TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

改性膨润土处理污水处理厂二级出水的实验研究

研究基于再生水回灌地下、补充地下水水源的目的,使用河南信阳某膨润土厂生产的钠基膨润土,通过酸改性、铝柱撑改性和微波-硫酸亚铁改性制得三种改性膨润土,用于处理城市污水处理厂的二级出水.实验结果显示,经XRD衍射分析可知,三种方法制备的改性膨润土,其矿物结构都有不同程度上的变化,膨润土层间距都较膨润土原矿有所增大,可见其改...     

Removal of polycyclic aromatic hydrocarbons from aqueous solution by raw and modified plant residue materials as biosorbents

Removal of polycyclic aromatic hydrocarbons （PAHs）, e.g., naphthalene, acenaphthene, phenanthrene and pyrene, from aqueous solution by raw and modified plant residues was investigated to develop low cost biosorbents for organic pollutant abatement. Bamboo wood, pine wood, pine needles and pine bark were selected as plant residues, and acid hydrolysis was used as an easily modification method. The raw and modified biosorbents were characterized by elemental analysis, Fourier transform infrared spectroscopy and scanning electron microscopy. The sorption isotherms of PAHs to raw biosorbents were apparently linear, and were dominated by a partitioning process. In comparison, the isotherms of the hydrolyzed biosorbents displayed nonlinearity, which was controlled by partitioning and the specific interaction mechanism. The sorpfion kinetic curves of PAHs to the raw and modified plant residues fit well with the pseudo second-order kinetics model. The sorption rates were faster for the raw biosorbents than the corresponding hydrolyzed biosorbents, which was attributed to the latter having more condensed domains （i.e., exposed aromatic core）. By the consumption of the amorphous cellulose component under acid hydrolysis, the sorption capability of the hydrolyzed biosorbents was notably enhanced, i.e., 6-18 fold for phenanthrene, 6-8 fold for naphthalene and pyrene and 5-8 fold for acenaphthene. The sorpfion coefficients （Kd） were negatively correlated with the polarity index [（O＋N）/C], and positively correlated with the aromaticity of the biosorbents. For a given biosorbent, a positive linear correlation between logKoc and logKow for different PAHs was observed. Interestingly, the linear plots of logKoc-logKow were parallel for different biosorbents. These observations suggest that the raw and modified plant residues have great potential as biosorbents to remove PAHs from wastewater.     

论水处理工程中的节能

人们在污水处理厂的建设中对污水处理工艺的先进性、可靠性以及工程投资大小考虑较多,而对污水处理厂建成后的运营管理考虑较少,因而造成许多污水处理厂建成后由于运营成本过高而不能正常运行。从能耗角度出发,分析造成运行成本高的主要原因以及相应采取的措施。     

Microstructure of 2205 duplex stainless steel joint in submerged arc welding by post weld heat treatment

The 2205 duplex stainless steel (DSS) is of both good properties austenitic steel and ferritic steel, which applies to the shipbuilding industry usually. In this paper, the OM, XRD and microhardness test methods are used to analyze the variation of submerged arc welded (SAW) joints with and without post weld heat treatment (PWHT). The research results show that the σ phase disappear in the fusion edge zone near heat affect zone (HAZ) and an increase in the welded center zone during the follow-up PWHT, while the amount of γ phase is decreased in the welded center zone with PWHT. A segregation distribution of some second phases is also found in the welded center zone after PWHT. There have two pick values of microhardness arise in the fusion edge zone and the welded center zone separately without PWHT. However, a maximum value of microhardness at the fusion edge zone near HAZ is disappeared and the other is still held at the welded center zone during PWHT. It can be attributed to the changes of second phases, element diffusions and particle segregation during PWHT. A developing mechanism is issued to demonstrate the second phases transferring of the 2205 DSS SAW joints by PWHT.     

桑树(Morus alba)幼苗对铅污染的生理耐性和积累能力的性别差异

以桑树(Morus alba)雌雄幼苗为实验材料,研究了施铅处理对其生长发育、生理过程和铅元素积累的影响,以揭示桑树幼苗对铅污染的生理耐性和积累能力的性别差异.结果表明:施铅后桑树雌雄幼苗的可溶性蛋白(Pr)含量和超氧化物歧化酶(SOD)活性显著增加,雄株增幅略高于雌株,而丙二醛(MDA)含量和相对电导率无显著变化;雌雄幼苗的净光合速率(Pn)、气孔导度(Gs)和蒸腾速率(Tr)显著增加,雄株比雌株具有更高的Pn和Tr;雌雄幼苗的叶绿素a、叶绿素b、总叶绿素及叶绿素相对含量显著增加,雄株增幅高于雌株;雌雄幼苗的形态生长与地上部生物量显著增加,根冠比显著降低,而雄株比雌株具有更高的株高、基径和总叶片数;铅在植物体内的分布为根叶茎,雄株根、叶中的铅含量和转移系数略高于雌株.综上,灌施剂量为800 mg·kg-1的铅离子对桑树雄株幼苗生长的促进作用高于雌株,雄株比雌株具有更强的生理耐性和积累能力.     

碱改性净水污泥对水中氨氮的吸附效能研究

采用氢氧化钠浸渍法改性净水污泥,研究了碱改性净水污泥对水中NH+4的去除性能.同时,考察了模拟废水pH、吸附剂投加量、NH+4初始浓度、吸附温度及吸附时间对吸附性能的影响.结果表明,当pH为弱酸性或中性,投加碱改性净水污泥20 g·L-1时,在室温下对初始浓度为50 mg·L-1的NH+4模拟废水振荡吸附120 min,可达到氨氮排放二级标准.将实验数据分别用吸附等温模型和动力学模型进行拟合,发现净水污泥对NH+4的吸附符合Langmuir模型和二级动力学模型,且净水污泥对氨氮的吸附包括静电吸引和离子交换两种作用机理.     

某麦芽生产厂废水管理与处理实践研究

麦芽生产过程包括清选、浸麦、发芽、烘干以及除根等工序,废水主要来自于浸麦、发芽等工序。某麦芽生产厂根据麦芽过程用水和废水产生的特点,采用设备改进、加强工艺管理、用水管理、废水回用、提高员工技能等措施,通过源头削减和生产全过程控制,合理调节生产用水,降低生产用水量和废水产生量,麦芽生产水耗指标为2.4 m3水/吨麦芽。麦芽废水采用SBR工艺进行处理,出水水质满足排放标准要求。该麦芽企业废水管理和处理经验为同行业提供了较好的案例。     

电化学法处理工业废水的现状与发展研究

随着工业的快速发展,如何对工业废水进行高效处理是我们需要解决的问题。电化学方法反应装置简单,反应效率高,不会产生二次污染。对中国工业废水目前常用的电化学处理技术的进展和应用进行了综述,包括电化学氧化、电化学还原、电絮凝、电渗析等内容,对国内外的研究成果的总结可知,电化学法对工业废水的处理效率较高,有一定的应用前景。同时对电化学法将来的重点研究方向提出了展望。     

壳聚糖絮凝机理及絮凝性能的影响因素分析

壳聚糖是一种天然高分子聚合物,被广泛地作为絮凝剂用于水处理过程。探讨了壳聚糖的三种絮凝机理。在水处理中,其絮凝性能的发挥受到pH值、壳聚糖的投加量、壳聚糖的分子量以及壳聚糖的脱乙酰度等因素的影响。