Performance evaluation of reverse logistics enterprise – an agent-based simulation approach

Reverse logistics (RL) has been applied in many industries and sectors since its conception. Unlike forward logistics, retracing consumer goods from the point of consumption to the point of inception is not a well-studied process. It involves many uncertainties such as time, quality and quantity of returns. The returned products can be remanufactured, have parts harvested, or be disposed safely. It is important to implement these activities in a cost-effective manner. The aim of this research is to measure the performance of the RL enterprise with the help of an agent-based simulation model. The major entities in the RL network are considered as Agents that can act independently. There are several different agents: collector agent, sorting-cum-reuse agent, remanufacturing agent, recycler agent, supplier agent and distributor agent. The individual performances of the agents are measured and recommendations are given to improve their performance, leading to the enhancement of the total performance of the RL enterprise. The approach is applied to a case study involving cell phone remanufacturing.     

Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

Recycling-oriented characterization of plastic frames and printed circuit boards from mobile phones by electronic and chemical imaging

This study characterizes the composition of plastic frames and printed circuit boards from end-of-life mobile phones. This knowledge may help define an optimal processing strategy for using these items as potential raw materials. Correct handling of such a waste is essential for its further “sustainable” recovery, especially to maximize the extraction of base, rare and precious metals, minimizing the environmental impact of the entire process chain. A combination of electronic and chemical imaging techniques was thus examined, applied and critically evaluated in order to optimize the processing, through the identification and the topological assessment of the materials of interest and their quantitative distribution. To reach this goal, end-of-life mobile phone derived wastes have been systematically characterized adopting both “traditional” (e.g. scanning electronic microscopy combined with microanalysis and Raman spectroscopy) and innovative (e.g. hyperspectral imaging in short wave infrared field) techniques, with reference to frames and printed circuit boards. Results showed as the combination of both the approaches (i.e. traditional and classical) could dramatically improve recycling strategies set up, as well as final products recovery.     

锆-十六烷基三甲基氯化铵改性活性炭对水中硝酸盐和磷酸盐的吸附特性

采用锆(Zr)和阳离子表面活性剂十六烷基三甲基氯化铵(CTAC)对活性炭进行联合改性,考察了所制备的Zr-CTAC改性活性炭对水中硝酸盐和磷酸盐的吸附去除作用,并探讨了相关的吸附去除机制.结果表明,Zr-CTAC改性活性炭对水中硝酸盐和磷酸盐均具备较好的吸附去除能力.Zr-CTAC改性活性炭对硝酸盐和磷酸盐吸附动力学过程满足准二级动力学模型.Langmuir、Freundlich和Dubinin-Radushkevich(D-R)等温吸附模型可以较好地描述Zr-CTAC改性活性炭对水中硝酸盐的等温吸附过程,Langmuir和D-R等温吸附模型可以较好地描述Zr-CTAC改性活性炭对水中磷酸盐等温吸附过程,通过Langmuir模型计算得到吸附剂对硝酸盐和磷酸盐的最大单位吸附量分别为7.58 mg·g-1和10.9 mg·g-1.高的p H会抑制Zr-CTAC改性活性炭对水中硝酸盐和磷酸盐的吸附.水中共存的Cl-、HCO-3和SO2-4等阴离子均会抑制Zr-CTAC改性活性炭对硝酸盐和磷酸盐的吸附,且对吸附硝酸盐的抑制作用较强而对吸附磷酸盐的抑制作用较弱.水中共存的磷酸盐对Zr-CTAC改性活性炭吸附硝酸盐的抑制作用较强,而水中共存的硝酸盐对Zr-CTAC改性活性炭吸附磷酸盐的抑制作用较弱.1 mol·L-1Na Cl溶液可以使90%左右被吸附到Zr-CTAC改性活性炭表面上的硝酸盐解吸下来.1 mol·L-1的Na OH溶液可以使78%左右被吸附到Zr-CTAC改性活性炭表面上的磷酸盐解吸下来.Zr-CTAC改性活性炭对硝酸盐的吸附机制主要包括阴离子交换作用和静电吸引作用,对磷酸盐的吸附机制主要包括配位体交换作用、阴离子交换作用和静电吸引作用.上述结果说明Zr-CTAC改性活性炭适合作为一种吸附剂去除废水中的硝酸盐和磷酸盐.     

