硫酸盐生物还原过程中涉硫组分代谢特性

通过硫酸盐生化代谢过程中涉硫组分（SO42-、SO32-、H2S、S2-、S2O32-、微生物含硫）等代谢特性模式研究,揭示了代谢过程中的主要限速步骤及过程代谢产物演替规律。SRB还原过程中限速步骤主要为亚硫酸根转化为硫化氢的过程,利用氮气吹脱硫化氢后,反应终点时各涉硫组分占总硫的51.38%,硫离子的量增加了2.09倍,硫酸根的去除率从83.5%提高到91.24%,亚硫酸根浓度呈现出降低的趋势;pH明显上升,并最终达到8.31,而无吹脱硫化氢的反应器最终pH为6.87。反应器中脱硫弧菌为优势菌,硫化氢被吹脱后,微生物在目、科、属水平上优势菌得到提高,硫化氢的存在抑制了优势菌的增殖。     

氯化铁和硫酸铁对酸性土壤中有效态镉和铅污染的修复作用

采用浸泡实验法研究了氯化铁和硫酸铁对酸性土壤中有效态镉和铅污染的修复效果,结果表明,氯化铁和硫酸铁均能有效去除土壤有效态镉和铅污染,Fe(Ⅲ)用量为50~100 mmol/kg时,有效态Cd和Pb的去除效果可达70%~96%。氯化铁和硫酸铁能去除土壤中的水溶态、碳酸盐结合态、腐殖酸结合态、铁锰氧化物结合态和强有机结合态Cd和Pb及交换态Cd。氯化铁和硫酸铁对Cd均既有洗脱修复作用又有固定修复作用,且洗脱修复作用的贡献稍大;氯化铁用量较小时(50 mmol/kg)对Pb既有固定修复又有洗脱修复作用,固定修复作用稍大;用量较大时(100 mmol /kg),对Pb只有洗脱修复作用。硫酸铁对Pb的修复作用则以固定修复作用为主,洗脱修复作用很小。     

载体内微孔孔径对生物膜特性及废水处理效果的影响

为解决载体內部微孔孔径在废水生物膜法中缺乏选型依据的问题,采用5种孔径(0.6~4 mm)聚氨酯海绵生物载体构建了SBBR,考察了载体内微孔孔径对生物膜特性(MLSS、EPS、DHA)及废水处理效果的影响,分析了载体内部微孔孔径与生物膜特性的相关性。结果表明：载体内微孔孔径与MLVSS、MLSS呈显著负相关,而与PN、PS、EPS和f呈显著正相关;高生物量使小孔径载体(0.6 mm,1 mm)在反应器运行前中期拥有最佳的废水处理效果,同时过多的生物膜在微孔环境中会堵塞内部的通道和空穴,进而抑制传质,使生物膜活性(DHA、f )降低;而大孔径载体(4 mm)内部传质快、水力剪切作用强,加速生物膜解吸脱落速率,促进了生物膜活性的提高与EPS(主要是TB-EPS)的释放,但同样限制了生物膜量的增长。相较而言,中等孔径载体(2 mm,3 mm)适宜的微孔不仅能维持适量的微生物量,还能保持良好的生物膜结构和活性,为生物膜反应器提供良好的长期运行条件和处理效果。     

剩余污泥发酵液对黏性膨胀污泥特性的影响

为了解决剩余污泥碱性发酵液作为低碳氮比生活污水外加碳源时引发的黏性污泥膨胀问题,采用序批式反应器(SBR),以剩余污泥碱性发酵液为进水碳源,对黏性膨胀污泥的沉降性能及其影响因素之间的相关性进行了系统研究。结果表明：当进水COD值为300~350 mg·L⁻¹时,随着运行时间的推移,污泥容积指数(SVI)逐渐升高,最终达到540 mL·g⁻¹,此时发生污泥黏性膨胀现象;黏性膨胀污泥表面负电荷由0.62 mV累积到29.49 mV,相对疏水性(RH)从44%下降至19%,污泥容积指数(SVI)与Zeta电位、相对疏水性(RH)呈负相关(R²分别为0.837 71和0.678 54),与污泥粒径不相关;胞外聚合物总量从31 mg·g⁻¹提高至39 mg·g⁻¹,但LB-EPS/TB-EPS的比例从0.92增加至2.92;与TB-EPS相比较,LB-EPS与污泥容积指数(SVI)、Zeta电位、相对疏水性(RH)具有显著相关性(R²分别为0.892 88、0.885 29和0.776 68)。以上结果揭示了以发酵液为碳源引发的黏性膨胀污泥特性的变化规律,可为实际工程中以发酵液为碳源的黏性污泥膨胀问题提供借鉴。     

Mitigating Impact of Devils Lake Flooding on the Sheyenne River Sulfate Concentration

