LEAD AND CADMIUM ASSOCIATED WITH SALTWATER INTRUSION IN A NEW JERSEY AQUIFER SYSTEM1

ABSTRACT: The U.S. Geological Survey collected ground-water samples from the upper and middle aquifers of the Potomac-Raritan-Magothy aquifer system in a 400-square-mile area of New Jersey from 1984 through 1986. Concentrations of lead were greater than the U.S. Environmental Protection Agency maximum contaminant level (MCL) of 50 micrograms per liter in water from 16 of 239 wells. The cencentrations of cadmium were greater than the MCL of 10 micrograms per liter in water from 10 to 241 wells. One-half of the wells that exceeded the lead MCL were in known areas of saltwater intrusion, as were all 10 wells that exceeded the cadmium MCL. The association of elevated concentrations of these metals with elevated concentrations of chloride indicates a mochanism related to saltwater intrusion.     

DISTRIBUTION AND GRAIN-SIZE PARTITIONING OF METALS IN BOVFOM SEDIMENTS OF AN EXPERIMENTALLY ACIDIFIED WISCONSIN LAKE1

ABSTRACT: A study of concentrations and distribution of major and trace elements in surficial bottom sediments of Little Rock Lake in northern Wisconsin included examination of spatial variation and grain-size effects. No significant differences with respect to metal distribution in sediments were observed between the two basins of the lake, despite the experimental acidification of one of the basins from pH 6.1 to 4.6. The concentrations of most elements in the lake sediments were generally similar to soil concentrations in the area and were well below sediment quality criteria. Two exceptions were lead and zinc, whose concentrations in July 1990 exceeded the criteria of 50 μg/g and 100 μg/g, respectively, in both littoral and pelagic sediments. Concentrations of some elements, particularly Cu, Pb, and Zn, increased along transects from nearshore to midlake, following a similar gradient of sedimentary organic carbon. In contrast, Mn, Fe, and alkali/alkaline-earth elements were at maximum concentrations in nearshore sediments. These elements are less likely to partition to organic particles, and their distribution is more dependent on mineralogical composition, grain size, and other factors. Element concentrations varied among different sediment grain-size fractions, although a simple inverse relation to grain size was not observed. Fe, Mn, Pb, and Zn were more concentrated in a grain-size range 20–60 tm than in either the very fine or the coarse fractions, possibly because of the aggregation of smaller particles cemented together by organic and Fe/Mn hydrous-oxide coatings.     

Trace elements in camel tissues from a semi-arid region

Trace and minor element concentrations differ in animal tissues as the result of the surrounding environment (feeding plants, soil contaminated with food and drinking water) and animal absorption of these elements. Concentrations of Ag, Au, Ca, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, and Zn were determined from different tissues of camel (inter-costal, scapula, sirloin, flank, front knuckle and front limb) from the semi-arid areas of the Aswan desert (Wadi El-Allaqi) and from Aswan city, Egypt. The study included an assessment of these same elements in the desert and city plants used as food by the camels and in soils from the study areas. The results reveal that camel tissues from the desert areas exhibited higher concentrations of Na, Mg, K, Au, Ag, Cu, Co and Zn than in those of the city camels. These higher levels of element are because of the high concentrations of the same elements in the desert plants and soil of the desert area. This, in turn, depends upon the geological formation differences between the desert area and the city area. Camel tissues appear to concentrate high levels of Mn, Ni, Co and Mg in the scapula while flank portions concentrate high levels of Mg and K. The levels of elements in the camel tissues under study were within the recommended safety baseline levels for camel health and human use, as well as within the appropriate limits in the desert and city plants for camel use.     