不同运行模式下改良型CAST工艺处理生活污水的除磷性能

实验采用改良型CAST工艺,以生活污水为研究对象,考察了C/P、回流比及温度等不同运行模式对系统除磷性能的影响.结果表明,常温条件下进水C/P由50升至100,系统除磷率均值从15%迅速升至95.6%,除磷性能显著提高;继而降低C/P至75,除磷性能因进水碳源不足再度下降,除磷率均值为51.4%,且长期投加易降解碳源引发系统污泥膨胀并导致污泥大量流失.C/P较低情况下,回流比由25%降低至12.5%,除磷性能提高2.3倍,继续降低回流比至0,除磷性能反而下降;温度实验研究则表明,低温系统(14℃±1℃),除磷率稳定维持在90%以上,而高温短程硝化系统(27℃±1℃)除磷率仅为14.1%,可见低温更有利于系统磷的去除.吸磷小试发现,常温系统污泥以O_2、NO_3~-和NO_2~-为电子受体均能进行吸磷,而低温系统污泥能以O_2、NO_3~-为电子受体进行吸磷,高温系统污泥则仅能以O_2为电子受体进行少量吸磷.此外,实验还发现,系统短期闲置导致的污泥"饥饿"有利于系统除磷率的提高.     

生活垃圾焚烧飞灰固化体力学及重金属浸出特性

以苏州七子山生活垃圾焚烧厂产生的飞灰为研究对象,采用水泥作为固化剂,研究水泥飞灰固化体的应力应变特征及重金属浸出特性,并探讨了水泥飞灰配合比、养护时间等关键性因素对这些特性的影响。实验结果表明:较养护3 d的样品,其余养护时间的样品强度平均增长了约96.2%,而其破坏应变平均减小了56%。随着水泥含量和养护时间的增加,飞灰固化体的强度上升,而其破坏应变减小,该趋势主要归因于钙矾石(AFt)的形成促进了飞灰固化体强度的发展。较飞灰原样,飞灰固化体的重金属浸出浓度随着水泥含量、养护时间的增加而降低了38%~99%,重金属的迁移被限制,主要归因于水化硅酸钙(C—S—H)和钙矾石(AFt)的形成,以及飞灰和水泥水化反应创造的强碱性环境。     

厌氧发酵处理庆大霉素菌渣的可行性及条件优化

采用厌氧发酵处理庆大霉素菌渣,考察了含固率、接种比、接种污泥、发酵底物等因素对庆大霉素菌渣厌氧发酵的影响,并用累积净甲烷产量衡量庆大霉素菌渣进行厌氧发酵的可行性及发酵程度。试验结果证实了庆大霉素菌渣进行厌氧发酵的可行性,其中含固率和接种比对发酵的影响较大,最佳条件为含固率5%,接种比1/3;对比试验所用3种接种污泥,发现接种某造纸厂污水处理IC反应器的厌氧颗粒污泥效果最优,在最优含固率和接种比的条件下,累积净产甲烷量为28.21 m3/t;此外,试验还证实,采用不同菌渣的联合发酵表现出了明显的协同作用,在最优条件下,庆大霉素菌渣与林可霉素菌渣按1∶2的比例联合发酵的产甲烷量可达到37.5 m3/t。     

西安市建筑垃圾渣土资源再利用研究

建筑垃圾渣土作为"建筑副产品",已造成严重的城市环境问题。通过对西安市建筑垃圾渣土的现场调查及工程再利用,借鉴发达国家及国内省市建筑垃圾渣土的成功管理经验和资源再利用的成功范例,提出了西安建筑垃圾资源再利用的对策建议,对"十三五"期间减少已有建筑垃圾的存量并遏制增量和建设西安森林城市具有参考意义。     

运用批实验研究溶解氧对米酒去除硝酸盐的影响

为了判别不同溶解氧条件下脱氮效果和碳的需求量,在水温为25~30℃条件下,设置了缺氧、微氧和有氧3种输入条件,以及C/N分别为2.0、1.5两种碳源投放量开展实验。研究表明:溶解氧的存在对反硝化作用的启动有延迟作用,但影响较小。溶解氧对于反硝化过程并没有产生明显的抑制作用,但在溶解氧较低的情况下,反硝化速率更为理想。缺氧条件下,C/N的适宜值应低于1.5;微氧条件下的C/N适宜值在1.5~2.0;而在有氧条件下C/N=2.0时可高效去除硝酸盐。该研究可为农村地区家庭自行去除饮用水中硝酸盐的实际应用提供参考。     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.