Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

亚甲蓝湿式氧化影响因素研究

以湿式氧化技术对亚甲蓝水溶液进行处理,用水样COD去除率评价处理效果.考察了反应时间、温度、氧分压、搅拌速度、进水pH值以及进水浓度对处理效果的影响,并进行机理分析.实验确定的最佳操作工艺条件为:反应温度210℃、氧分压2.0 MPa、搅拌速度880 r/min、进水pH=11.30.在此条件下,COD为2 000mg/L的亚甲蓝水溶液,反应90min时COD去除率达93.2%.     

水解-接触氧化工艺处理针织染整废水

介绍了采用水解-接触氧化工艺处理针织染整废水,工程运行结果表明：CODcr和色度的去除率分别达到91.3%、88%,最终排放污水达到国家污水Ⅰ级标准.该工艺具有处理效果好、经济、运行稳定等特点,在染整废水处理中具有实用性.     

炼油污水的深度处理

对炼油污水深度处理常用技术——过滤、膜分离、化学氧化技术进行了详细的论述，并结合中试试验，对动态砂滤系统、PAN膜处理系统和高级氧化系统处理炼油厂二级排放水的适用性进行了论证。     

延边地区公路沿线边坡失稳试验分析

延边地区公路沿线分布着大量软岩，其岩性具有强膨胀性，致使这一地区公路边坡出现了多处滑坡现象。为了合理地处理这一工程地质问题，需要认真研究该种软岩的膨胀特性。选取滑坡体软岩为研究对象，定量分析了其自由膨胀率、无荷膨胀率和有荷膨胀率，并具体测定了其膨胀力，探讨了其膨胀率和膨胀力的变化规律，揭示了研究区软岩的膨胀特性，为公路建设中软岩边坡加固参数的选取提供了科学的依据。     

气浮+生物接触氧化工艺处理食品加工废水

通过气浮 生物接触氧化工艺处理速冻食品加工废水的实验、设计和工程运行,结果表明:废水COD去除率能达到97%以上,使得最终出水的COD＜100mg/l.该工艺对冲击负荷有较强的适应性.     

多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

A Parallel Study of SAR Levels in Head Tissues for Three Antennas Used in Cellular Telephones: Monopole, Helix and Patch

Summary This paper is a comparative study of several antennas commonly used in cellular telephones. These include a monopole, a helix-monopole and a patch antenna. Each one of these structures is modeled and numerically tested using finite-difference time-domain simulation and human models based on magnetic-resonance images, which allow for inclusion of details of the human body in the simulation. The testing procedure involves antenna simulation in the proximity of the human head. The behavior of each antenna is evaluated for variable distances from the head geometry (0, 1, 2, 4, 8 and 16 mm). Continuous waveform, representative of the sources used in mobile telephones, (250 mW, 1.8 GHz) is used as the form of the antenna excitation. The simulation outputs used as measures for this comparative study include transmitting and receiving antenna characteristics and the specific absorption rate (SAR). The SAR levels for the head tissues are calculated for and with accordance to the two currently accepted standards: Federal Communications Commission (FCC) and International Commission on Non-Ionizing Radiation Protection (ICNIRP). The computed SAR levels within each of the considered tissues vary for the three antennas under investigation and are within the determined health safety standards. Results suggest that the patch antenna may be the structure of choice when considering safety standards, as its radiation yields the lowest local SAR in the head tissues.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.