二元联合作用藻红外测试方法——以重金属为例

为检验二元联合作用藻红外测试方法的可行性,用Cu~(2+)、Fe3+、Mn~(2+)、Al3+、Cr3+、Hg~(2+)、Cd~(2+)、Pb~(2+)、Zn~(2+)进行了二元联合作用测试实验。结果显示:联合药液的参照浓度与单药液的参照浓度比为0.5:0.25的有15组二元组合,为2.0:1.0的有10组二元组合,为1.0:0.5的有11组二元组合;在9种重金属的36组二元联合作用测试结果中出现拮抗作用、相加作用、协同作用,表明联合作用类型表现出多样性;14组拮抗作用中单组的再现性为50%~100%、多组的再现性的出现率为93%、单组的重现性为67%~100%、多组的重现性的出现率为100%,21组相加作用中单组的再现性为50%~100%、多组的再现性的出现率为86%、单组的重现性为67%~100%、多组的重现性的出现率为100%,1组协同作用重现性67%;36组联合作用测试结果的再现性为50%~100%、再现性的出现率为86%,重现性为67%~100%、重现性的出现率为100%。上述分析可知,9种重金属的36种二元联合作用测试结果具有较好的多样性、再现性、重现性,表明测试条件、藻温测试方法、三指标评价法能够保证藻响应温差和藻响应药品评价结果的质量,参照浓度分析方法、联合作用评价方法能够控制联合作用分析结果的质量;藻响应的有毒有害物都存在敏感浓度,用参照浓度分析方法可分析出藻响应有毒有害物的参照浓度。因此,藻红外测试技术可以用于测试重金属、农药、有机药品、抗生素等的二元联合作用。     

Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

Have government regulations improved workplace safety? : A test of the asynchronous regulatory effects in China's coal industry, 1995-2006

Problem

Empirical studies on the effectiveness of workplace safety regulations are inconclusive. This study hypothesizes that the asynchronous effects of safety regulations occur because regulations need time to become effective. Safety regulations will work initially by reducing the most serious accidents, and later by improving overall safety performance.

Method

The hypothesis is tested by studying a provincial level aggregate panel dataset for China's coal industry using two different models with different sets of dependent variables: a fixed-effects model on mortality rate, which is defined as fatalities per 1,000 employees; and a negative binominal model on the annual number (frequency) of disastrous accidents.

Results

Safety regulations can reduce the frequency of disastrous accidents, but have not reduced mortality rate, which represents overall safety performance.

Discussion and summary

Policy recommendations are made, including shifting production from small to large mines through industrial consolidation, improving the safety performance of large mines, addressing consequences of decentralization, and facilitating the implementation of regulations through carrying on institutional actions and supporting legislation.

Impact on industry

Until recently, about 4,000 coal miners perished annually in China, demonstrating that workplace safety in China's coal industry is an urgent and important issue. This research provides evidence that safety regulations have asynchronous effects and identifies the priorities in improving safety in China's current coal mining. This may assist the Chinese government to design more effective safety improvement policies and improve the effectiveness of safety regulations and safety performance.     

Improving inverse model fitting in trees—Anisotropy,multiplicative effects,and Bayes estimation

Model fitting for individual-based effects in forests has some problems. Because samples measuring the separate influence of each individual are rarely available, the measured value in the sample represents the influence of all surrounding individual trees. Therefore, it is helpful to build inverse models that use the spatial pattern of the variable as well as that of the source trees. For example, since seed dispersal is influenced by wind effects, a model is discussed describing anisotropic effects to ensure an unbiased estimate of the total fruit number. Further, we present a model describing the absorption of radiation by trees. In this case a multiplicative combination of individual effects yields the total effect. Our approach uses logarithmic transformations of the original data to model multiplicative combinations as sum of transformed single effects. For fitting model parameters we propose an approach based on Bayesian statistics, to ensure ecologically interpretable parameters.     

酸性洗涤塔-生物滤塔-生物曝气池组合工艺处理恶臭气体NH3和H2S

采用酸性洗涤塔、生物滤塔和生物曝气池的组合工艺处理NH3、H2S恶臭混合气体,研究表明,该组合工艺对NH3和H2S有很好的去除效果,在进气流量为35 L/min,喷淋量45 L/h时,NH3进气浓度50.15~525.4 mg/m3,H2S进气浓度10.23~110.36 mg/m3时,NH3单一进气去除率稳定在99%以上,H2S单一进气去除率90%以上。混合进气后,NH3去除率几乎为100%,H2S的去除率提高至98%以上。在一定的浓度范围内,NH3和H2S之间的相互作用对两者的去除效果没有明显的影响,而且起到了相互促进降解的作用。同时,进气流量和填料层高度都会影响NH3、H2S的去除率。系统对进气容积负荷变化的缓冲能力强,在偶尔超负荷条件下运行并不能使系统崩溃,并且微生物对高负荷逐渐表现出适应性。大部分溶于水的氨由生物曝气池去除,去除率达到96.9%。     