我国化学工业的“三废”及其资源化

文章在介绍我国化学工业排放三废的严峻现状后,阐述了通过工艺改造和综合回收途径来推进三废资源化的技术对策,以及从宏观和微观上看深化三废资源化的意义和光明前景。     

USE OF X-RAY FLUORESCENCE TO DETERMINE TRACE METALS IN WATER RESOURCES1

ABSTRACT. The X-ray fluorescence method was used to analyze trace metals collected in particulate form on filter papers and from the ionic state by ion exchange filter papers. The samples were prepared by allowing water to pass through these filter papers. The procedures necessary for using the X-ray fluorescence method are described. A number of samples were taken from the Great Miami River in Dayton, Ohio over one year showing the presence of the following metals, Ca, Ti, Cr, Fe, Cu, Zn, Sr, and Cd. Elements in the periodic table between Ti and Cs were detectable to a sensitivity limit of the order of 30 ppb for metals in the particulate form and 0.4 ppm for metals in the ionic form.     

MANGANESE IN LACUSTRINE ECOSYSTEMS: A REVIEW1

This paper serves as a literature review of manganese in fresh water. The major aspects of manganese occurrence discussed are: (1) sources, (2) geochemistry, (3) manganese-iron relationships, (4) effects on the fauna and flora and (5) detection.     

Distribution of Trace Metals in the Surface Sediments of Two Pristine Subalpine Lakes in Taiwan

Sediment cores were collected from two remote subalpine lakes: the rather shallow (1.5 m) Little Ghost Lake at 2040 m elevation and the deeper, Great Ghost Lake (40 m) at 2150 m elevation. Different early diagenesis of metals were observed. the seasonally anoxic hypolimnion drives the annual iron redox cycle and causes the remobilization of metals in the mobile fractions of sediments in the Great Ghost Lake. These result in the redistribution of metals in the mobile fractions of sediment and poor correlation between metal concentrations. in the Little Ghost Lake, the shallow water column is always oxic with less change of metals in the mobile fractions of sediments. As a result, most metals have strong positive correlations with each other.

The distributions of metal/Al ratios, total metal contents and acid-leached metal concentrations in the near-surface sediments of these two lakes suggest that the anthropogenic inputs from the atmospheric fallouts in recent decades are one of the major factors affecting the distributions of metals such as cadmium, lead and, to a lessor extent, zinc. the Pb-206/Pb-207 ratios confirm the anthropogenic lead input in these surface sediments.     

混合气体爆炸性MFC图形分析

判断混合气体爆炸性常用 3种方法 ,即科瓦德爆炸三角形法、美国矿业局采用的爆炸三角形计算法和最小助燃氧浓度法 ,然而如何准确、快速、形象地得到分析结果在防灾救灾中是十分关键的。笔者的重点是提供一个图形分析方法解决上述问题。VC ++是方法的基本理论依据 ,用一个实例来验证方法的有效性。总之 ,研究表明 :图形分析法可提高安全管理效率。     

耐候钢中微量元素的测定

本文分别用化学法和电感耦合等离子体发射光谱法(ICP-AES)测定了Corten-B和Sten3两种耐候钢中Cr、Cu、Mn、Sb、Si、V、P、Ti等8种微量元素的含量,并与传统的化学法进行了对比.试验证明ICP-AES光谱法不但技术简便、快速、易于推广应用,而且ICP-AES光谱法和微波消解技术联用在微量元素测量上有更准确、安全等方面的优点.另外,ICP-AES仅通过对少量样屑的一次溶样即可得到全部元素的分析结果,节省了钢样,这对于难以取样的情况尤为有利.     

天然气钻井井口安全距离研究分析

分析天然气钻井井场可能发生的事故类型及事故的破坏程度,选择适合的事故后果模型,对天然气井井喷失控后可能发生的蒸气云爆炸及硫化氢扩散的后果进行量化分析,根据超压-冲量准则、热剂量准则和硫化氢扩散行为规律,计算出爆炸波、爆炸火球及硫化氢扩散的危害范围。笔者建立了天然气钻井井口安全距离的计算模型,并提出一种确定安全距离的方法。通过计算给出不同无阻流量、不同硫化氢体积含量的20种条件下的天然气钻井井口安全距离,并应用该模型对某含硫气井井口安全距离进行了计算。实例表明,该方法具备实用性,值得在天然气井选址规划中推广和使用。