汽油储罐火灾爆炸事故定量安全评价方法简析

以某化工企业汽油储罐为例,针对储罐可能发生的火灾爆炸事故,采用道化学危险指数法和池火灾伤害数学模型分析两种评价方法进行定量评价,对两种评价方法的评价结果进行了对比、分析.     

新型L沸石在FCC汽油加氢脱硫催化剂中的应用研究

采用等体积浸渍法,制备了一系列含有相同含量活性组分(MoO3、CoO和NiO)不同USL沸石含量的加氢脱硫催化剂。通过X-射线衍射(XRD)、氮气吸附脱附、吡啶红外(Py-FTIR)和氨气程序升温脱附(NH3-TPD)等分析方法对样品进行了表征。结果表明:与Cat.0(参比剂,仅以γ-Al2O3为载体)相比,添加USL沸石催化剂所得加氢油的烯烃含量、芳烃含量和研究法辛烷值(RON)均增加;仅当催化剂载体中USL沸石加量在0~40m%之间变化时,加氢油的异构烷烃含量呈上升趋势;而当载体中USL沸石添加量在0~20m%之间变化时,催化剂的脱硫率有所升高。综合对比,当载体中USL沸石添加量约为40m%,催化剂具有最佳的综合性能指标,脱硫率达90%,RON损失仅为1.5左右。     

缸内直喷汽油车颗粒物化学组分特征

随着缸内直喷汽油车（GDI）的大量使用,其尾气颗粒物排放问题日益凸显.研究缸内直喷汽油车尾气颗粒物构成组分是有效控制其颗粒物排放的重要前期工作之一.选取了5辆满足国六排放标准的缸内直喷汽油车进行了尾气颗粒物碳质成分、水溶性离子和多环芳烃（PAHs）组分分析.结果发现,各类碳质是测试车辆尾气颗粒物中的主要成分,平均占比约70%.颗粒物碳质中有机碳质（OC）多于核态碳质（EC）,OC/EC比值在1.03~3.43之间.测量了颗粒物中多种水溶性离子的含量,结果表明Ca²⁺和SO₄^2-是尾气颗粒物中的主要水溶性离子,主要来源均为机油添加剂.此外,结果还发现GDI车辆尾气颗粒物中高环PAHs排放占比较高,对人体健康危害大,需要重点关注.     

Assessment of using unleaded fuel in the harsh environment of the United Arab Emirates

The service life of lubricating oil produced in the United Arab Emirates (UAE) was examined using a car fueled with leaded or unleaded gasoline of the same grade in harsh local conditions. In addition, the economic impact of using leaded vs. unleaded gasoline via the effects on the useful life of engine oil was investigated. Every 500 km that the car was operated, the physical properties of the oil were examined to determine the optimum oil life before replacement. It was found that relative to unleaded gasoline, leaded gasoline resulted in a faster deterioration of lube oil properties and a reduced useful life of the oil. Many of the effects of use on the physical properties of oil became apparent from the beginning of its service, especially when leaded gasoline was used. Our findings indicate that the recommended useful life of oil when using leaded gasoline is 2500 km. With unleaded gasoline, deterioration of the physical properties of the lubricating oil became a concern after 3000 km. Thus with unleaded gasoline, it is recommended to have an oil change every 3500 km. These findings indicate that the decision of the UAE government to stop using lead compound additives to improve the octane number of gasoline will not only protect the environment from the harmful effects of lead compounds, but will also extend the useful life of oil. This extension will reduce the amount of used oil that is disposed of by up to 4678 tons/year. This reduction in oil use translates to a cost savings of about 23.4 million UAE Dirhams (=$6.37 million US Dollars) per year.     

浅谈加油加气站的防雷防静电安全检测

本文根据相关技术标准和多年来对加油加气站的防雷防静电安全检测经验，总结归纳了加油加气站防雷防静电安全检测技术要点，针对检测准备工作、检测程序、检测项目、检测要求及方法、检测数据的整理及有关注意事项等分别进行了阐述。     