Devils Lake is a terminal lake located in northeast North Dakota. Because of its glacial origin and accumulated salts from evaporation, the lake has a high concentration of sulfate compared to the surrounding water bodies. From 1993 to 2011, Devils Lake water levels rose by ~10 m, which flooded surrounding communities and increased the chance of an overspill to the Sheyenne River. To control the flooding, the State of North Dakota constructed two outlets to pump the lake water to the river. However, the pumped water has raised concerns about of water quality degradation and potential flooding risk of the Sheyenne River. To investigate these perceived impacts, a Soil and Water Assessment Tool (SWAT) model was developed for the Sheyenne River and it was linked to a coupled SWAT and CE‐QUAL‐W2 model that was developed for Devils Lake in a previous study. While the current outlet schedule has attempted to maintain the total river discharge within the confines of a two‐year flood (36 m³/s), our simulation from 2012 to 2018 revealed that the diversion increased the Sheyenne River sulfate concentration from an average of 125 to >750 mg/L. Furthermore, a conceptual optimization model was developed with a goal of better preserving the water quality of the Sheyenne River while effectively mitigating the flooding of Devils Lake. The optimal solution provides a “win–win” outlet management that maintains the efficiency of the outlets while reducing the Sheyenne River sulfate concentration to ≤600 mg/L.     

Experimental study on the effect of fly ash content in cemented paste backfill on its anti-sulfate erosion

ABSTRACT

In order to study the effect of fly ash content in cemented paste backfill (CPB) on its anti-sulfate erosion, the apparent phenomenon, strength development, and hydration products change the law of CPB with different fly ash content under long-term soaking of 5% sodium sulfate solution were studied by the macrotest and microanalysis, in addition, the mechanism of CPB anti-sulfate attack was analyzed by combining with a scanning electron microscope (SEM). The results indicated that the effect of sulfate environment on the strength of fly ash cemented paste backfill (FCPB) was mainly determined by the hydration products in the FCPB at different soaking times. In the early soaking stage, the formation of ettringite (AFt) in FCPB could improve its compactness, which was conducive to improving the strength of FCPB. In the late soaking stage, there were ettringite-type erosion damage and gypsum erosion-type damage internal of the FCPB with low content fly ash, resulting in microfracture, cracking of the FCPB, and reducing the strength. CPB with an appropriate content of fly ash could improve the internal structure of the FCPB to achieve the purpose of anti-sulfate erosion.     

The prediction of adsorption isotherms of ester vapors on hypercrosslinked polymeric adsorbent

Adsorption isotherms of methyl acetate, ethyl acetate, propyl acetate, isopropyl acetate and ethyl propionate on hypercrosslinked polymeric resin (ND- 100) were measured at 303K, 318K and 333K,respectively, and well fitted by Dubinin–Astakhov (DA) equation. The plots of the adsorbed volume (q _v ) versus the adsorption potential (ε) at three different temperatures all fell basically onto one single curve for every ester. A predicted model based on DA equation was obtained on the basis of adsorption equilibrium data of methyl acetate, ethyl acetate and ethyl propionate at 318K. The model equation successfully predicted the adsorption isotherms of methyl acetate, ethyl acetate and ethyl propionate on ND-100 at 303K, and 333K, and also gave accurate predictive results for adsorption isotherms of the other two ester compounds (propyl acetate and isopropyl acetate) on ND-100 at 303K, 318K and 333K. The results proved the effectiveness of DA model for predicting the adsorption isotherms of ester compounds onto ND-100. In addition, the relationship between physico-chemical properties of adsorbates and their adsorption properties was also investigated. The results showed that molecular weight, molar volume and molar polarizability had good linear correlations with the parameter E (which represents adsorption characteristic energy) of DA equation.     

Effect of biocides on the precipitation of calcium fluoride in the presence of anionic copolymeric inhibitors

The inhibitory efficiency of anionic copolymers and the effect of the biocides sodium hypochlorite, glutaraldehyde, and tris(hydroxymethyl)nitromethane on the precipitation behavior of calcium fluoride (CaF₂) were studied. The efficiency of polymeric inhibitors was traced from conductivity measurements by using half-life (t_1/2) method. X-ray diffraction parameters have been measured for calcium fluoride scale minerals. An anionic copolymer (K-798) acts as one of the best inhibitors for the precipitation process of the calcium fluoride in water as compared to K-775. It is assigned to the fact that the copolymer (K-798) contains both sulfonic acid and sulfonated styrene groups while the polymer (K-775) having only the sulfonic acid group. It was further observed that the biocides have no appreciable effect on the performance of the anionic polymeric inhibitors.     

硫酸法钛白生产水洗工序清洁生产技术初探

通过开展水洗工段用水审计并试验了温度、偏钛酸ξ电位和漂白工艺对水洗的影响效果，从实践和理论上探讨了为其提高钛白质量改进水洗工艺的清洁生产方案的可行性和合理性。     

亚铵制浆黑液非无菌操作连续发酵生产酵母

从土壤中筛选出能在亚铵黑液中生长的毕赤酵母菌株（Ｐｉｃｈｉａ ｓｐ．Ｎｏ．１）经耐毒驯化后，可接种于酸析脱木素和汽提脱毒后的亚铵黑液中，在非无菌操作条件下连续发酵生产酵母菌体，该菌生产迅速，连续培养衡释率达０．２６ｈ＾－１，总糖的酵母得率为０．４８ｇ／ｇ（ＴＳ），ＣＯＤ去除２３％，菌体易絮凝，可自然沉降分离。