PVDF阳离子交换膜制备进展研究

总结介绍了目前国内外以聚偏氟乙烯(PVDF)材料制备阳离子交换膜的研究动态和最新进展,PVDF阳离子交换膜制备的主要方法为接枝法和共混法,接枝法是在PVDF表面生成自由基增长点,共混制膜法是将PVDF与其它无机纳米颗粒或聚合物共混制得离子交换膜.具体介绍了这两种方法的原理和制备实例.多项研究表明对PVDF材料进行等离子体照射、化学处理、臭氧活化接枝以及与无机纳米颗粒、其它聚合物共混处理等方法可制得性能优异的阳离子交换膜,应用前景广阔.     

微污染水源水中有机物的分布特征及微滤膜对其的影响作用

本试验是在微污染水源水中有机物分布调查的基础上,采用聚偏氟乙烯(PVDF)微滤膜(MF)过滤微污染地表水,考察微滤膜对天然水中有机物的影响作用.试验结果表明,黄浦江微污染水源水中的有机物分子质量主要集中在3~5 k Da和0.2 k Da附近,且疏水性有机物和亲水性有机物所占的比例相当.有机物季节性分布特征明显,冬季溶解性有机碳(DOC)的值偏高,而UV254和比紫外吸光度值(SUVA)则在夏季偏高.黄浦江原水经微滤膜过滤后,有机物构成发生明显变化,膜出水中的亲水性有机物的比例增加,而疏水性有机物的比例降低,DOC和UV254的平均去除率分别为17.73%和15.75%.黄浦江原水及经0.45μm滤膜过滤以去除悬浮物的黄浦江原水分别进行微滤膜过滤,膜比通量的对比发现,在较短时间内两者的膜比通量下降都很明显,而后膜比通量都趋于平缓,变化趋势及结果基本一致,可见,黄浦江水中造成膜通量下降的物质并不是悬浮物,而是溶解性的有机物质.     

Phosphorus-doped graphene supported palladium (Pd/PG) electrocatalyst for the hydrogen evolution reaction in PEM water electrolysis

PEM water electrolysis is one of the most efficient methods for the production of hydrogen because of produced high purity of the gases and environmentally friendly. In the present study, Phosphorus-doped Graphene (PG) was synthesized by thermal annealing of triphenylphosphine (TPP) and graphene oxide (GO). The PG supported palladium (Pd/PG) electrocatalysts were synthesized by chemical reduction method and used as the cathode for hydrogen evolution reaction (HER) electrode. Structural properties and electrochemical performances of the synthesized Pd/PG electrocatalyst were studied by FE-SEM, EDS, ICP, FT-IR, XRD, and Cyclic voltammetry (CV) methods, respectively. The membrane electrode assemblies (MEA’s) were fabricated using Pd/PG as cathode for HER electrode and RuO₂ as anode for OER electrode. Also, their electrochemical performances along with the corresponding hydrogen yields were evaluated in single cell PEM water electrolyzer at various experimental conditions such as different current densities from 0.1 to 2.0 A cm^?2 and temperatures (28–80°C). The synthesized Pd/PG electrocatalyst was observed a current density of 1 A cm^?2 with 1.95 V at 80°C. Further, long-term stability studies were carried out continuously up to 2000 h which showed a reasonable stability. Hence, the synthesized Pd/PG can be used as an alternative to Pt-based electrocatalysts for the HER in PEM water electrolysis.     

A novel method to synthesize polyaluminum chloride with a membrane reactor

Al13 or Alb is usually regarded as the most efficient species of polyaluminum chloride(PAC), the performance flocculant for water treatment. This paper was intended to report a new method to synthesize PAC with high content Alb, by using the membrane reactor. NaOH solutions were managed to permeate slowly through the micropores of ultrafiltration membrane into AlCl3 solutions under the suitable transmembrane pressure(TMP). Meanwhile NaOH drops size was limited to nano-scale, resulting in dramatical reduction of the characteristic diffusion time and great increment of contact interface between the strong base and AI ions in solution to favor the formation of Al(OH)4^-, the precursor of AI,3, so few precipitates and much Alb are produced. When the initial concentration of AlCl3/NaOH is 0.40/2.0 (mol/L), MWCO = 10000, TMP = 0.0085 MPa, T= 305 K and B(molar ratio of OH^-/Al^3 ) = 2.25, the quantity of Alb attains about 80%. The results of ^27Al-NMR determination showed that the Al13 content is equal to Alb content. And our PAC product has shown better flocculation effects than the commercial product.     

