蜂窝流道热沉强化传热数值模拟

热沉是模拟太空深冷环境的核心部件。为提高空间深冷环境的模拟效果,更好地满足型号试验需求,设计了一种蜂窝流道热沉。利用流体力学理论和有限元方法对蜂窝热沉内部流体的流动和强化传热进行数值模拟,分析流道结构参数对流体流动和换热的影响,确定最优的流道结构参数。结果表明,同等条件下蜂窝热沉表面温度低于管板式热沉5 K左右,温度均匀性可达到±2 K;流道深度和间距是影响流体在热沉中流动与传热的重要因素,合理选择流道结构参数可以提高热沉的换热性能;需要综合考虑传热和阻力问题来确定最优的流道结构参数,最优的蜂窝热沉流道间距为75 mm,深度为10 mm。     

建筑陶瓷碳计量与优化模型研究

采用投入产出分析方法和目标规划方法,以某建陶企业为代表,建立了建筑陶瓷产业投入产出模型及低碳优化模型,利用投入产出模型计量和预估了建筑陶瓷产业关键环节碳排放和产品碳足迹;应用低碳优化模型对建筑陶瓷企业的产品计划进行了低碳优化.结果表明,建筑陶瓷企业年二氧化碳排放量达182 543.9 t,单位产品碳排放量多于国外先进水平10%以上;影响建筑陶瓷产业二氧化碳排放的关键环节为烧成和喷雾干燥过程,烧成和喷雾干燥过程排放的二氧化碳占总排放的80%以上;3种建筑陶瓷产品中,坯砖、抛光砖、釉面砖的万平米产量碳足迹依次为150.2、168.0、159.6 t.建筑陶瓷企业经低碳模型优化后可以在保证同样利润的同时降低5.4%的碳排放,也可以在保证碳排放相同的条件下使利润提高5.6%.     

一种新型电化学法处理硝态氮废水的初步研究

通过对Pd-Me双金属催化还原NO 3--N和折点氯化法处理NH 4+-N的相关理论分析,提出了一种基于电化学法的新型NO 3--N废水处理工艺.即利用具有电子空轨的常见金属元素修饰Ti基获得催化阴极,在电场的作用下,将NO 3--N催化还原;通过调整催化元素的配比和电解条件,控制NO 3--N还原产物主要为NH 4+-N;利用阳极氧化Cl-生成高氧化性物质HOCl,将NH 4+-N氧化为无害产物N2-N.结果表明,金属元素Co和Cu修饰Ti基制得阴极可以有效地催化还原模拟废水中的NO 3--N;按前驱物溶液金属元素摩尔比1∶1制得Ti基Co-Cu复合涂层催化阴极,可以将NO 3--N高效催化还原为NH 4+-N;电解体系中引入Cl-后,通过阳极作用可将NO 3--N还原生产的NH 4+-N有效地氧化为N2-N.在100 mg/L NO 3--N模拟废水中添加1 000 mg/L Cl-,设置极板间距6 mm、电流400 mA,电解2.5 h后出水NO 3--N、NO 2--N、NH 4+-N和TN分别为2.9、0.5、1.7和6.0 mg/L.     

Fe/Al改性膨润土对铬酸根的吸附性能研究

利用膨润土原矿提取了粒径小于2μm的膨润土胶体,经过钠质化处理后分别用聚羟基铁和聚羟基铝进行改性,然后用一次平衡法研究了改性膨润土对水体中铬酸根的吸附性能.结果表明,与原矿相比,改性膨润土对铬酸根的吸附量有了不同程度的提高,铁改性膨润土对铬酸根的吸附量大于铝改性者.CrO42-的吸附平衡浓度为0.5 mmol·L-1时,Mt-1(Fe)、Mt-2(Fe)和Mt-3(Al)对铬酸根的吸附量分别为271.0 mmol·kg-1、114.0 mmol·kg-1和16.1 mmol·kg-1.改性膨润土对铬酸根的吸附量随离子强度的增加而增大,随体系pH值的增加而减小.铬酸根在改性膨润土表面的吸附以专性吸附机制为主,静电吸附所占比例很小,一般不超过30%.这些研究结果可为开发新型水处理剂提供理论指导.     

蜂窝陶瓷催化臭氧化降解水中微量硝基苯的动力学研究

实验表明单独臭氧氧化和臭氧/蜂窝陶瓷氧化在温度20℃、初始pH值6.87条件下对硝基苯的降解均遵循一级反应动力学模型,该条件下单独臭氧氧化和臭氧/蜂窝陶瓷氧化工艺对硝基苯的降解主要来源于高活性羟基自由基的氧化作用,同时证明了不同体系温度（10～40℃）和溶液初始pH值（3.00～10.96）下硝基苯的降解同样符合一级反应动力学.2种工艺对硝基苯的降解反应速率都随着温度的升高而增加,单独臭氧氧化的反应速率常数由0.37×10^-3 s^-1升高到1.49×10^-3 s^-1,臭氧/蜂窝陶瓷氧化的反应速率常数由0.56×10^-3 s^-1升高到2.46×10^-3 s^-1,温度越高反应速率提高的幅度却越小.随着pH的升高,单独臭氧氧化对硝基苯降解的反应速率常数从0.15×10^-3 s^-1增加到2.69×10^-3 s^-1,在pH值3.00～9.23范围内,臭氧/蜂窝陶瓷氧化工艺反应速率常数从0.17×10^-3 s^-1增加到1.90×10^-3 s^-1,在pH为10.96时反应速率常数下降到1.64×10^-3 s^-1.     

