铁屑去除酸法地浸采铀地下水中硝酸盐的试验研究

在酸法地浸采铀过程中,硝酸及硝酸盐的广泛使用使硝酸盐在地下不断累积并扩散到地下水中,这给矿区地下水造成了一定程度的污染.本试验以铁屑为还原剂,对该地下水中NO3--N的去除进行了批试验和动态试验研究.试验结果表明,铁屑可有效去除地下水中的NO3--N,其去除率随pH值的降低而逐渐升高;溶液中共存的Ca2 、Mg2 对NO3--N的去除影响不大,而SO42-、HCO3-的存在可明显降低NO3--N去除率;铁屑最佳投加量为120 g/L,铁炭最佳体积比为1∶1;二级柱可以明显提高柱子的稳定运行时间,在55 h内NO3--N去除率可保持在93%以上,去除效果较好.     

Transparent exopolymer particles (TEPs)-associated protobiofilm: A neglected contributor to biofouling during membrane filtration

• Bacteria could easily and quickly attached onto TEP to form protobiofilms. • TEP-protobiofilm facilitate the transport of bacteria to membrane surface. • More significant flux decline was observed in the presence of TEP-protobiofilms. • Membrane fouling shows higher sensitivity to protobiofilm not to bacteria level. Transparent exopolymer particles (TEPs) are a class of transparent gel-like polysaccharides, which have been widely detected in almost every kind of feed water to membrane systems, including freshwater, seawater and wastewater. Although TEP have been thought to be related to the membrane fouling, little information is currently available for their influential mechanisms and the pertinence to biofouling development. The present study, thus, aims to explore the impact of TEPs on biofouling development during ultrafiltration. TEP samples were inoculated with bacteria for several hours before filtration and the formation of “protobiofilm” (pre-colonized TEP by bacteria) was examined and its influence on biofouling was determined. It was observed that the bacteria can easily and quickly attach onto TEPs and form protobiofilms. Ultrafiltration experiments further revealed that TEP-protobiofilms served as carriers which facilitated and accelerated transport of bacteria to membrane surface, leading to rapid development of biofouling on the ultrafiltration membrane surfaces. Moreover, compared to the feed water containing independent bacteria and TEPs, more flux decline was observed with TEP-protobiofilms. Consequently, it appeared from this study that TEP-protobiofilms play a vital role in the development of membrane biofouling, but unfortunately, this phenomenon has been often overlooked in the literature. Obviously, these findings in turn may also challenge the current understanding of organic fouling and biofouling as membrane fouling caused by TEP-protobiofilm is a combination of both. It is expected that this study might promote further research in general membrane fouling mechanisms and the development of an effective mitigation strategy.     

Characteristics and mixing state of S-rich particles in haze episodes in Beijing

Direct individual analysis using Scanning Electron Microscopy combined with online observation was conducted to examine the S-rich particles in PM_2.5 of two typical polluted haze episodes in summer and winter from 2014 to 2015 in Beijing. Four major types of S-rich particles, including secondary CaSO₄ particles (mainly observed in summer), S-rich mineral particles (SRM), S-rich water droplets (SRW) and (C, O, S)-rich particles (COS) were identified.We found the different typical morphologies and element distributions of S-rich particles and considered that (C, O, S)-rich particles had two major mixing states in different seasons. On the basis of the S-rich particles’ relative abundances, S concentrations and their relationships with PM_2.5 as well as the seasonal comparison, we revealed that the S-participated formation degrees of SRM and SRW would enhance with increasing PM_2.5 concentration. Moreover, C-rich matter and sulfate had seasonally different but significant impacts on the formation of COS.