Methanation and chemolitrophic nitrogen removal by an anaerobic membrane bioreactor coupled partial nitrification and Anammox

● Efficient carbon methanation and nitrogen removal was achieved in AnMBR-PN/A system. ● AOB outcompeted NOB in PN section by limiting aeration and shortening SRT. ● The moderate residual organic matter of PN section triggered PD in anammox unit. ● AnAOB located at the bottom of UASB played an important role in nitrogen removal. An AnMBR-PN/A system was developed for mainstream sewage treatment. To verify the efficient methanation and subsequent chemolitrophic nitrogen removal, a long-term experiment and analysis of microbial activity were carried out. AnMBR performance was less affected by the change of hydraulic retention time (HRT), which could provide a stable influent for subsequent PN/A units. The COD removal efficiency of AnMBR was > 93% during the experiment, 85.5% of COD could be recovered in form of CH₄. With the HRT of PN/A being shortened from 10 to 6 h, nitrogen removal efficiency (NRE) of PN/A increased from 60.5% to 80.4%, but decreased to 68.8% when the HRT_PN/A further decreased to 4 h. Microbial analysis revealed that the highest specific ammonia oxidation activity (SAOA) and the ratio of SAOA to specific nitrate oxidation activity (SNOA) provide stable NO₂⁻-N/NH₄⁺-N for anammox, and anammox bacteria (mainly identified as Candidatus Brocadia) enriched at the bottom of Anammox-UASB might play an important role in nitrogen removal. In addition, the decrease of COD in Anammox-UASB indicated partial denitrification occurred, which jointly promoted nitrogen removal with anammox.     

无矩阵迭代法在膜结构风振耦合分析中的应用

提出在采用浸入物体法(IOM)对膜结构和空气流体建模时,可以采用带有预定条件的无矩阵Newton-Krylov迭代算法求解浸入物体法,并引入了预定条件矩阵。将提出的无矩阵迭代方法应用于一双坡型膜结构的风振耦合分析中,得出了结构的风压和风速分布,并对带有预定条件和不带预定条件的无矩阵迭代算法进行了对比。结果表明,将带有预定条件的无矩阵迭代算法应用于膜结构风振的耦合分析中,可以得到准确结果,并使计算效率大大提高。     

水与废水处理中的膜生物反应器技术

介绍了膜生物反应器的概念及其用于给水和废水处理的研究发展过程。膜生物反应器包括一体式系统、分离式系统和隔离式系统,并给出８例用于给水和废水处理的膜生物反应器的技术参数及水处理效果数据等。     

膜分离技术治理糠醛废水

糠醛生产废水中含1—2.5％的乙酸,若废水外排,会造成大量损失且污染环境.通过30—80对膜组装的400×800mm电渗析器中试操作,回收了浓度为20％的乙酸,再经萃取、精馏工艺得到工业一级乙酸.治理后的废水含酸量为0.02—0.05％,可安全排放及回用.中试技术指标优于小试,重现良好.     

高浓度合成香料废水的处理工艺研究

采用铁屑内电解-UASB-SBR-膜工艺处理高浓度香料废水,实验结果和工程实践都表明该工艺的处理效果比单纯的UASB和SBR组合工艺好,出水达到了中水回用水质标准,具有较高的应用价值和推广意义.     

臭氧对水稻叶片膜脂过氧化和抗氧化系统的影响

采用 OTC- 1型开顶式气室研究臭氧对不同生育时期水稻叶片膜脂过氧化和抗氧化系统的影响 .实验结果表明 ,随着臭氧浓度增加 ,水稻叶片叶绿素含量、叶绿素 a/b值下降 ,膜相对透性和丙二醛 (MDA)含量上升 ,过氧化物酶 (POD)活性逐渐上升 ,过氧化氢酶 (CAT)、超氧化物歧化酶 (SOD)活性开始被诱导上升 ,当浓度达到 200 nl· L^-1时反而下降 .叶绿素含量及叶绿素a/b值与 MDA含量呈显著负相关 ,膜透性与 MDA含量呈显著正相关 ,叶绿素含量与 POD活性呈负相关 .臭氧造成活性氧的产生和清除之间的失衡 ,加剧了膜脂过氧化作用 ,对水稻的膜系统产生了危害 ,降解叶绿素 ,加速叶片的老化 .