有机改性粘土对赤潮藻絮凝沉降的动力学研究

采用分光光度计法和活体荧光计法,研究了吉米奇类表面活性剂双烷基聚氧乙烯基三季铵盐（DPQAC）改性粘土对2种赤潮生物赤潮异弯藻和锥状斯氏藻的絮凝沉降动力学,比较了2种实验方法的不同,并对几种影响絮凝沉降的因素进行了研究.结果表明,传统的分光光度计法进行动力学研究时,有机粘土对赤潮藻的絮凝沉降较好地符合双分子反应动力学模型,而采用活体荧光计法进行实验时,有机粘土对赤潮藻的絮凝沉降很好地符合双曲线动力学模型,利用活体荧光计法进行实验时避免了前者由于粘土沉降导致的体系透光率的快速变化,更好地反映了赤潮藻细胞絮凝沉降实质.2种动力学实验方法都表明,高岭土体系的沉降速率要略高于膨润土体系,提高粘土、改性剂的用量以及体系的pH值都能加快沉降速率,其中提高改性剂的用量是增加去除率和加快沉降速率的最有效方法.     

氯化镧改性黏土固化湖泊底泥中磷的研究

用氯化镧对14种黏土进行改性并研究了这些改性黏土固化磷的效果.研究了pH对改性高岭土磷吸附率和镧离子溶出的影响.结果表明,通过氯化镧改性,不同黏土的磷固定率由改性前的3%～14%提高到改性后的52%～95%.氯化镧改性高岭土在pH为5时,达到磷吸附率的最大值94.85%,并在pH值4～8范围内,保持较高的磷吸附率（>80%）.在pH>6.5的范围,La³⁺溶出浓度低于0.0178 mg/L.     

Modeling of air quality with a modified two-dimensional Eulerian model： A case study in the Pearl River Delta （PRD） region of China

A modified two-dimensional Eulerian air quality model was used to simulate both the gaseous and particulate pollutant concentrations during October 21-24, 2004 in the Pearl River Delta （PRD） region, China. The most significant improvement to the model is the added capability to predict the secondary organic aerosols （SOA） concentrations because of the inclusion of the SOA formation chemistry. The meteorological input data were prepared using the CALMET meteorological model. The concentrations of aerosol-bound species such as NO3^-, NH4^＋, SO4^2-, and SOA were calculated in the fine particle size range （〈2.5 μm）. The results of the two-dimensional model were compared to the measurements at the ground level during the PRD Intensive Monitoring Campaign （IMC）. Overall, there were good agreements between the measured and modeled concentrations of inorganic aerosol components and O3. Both the measured and the modeled results indicated that the maximum hourly O3 concentrations exceeded the China National Air Quality Standard. The predicted 24-h average SOA concentrations were in reasonable agreement with those predicted by the method of minimum OC/EC ratio.     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

Evaluation of adsorption capacities of humic acids extracted from Algerian soil on polyaniline for application to remove pollutants such as Cd(Ⅱ), Zn(Ⅱ) and Ni(Ⅱ) and characterization with cavity microelectrode

The adsorption capacities of new humic acids isolated from Yakouren forest (YHA) and Sahara (Tamenrasset: THA) soils (Algeria) and commercial humic acid (PFHA) on polyaniline emeraldine base (PEB) were studied at pH 6.6. Also the adsorption of heavy metals such as Cd2+, Zn2+ and Ni2+ on humic acid-polyaniline systems (HA-PEB) was investigated at the same conditions. HA-PEB compounds were characterized by scanning electron microscopy (SEM), infrared spectrometry and cavity microelectrode. In addition, batch adsorption and cavity microelectrode were used in the adsorption study of Cd2+, Zn2+ and Ni2+ on HA-PEB. To develop biocaptors of polluting metals using a cavity microelectrode modified by HA-PEB systems, the adsorption kinetic and adsorption capacity were investigated. The SEM analysis showed that the presence of humic acid affected the PEB surface and caused the formation of a granular morphology. The maximum adsorption capacities (qmax) of PFHA, THA and YHA determined by adsorption isotherms were 91.31, 132.1 and 151.0 mg/g, respectively. Batch adsorption results showed that qmax of Cd2+, Zn2+ and Ni2+ on HA-PEB followed the order: THA-PEB > YHA-PEB > PFHA-PEB. The voltammograms obtained with HA-PEB modified cavity microelectrode showed the appearance of new redox couples reflecting the adsorption of HA on PEB. Metal-humic acid-polyaniline voltammograms were characterized by appearance of oxidation-reduction couples or reduction wave corresponding to metal. Finally, the result may be exploited to develop a biocaptor based on the cavity microelectrode amended by THA-PEB and YHA-PEB.