非离子表面活性剂对污泥调理脱水效果的影响

现有污泥脱水技术仅使污泥含水率降到80%左右,难以满足日益严格的污泥处置要求.以污泥比阻（SRF）、脱水率为考察指标,比较了两大类非离子型表面活性剂（辛基酚聚氧乙烯醚OPEO型和烷基糖苷APG）对剩余污泥的脱水效果,并对原泥及调理后污泥进行了显微观察.结果表明,非离子表面活性剂可使污泥絮体粒径变小,不规则程度降低,改善了污泥的脱水性能,而且烷基糖苷APG脱水效果优于OPEO型.APG投加量为0.05%干固体时,污泥比阻即可降低到原泥的42%,脱水率可达到93%.以烷基糖苷APG为调理剂进行板框脱水实验,结果表明,当APG投加量为0.05%干固体时,脱水泥饼含水率比原泥脱水泥饼含水率低约10%,脱水率可达到97%.本研究为APG应用于污泥脱水,改善污泥脱水性能提供一些参考.     

微压流化式复合生物反应器处理含酚废水效能的研究

通过连续动态试验,对新型微压流化式复合生物反应器(MP-FHBR)处理模拟苯酚废水的效能进行研究.结果表明,MP-FHBR的COD容积负荷可达4.86kg/(m3·d)、苯酚容积负荷可达1.96kg/(m3·d),出水COD低于200mg/L、出水苯酚浓度低于1mg/L,COD和苯酚去除率分别达到90%和99%以上.当苯酚容积负荷达到2.04kg/(m3·d),苯酚在反应器中逐渐累积,反应器内微生物的TTC-比脱氢酶活性下降.当MP-FHBR进水苯酚浓度为800mg/L时,最佳水力停留时间为9～10h.水力负荷对反应器沉淀池的泥水分离效果影响较大,限制了反应器的进水量,所以MP-FHBR主要适用于处理较高浓度的含酚废水.     

Oxidation inhibition of sulfite in dual alkali FGD system

A laboratory-scale well-mixed thermostatic reactor with continuously blasting air was used to investigate the oxidation inhibition of sulfite in dual alkali flue gas desulfurization （FGD） system. The effects of operating parameters such as pH value and catalyst concentration on the oxidation were studied. Sodium thiosulfate was used in the system, and was found that it significantly inhabited the sulfite oxidation. In the absence of catalyst, sodium thiosulfate at 12.67 mmol/L had an inhibition efficiency of approximately 98%. While in the presence of catalyst, sodium thiosulfate at 26.72 mmol/L had an inhibition efficiency less than 85.0%. The oxidation reaction order of sulfite in the sodium thiosulfate was determined to be -1.90 and 4）.55 in the absence and presence of the catalyst, respectively. Apparent activation energy of oxidation inhibition was calculated to be 53.9 kJ/mol. Pilot tests showed that the consumption rate of thiosulfate agreed well with the laboratory-scale experimental results.     

强化供氧条件下潜流型人工湿地运行特性

针对潜流型人工湿地中溶解氧浓度和脱氮率偏低的问题,试验研究了强化供氧对植物和微生物的影响及人工湿地内溶解氧浓度、净化效率的变化规律.结果表明,强化供氧宜在湿地前端进行,最佳气水比为6左右,可采用连续供氧方式.供氧对湿地植物生理特性无明显不良影响,可显著增加湿地中硝化菌、反硝化菌数量,硝化菌可比供氧前高出1～2个数量级,反硝化菌高出1个数量级.强化供氧有效改善了湿地内氧环境,供氧前湿地内溶氧浓度普遍低于0.6 mg/L,供氧后氧浓度上升至1 mg/L以上.强化供氧有利于各类污染物质尤其是有机物和氮类物质的去除,有机物去除率比原湿地高出10％左右, TN去除率能够达到60％以上.因此,强化充氧措施具有较好的研究和应用价值.     

Vertical and temporal distribution of nitrogen and phosphorus and relationship with their influencing factors in aquatic-terrestrial ecotone： a case study in Taihu Lake, China

Vertical and temporal distributions of N and P in soil solution in aquatic-terrestrial ecotone （ATE） of Taihu Lake were investigated, and the relations among N, P, ORP （oxidation reduction potential）, TOC, root system biomass and microorganism were studied. As a whole, significant declines in TN, NO3^--N, DON （dissolved organic nitrogen） and TP concentration in soil solution have occurred with increase of the depth, and reached their minima at 60 cm depth, except for NH4^＋-N, which increased with depth. The concentration of TP increased gradually from spring to winter in the topsoil, the maximum 0.08 mg/L presented in the winter while the minimum 0.03 mg/L in spring. In the deeper layer, the concentration value of TP fluctuated little. As for the NO3^--N, its seasonal variation was significant at 20 cm depth, its concentration increased gradually from spring to autumn, and decreased markedly in winter. Vertical and temporal distribution of DON is contrary to that of NO3^--N. The results also show that the variation of N and P in the percolate between adjacent layers is obviously different. The vertical variation ofTN, TP, NO3^--N, NH4^＋-N and DON is significant, of which the variation coefficient of NO3^--N along the depth reaches 100.23%, the highest; while the variation coefficient of DON is 41.14%, the smallest. The results of correlation analysis show that the concentration of nitrogen and phosphorus correlate significantly with TOC, ORP, root biomass and counts of nitrifying bacteria. Most nutrients altered much from 20 to 40 cm along the depth. However, DON changed more between 60 and 80 cm. Results show that soil of 0-60 cm depth is active rhizoplane, with strong capability to remove the nitrogen and phosphorus in ATE. It may suggest that there exists the optimum ecological efficiency in the depth of above 60 cm in reed wetland. This will be very significant for ecological restoration and reestablishment.     