Open image in new window

     

基于PMF模式的南京市大气细颗粒物源解析

为研究南京市大气细颗粒物(PM2.5)污染来源,分别在3个点位、4个季节开展了PM2.5环境样品的采集,共获得170个有效样本.对样本进行了化学成分分析,包括Al、Fe、Na、Mg、K、Ba、Li、Tl、Mn、Co、Ni、Cu、Zn、Sb、Pb、Cr、Ce、Na+、NH4+、Mg2+、Ca2+、SO42-、NO3-、Cl-、以及OC、EC,共计26种.首先采用OC/EC最小比值法估算出二次有机气溶胶(SOA)的含量;然后利用正矩阵因子分解法(PMF)对PM2.5的非SOA部分进行来源解析,共解析出6类因子:二次无机气溶胶(SIA)、燃煤、机动车排放、地面扬尘、冶金和其它源,贡献率分别25.0%、23.5%、20.4%、17.1%、3.0%和11.0%;最后基于南京市SO2、NOx、VOCs三种主要前体污染物的排放量,分别对SIA和SOA在一次来源中进行再分配.最终结果表明,南京市PM2.5主要来源为燃煤、机动车、扬尘、工业和其它源,其贡献率分别为29.6%、22.4%、14.6%、18.7%和14.7%.     

黄山大气气溶胶新粒子生长特性观测分析

利用2012年9月22日~10月28日黄山地区大气气溶胶、二氧化硫和臭氧观测数据,结合气象数据,分析气溶胶新粒子的生成-增长特征.分析发现,在33个有效观测日中,有新粒子生成-增长的观测日占总数的18.2%,其中晴天的发生频率为37.5%,新粒子生成-增长都开始于晴天上午,与无新粒子观测日相比,太阳辐射量、风速、SO2及O3浓度较高,环境温度和相对湿度较低.气溶胶新粒子的增长具有由小及大的特点,核模态气溶胶粒子(10~20nm)数浓度最先增加,爱根核模态粒子(20~50nm)数浓度随着时间推移逐渐增大,但浓度峰值依次下降,平均增长率为3.58nm/h. SO2浓度先于核模态气溶胶数浓度到达峰值,其氧化后的产物H2SO4为新粒子的核化提供前体物,并且参与新粒子的增长过程,当SO2浓度较低时,不会发生新粒子生长事件.     

Optimizing synthesis conditions of nanoscale zero-valent iron (nZVI) through aqueous reactivity assessment

Nanoscale iron particles (nZVI) is one of the most important engineered nanomaterials applied to environmental pollution control and abatement. Although a multitude of synthesis approaches have been proposed, a facile method to screen the reactivity of candidate nZVI materials produced using different methods or under varying synthesis conditions has yet been established. In this study, four reaction parameters were adjusted in the preparation of borohydride-reduced nZVI. The reductive properties of the resultant nanoparticles were assayed independently using two model aqueous contaminants, Cu(II) and nitrate. The results confirm that the reductive reactivity of nZVI is most sensitive to the initial concentration of iron precursor, borohydride feed rate, and the loading ratio of borohydride to ferric ion during particle synthesis. Solution mixing speed, in contrast, carries a relative small weight on the reactivity of nZVI. The two probing reactions (i.e., Cu(II) and nitrate reduction) are able to generate consistent and quantitative inference about the mass-normalized surface activity of nZVI. However, the nitrate assay is valid in dilute aqueous solutions only (50 mg·L⁻¹ or lower) due to accelerated deactivation of iron surface at elevated nitrate concentrations. Additional insights including the structural and chemical makeup of nZVI can be garnered from Cu(II) reduction assessments. The reactivity assays investigated in this study can facilitate screening of candidate materials or optimization of nZVI production parameters, which complement some of the more sophisticated but less chemically specific material characterization methods used in the nZVI research.     