Enhancement of UV and chromate mutagenesis by nickel ions in the Chinese hamster HGPRT Assay †

1. The HGPRT (Hypoxanthine‐Guanine‐Phospho‐Ribosyl‐Transferase) assay with Chinese Hamster V79 cells was used to measure the mutagenic effects of UV irradiation, potassium dichromate and nickel chloride. The agents were tested separately and in the combinations of UV plus nickel and dichromate plus nickel.

2. UV, Cr(VI) and Ni(II) were confirmed to be mutagenic in the V79 cell assay. The combination of UV(5J/m²) and Ni(II) (0.5 mM) caused a mutation rate 11.2 times above that corresponding to the sum of the individual mutation rates of these agents. The combined action of Cr(VI) (0.1 mM) and Ni(II) (0.5 mM) produced a mutation rate 2.8 fold above that corresponding to the sum of the individual rates of the separate agents.

3. The enhancing effect of nickel chloride on the mutagenicity of UV or Cr(VI) is interpreted by an interference of Ni(II) with the repair of DNA lesions.     

生物法-人工湿地组合工艺处理小城镇混合污水研究

为适应小城镇污水处理高效、低耗、管理简单的要求,开展了生物法(水解酸化/生物接触氧化)-人工湿地组合工艺(A/BCO-CW)处理小城镇片区混合污水的研究。结果表明,A/BCO系统在停留时间为3～6 h条件下,对悬浮物和有机物有高的去除效率,COD、BOD5和TSS去除率分别达到63.1%、67.7%和66.2%,避免了人工湿地堵塞和提高处理效率,减少了所需湿地面积44%。全年运行结果表明,在0.30～0.59 m/d水力负荷率下,垂直流-表面流-水平潜流人工湿地组合系统对COD、BOD5和TSS平均去除负荷达9.4、5.1和7.2 g/(m2.d)(42%、71.2%和85.2%);COD、BOD5去除速率常数为74.6±12.1 m/y、166±30.5 m/y,这些数值均处于文献中k值范围的高量程内。A/BCO-人工湿地系统对COD、BOD5和TSS具有好的处理效果,出水水质能够稳定达到《地表水环境质量标准》(GB 3838-2002)的IV类水标准,2种处理方法有效组合起来,所开发的低成本、高效率、可持续运行的城镇废水处理组合系统,将会在实际应用尤其是高有机负荷污水处理中发挥良好效用。     

生产部门提高能源效率的宏观能耗回弹分析

提高能源效率已成为我国节能减排政策的重点,但是由于经济系统内在的调整机制作用,在宏观层面所能实现的节能效果可能不及微观技术层面能源效率提高的程度,甚至还会诱发更多的能源消耗,该现象被称为“宏观能耗回弹”效应.本文通过构建一个中国环境资源CGE模型,测算生产部门提高能源效率的宏观能耗回弹效应.结果显示,能源效率提高5％后,短期回弹效应为52.38％,节能效果仅达到技术层面预期的一半左右；长期回弹效应达178.61％,在高耗能部门竞争力提高、耗能产品出口扩张和经济增长的推动下,节能效果不但被完全抵消,总能耗还进一步增加.因此,生产部门提高能源效率在短期内确实能够降低我国能源消耗,但是由于回弹效应的存在,长期来看,在技术层面“产量相同投入更少”的努力反映到宏观经济层面则转变成“生产更多投入更多”,并且加剧了我国经济高耗能的偏好,提高能源效率所引发的产出增长和结构调整对能耗增加的刺激作用可能最终会抵消或者超过提高能源效率的节能效果.     

微波强化Fenton/活性炭工艺处理制药废水的影响因素

为了研究微波强化Fenton/活性炭工艺处理高浓度制药废水的影响因素,以阜新某集团公司生产制药原料排出的废水为研究对象,利用静态实验,采用混凝-微波强化Fenton/活性炭工艺对高浓度制药废水进行实验。实验用水为100 mL、COD为576~1 440 mg/L的制药废水,当活性炭投加量为2 g,H2O2投加量为3/4Qth,pH值为5,微波辐照功率和时间分别为500 W和7 min时,COD去除率可达到92.6%,出水COD在42.6~106.6 mg/L范围内。实验结果表明,活性炭的投加量、H2O2的投加量、pH值、微波辐照功率和辐照时间对微波强化Fenton/活性炭工艺的处理效果影响都较显著。