Effects of nitrate concentration in interstitial water on the bioremediation of simulated oil-polluted shorelines

Nutrient addition has been proved to be an effective strategy to enhance oil biodegradation in marine shorelines.To determine the optimal range of nutrient concentrations in the bioremediation of oil-polluted beaches,nitrate was added to the simulated shoreline models in the initial concentration of 1,5 and 10 mg/L.Whenever the NO3-N concentration declined to 70% of its original value, additional nutrients were supplemented to maintain a certain range.Results showed adding nutrients increased the oil biodegradation level,the counts of petroleum degrading bacteria(PDB)and heterotrophic bacteria (HB),and the promoted efficiency varied depending on the concentration of nitrate.Oil degradation level in 5 mg/L(NO_3-N)group reached as much as 84.3% accompanied with the consistently highest counts of PDB;while in 1 mg/L group oil removal efficiency was only 35.2%,and the numbers of PDB and HB were relatively low compared to the other groups supplemented with nutrients.Although counts of HB in the 10 mg/L group were remarkable,lower counts of PDB resulted in poorer oil removal efficiency (70.5%) compared to 5 mg/L group.Furthermore,it would need more NO_3-N(0.371 mg)to degrade 1 mg diesel oil in the 10 mg/L group than in the 5 mg/L group(0.197 mg).In conclusion, Nitrate concentration in 5 mg/L is superior to 1 and 10 mg/L in the enhancement of diesel oil biodegradation in simulated shorelines.     

企业风险管理与经营效率：来自中国保险业的经验证据

本文从风险管理的视角对企业效率评估的数据包络分析技术进行了改进,探讨了风险管理与经营效率的内在关联,并以中国保险业为例,对1999年以来企业真实的经营效率水平进行了评估。结果表明：企业内部的风险管理能力对其经营效率水平的提升具有明显的影响,而且这种影响力正在逐渐加强。不考虑企业内部的风险管理水平将直接导致其经营效率的测算结果出现低估,2002年以后这种低估的程度越发明显,这可归因于同期保险企业开始逐渐重视提高自身的风险管理能力。以上结论也为企业如何在管控风险的同时提升经营效率水平提供了有价值的指导。     

Sustainability issues in sheet metal forming processes: an overview

Environmental sustainability in manufacturing is nowadays an urgent and remarkable issue and the main concerns are related to more efficient use of materials and energy.In sheet metal forming processes there is still a lack of knowledge in this field mainly due to the need of a proper modelling of sustainability issues and factors to be taken into account. The aim of this paper is mainly to underline the state of the art from a forming point of view about the sustainability contributions offered in any phase of a product life cycle. Actually, a lack in terms of comprehensive contributions is present in the technical literature, thus, the authors try to give a sort of holistic vision aimed to provide basic guidelines in order to help in identifying the possible solutions with regard to all the phases of a forming product life cycle. The main attention was paid to sheet metal forming technologies. The paper gives an overview of the main topics concerning sheet metal forming problems related to energy and resource efficiency with the aim to stress the principal contributions which may derive from such processes to environmental performances of manufacturing.     

The potential for improvements in energy efficiency and CO2 emissions in the EU27 cement industry and the relationship with the capital budgeting decision criteria

This paper performs a cost-effectiveness analysis of some of the best available technologies (BAT) that can contribute to decreasing the energy consumption and CO₂ emissions in the European Union’s (EU27) cement industry. Several capital budgeting decision criteria have been used (the payback period, the net present value and the internal rate of return) to study whether or not an investment should be considered worthwhile. The results show that, independent of the capital budgeting decision criteria used, the number of cost-effective retrofitting possibilities available is large compared to the rate of improvements that the industry undertakes annually. This shows the insensitivity of the industry to financial criteria when it comes to making their investment decisions. The possible thermal energy improvement in the clinker production, if all these BATs were implemented, has been quantified to be around 10%. This achievement would place the cement industry in the upper bound of the benchmark range for clinker manufacture. However considering the delays observed nowadays in terms of diffusion of BATs in the cement industry, it requires a conducive policy environment that combines support for both technology development and to their deployment.     

基于DEA模型的区域生态环境建设绩效评价——以江苏省苏州市为例

选取生态系统服务价值、生态绿当量、人均生态足迹赤字和环境质量综合指数作为区域生态环境质量表征指标,借助DEA模型对区域生态环境建设过程中劳动力投入、资金投入、技术投入和资源投入的绩效进行评价,结果表明:(1)苏州市10年来生态环境建设总体而言绩效良好,DEA有效年份占30%,弱有效年份占20%,无效年份占50%,并且无效年份的效率指数都在0.97以上;(2)导致苏州市最近5年生态环境建设DEA无效的原因主要是乔资源投入不足,生态用地成为区域生态环境建设刚性约束;(3)通过调整生态环境建设要素投入比例,各种生态环境指标值都将有所提高,区域生态环境质量也将显著改善;(4)地区生态环境建设绩效下降还受地区人口数量增加、人均生态占用增长、生态环境累积效应影响.最后从促进区域社会经济与生态环境协调发展的角度提出相关建议.