蒸汽相变促进可溶PM2.5凝结增长的数值分析

为利用蒸汽相变原理促进氨法脱硫系统排放细颗粒物(PM2.5)的脱除,建立多分散颗粒的凝结增长动力学模型,利用数值模拟方法研究了可溶硫酸铵颗粒的凝结增长规律,并将典型粒径可溶与不可溶颗粒的凝结增长过程进行对比分析.结果表明:不同粒径硫酸铵颗粒的增长速率相近,等温系统的凝结增长效果优于绝热系统;对于同一初始粒径分布下的可溶和不可溶颗粒,微米尺度可溶颗粒的增长速率始终大于不可溶颗粒,亚微米尺度可溶颗粒的增长速率先大于而后小于不可溶颗粒,使得二者的增长曲线存在一个交叉点;蒸汽饱和度增大能显著促进硫酸铵颗粒的增长;等温系统中温度对硫酸铵颗粒的增长影响显著,绝热系统中温度的影响较弱.     

Experimental investigation into the oxidation reactivity, morphology and graphitization of soot particles from diesel/n-octanol mixtures

Aiming to investigate the impacts of n-octanol addition on the oxidation reactivity, morphology and graphitization of diesel exhaust particles, soot samples were collected from a four-cylinder turbocharged diesel engine fueled with D100（neat diesel fuel）, DO15（85% diesel and 15% n-octanol, V/V） and DO30（70% diesel and 30% n-octanol, V/V）. All tests were conducted at two engine speeds of 1370 and 2150 r/min under a fixed torque of 125 N ·m. The soot properties were characterized by thermogravimet...     

大气颗粒物吸湿性研究

大气颗粒物吸湿性是反映颗粒物理化性质的重要指标,吸湿性研究对深入了解颗粒物的环境和健康效应具有重要意义. 总结了国外近年来大气颗粒物吸湿性研究进展:①典型的大气颗粒物吸湿性分析方法为H-TDMA(吸湿性串联差分电迁移率粒径分析仪)系统及其优化方法. ②大气颗粒物吸湿性呈单峰、双峰甚至多峰分布;根据G_f(吸湿性生长因子)随粒径变化的模式,可将大气颗粒物分为强吸湿性和弱吸湿性2类,也可分为纯不溶性、混合不溶性、混合可溶性和纯可溶性4类. ③城市背景点颗粒物的G_f比城市观测点高;城市观测点的颗粒物G_f分布呈夏季高、冬季低,白天高、晚上低的特征. ④颗粒物吸湿性与其化学组成和形态密切相关,纯可溶性盐颗粒物的G_f通常较高. ⑤柴油燃烧源新排放的颗粒物属于弱吸湿性颗粒物,G_f非常小,但在其表面老化后或随燃料中硫含量的增加G_f会明显变大. ⑥生物质燃烧排放颗粒物的G_f相对较高,但存在区域差异性. 针对国内大气颗粒物吸湿性研究现状,提出了未来重点研究方向.      

Transport of Sewage Sludge in a Mixed Water Column

Abstract

Sewage sludge from four publicly-owned treatment works was sampled and characterized in terms of parameters affecting transport at the 106-mile deep ocean disposal site as part of the US Environmental Protection Agency's site monitoring programme. Samples from treatment plants in Passaic Valley, Rahway, and Elizabeth, New Jersey and New York City were characterized in terms of dynamic size distribution, suspended solids and density. the transport characteristics of sludge particles were measured using a 2 metre computer-interfaced laboratory settling column. Experiments were conducted at constant salinity (35 ppt) while varying hydrodynamic mixing, sludge type and concentration using a modified factorial experimental design. Hydrodynamic power dissipation was varied so that the vertical dispersion and rms fluid shear rate ranged between 0-6 cm²S^?1 and 0-30s^?1 respectively. Results indicate that at least 80% of suspended sludge particles will eventually settle under mixed conditions. the average settling velocities ranged between 0.05-4.05 × 10^-3 cm ^s-1. Shear rates above 15 s^?1 inhibited sludge settling due to aggregate breakup and boundary effects, but at a lower shear rate, differential settling and fluid shear were the dominant transport mechanisms. Sludge dilution (1/500-1/5000) had a limited effect on the settling rate. Results from this study can be used to calibrate particle transport models to determine the fate of sludge disposed at an ocean disposal site.