at pH above 12. After that, blending treatment was carried out in a full-scale municipal wastewater treatment plant (WWTP) for approximately 3 months. Different operational modes consisting of different pretreated leachate and methanol addition levels were tested, and their performances were evaluated. Results showed that throughout the experimental period, monitored parameters in the WWTP effluent, including COD (<60 mg/L), BOD₅ (<20 mg/L), ammonium (<8 mg/L), phosphorus (<1.5 mg/L) and heavy metals, generally complied with the Chinese sewage discharged standard. Under the experimental conditions, a certain amount of methanol was needed to fulfill TN removal. An estimation of the operation cost revealed that the expenditure of blending treatment was much lower than the total costs of respective treatment of MSWI leachate and municipal wastewater. The outcomes indicated that blending treatment could not only improve the treatability of the MSWI leachate, but also reduce the treatment cost of the two different wastewaters.     

南京大气细粒子中重金属污染特征及来源解析

利用2011年1月、4月、7月和10月在南京市区和北郊采集的气溶胶样品，研究了南京大气细粒子中zn、Ph、Hg、As和cd5种重金属的污染水平，通过元素相关性分析和因子分析方法，对细粒子中这些重金属的污染来源进行了初步解析。结果表明，南京大气细粒子及其重金属污染严重，北郊普遍比市区严重；As严重超标，cd在南京北郊超标约5倍，zn在市区与北郊的质量浓度均高于其他重金属元素。每种重金属的浓度均随季节而变化。市区细粒子中，As和zn可能主要与燃煤、轮胎灰尘和建筑扬尘等有关，Pb、Hg和cd主要来自交通尘、城市垃圾焚烧等。北郊细粒子中，As、Hg和zn主要来源于燃煤、钢铁冶炼等工业，Pb和cd主要与农作物秸秆燃烧、汽车尾气、道路扬尘等影响有关。     

重金属Cr(Ⅵ)、Pb及Cu胁迫对双齿围沙蚕体腔细胞的DNA损伤

为探讨重金属Cr(Ⅵ)、Pb以及Cu对沙蚕体腔细胞DNA的毒性效应,以双齿围沙蚕为受试动物,重金属按不同剂量水平,Cr(Ⅵ):10、100和200 mg· L-1,Pb:5、50和100 mg·L-1,Cu:1、10和20 mg· L-1,分别胁迫沙蚕24 h,以不加任何重金属离子的海水为对照,采用单细胞凝胶电泳技术,检测其体腔细胞DNA损伤程度.结果表明,与空白对照组相比,3种重金属离子的各浓度组都能引起沙蚕体腔细胞DNA损伤,且3种重金属胁迫浓度与细胞DNA损伤程度之间存在显著的剂量-效应关系.双齿围沙蚕可以作为单细胞凝胶电泳的实验材料用于重金属所致环境污染的生物监测指示生物.