加油VOCs排放因子测试方法研究与应用

加油站VOCs排放是北京市VOCs的主要来源之一,中国、美国环保署、欧洲环境署加油环节的未控制排放因子(UEF)分别是加州空气资源委员会(CARB)加油UEF(1 008 mg·L-1)的2.16、1.31和1.00倍,中国20年来汽油标准发生了变化,急需开展加油VOCs排放因子本地化研究.本研究对比发现欧盟加油排放因子测试方法比CARB简单易操作,借鉴欧盟方法加工了加油VOCs排放因子测试装置,并在北京市某加油站的美国加油油气回收系统(StageⅡ)开展加油VOCs排放因子测试.结果表明:1针对试验油箱,冬夏季加油油气回收效率分别是气液比(A/L)的0.93和0.83倍,夏季加油排放因子大于冬季,且回收效率小于冬季;2针对社会车辆,A/L=0时冬夏季加油UEF分别为(525±42)mg·L-1和(963±174)mg·L-1,分别是CARB加油UEF的0.52倍和0.95倍,冬夏季在A/L为1.05~1.07时的排放因子平均值分别为(55±30)mg·L-1和(112±108)mg·L-1;3选取无油气回收时社会车辆加油UEF作为北京市冬夏季加油UEF,结合试验油箱建立的冬夏季排放因子与A/L的线性方程,计算有油气回收时不同A/L的排放因子.     

汽油轿车NEDC循环超细颗粒物排放特性

以一辆采用电控燃油进气道多点喷射系统的桑塔纳汽油轿车为试验样车,采用排气颗粒数量及粒径分析仪EEPS,对该车NEDC循环的超细颗粒排放数量及颗粒粒径分布特性进行了试验研究.结果表明,NEDC循环中,车辆加速时排放的核模态颗粒、聚集态颗粒数量浓度均增加;车辆启动后40 s及EUDC循环高速工况（≥90 km.h-1）排放的超细颗粒数量浓度较高;NEDC循环的颗粒数量排放呈单峰对数分布,颗粒数量排放峰值的颗粒粒径集中于10～30 nm,几何平均粒径为24 nm;ECEⅠ、ECEⅡ～Ⅳ和EUDC循环,加速、减速、怠速及匀速驾驶工况的颗粒数量排放基本上呈单峰对数分布,颗粒数量排放峰值的颗粒粒径主要集中于10～30 nm,几何平均粒径集中于14～42 nm.该汽油车NEDC循环排放的超细颗粒主要以粒径小于50 nm的核模态颗粒为主.     

长径比对管道油气爆炸特性与火焰传播规律影响研究*

为了探究长径比对油气爆炸传播特性与火焰传播规律的影响，为复杂管道受限空间油气爆炸防控提供理论参考，结合油气爆炸与爆炸抑制工程实际需要，构建不同长径比管道油气爆炸模拟实验系统,在此基础上开展不同初始浓度的预混油气-空气混合气爆炸实验。研究结果表明:管道内部的预混油气爆炸超压信号呈先上升后下降的趋势，由于耗散以及憋压效应导致超压下降平稳后仍大于初始压力；同时长径比增加会导致达到最大爆炸超压的油气浓度增加，油气爆炸超压峰值随着长径比的增加呈现上升→下降→上升的规律，小长径比管道的油气爆炸超压峰值高于大长径比管道，但同为小长径比管道或大长径比管道工况的实验结果对比显示爆炸超压峰值随着长径比增加而提升；而超压上升速率则会随着长径比的增加而上升；长径比的增加同时也会促进火焰的加速传播并减小火焰持续时间。     

车用乙醇汽油静电起电特性试验研究

为研究乙醇汽油使用过程中存在的静电风险及带电变化规律,基于自主研发的油品电荷密度表,试验研究了乙醇含量对管输汽油静电带电规律的影响,获得乙醇体积含量0~5%的管输油品静电数据;对油库内乙醇汽油装车作业及加油站加油作业乙醇汽油静电起电特性进行了试验研究。研究结果表明:随着乙醇含量的增加,油品静电呈现先增大后减小的趋势;乙醇体积含量在0.5%~1%时,油品静电起电量最高可达到-77.2 μC/m3,为此需注意乙醇汽油调配过程中可能存在的静电风险;高电导率的车用乙醇汽油在加油作业时,油品静电起电量较低。     

Effects of ambient temperature on regulated gaseous and particulate emissions from gasoline-, E10- and M15-fueled vehicles

• Emissions from two sedans were tested with gasoline, E10 and M15 at 30°C and -7°C. • As the temperature decreased, the PM, PN and BC emissions increased with all fuels. • Particulate emissions with E10 and M15 were more sensitive to the temperature. • The PN and BC generated during cold start-up dominated those over the WLTC. Ambient temperature has substantial impacts on vehicle emissions, but the impacts may differ between traditional and alcohol gasolines. The objective of this study was to investigate the effects of temperature on gaseous and particulate emissions with both traditional and alcohol gasoline. Regulated gaseous, particle mass (PM), particle number (PN) and black carbon (BC) emissions from typical passenger vehicles were separately quantified with gasoline, E10 (10% ethanol and 90% gasoline by volume) and M15 (15% methanol and 85% gasoline by volume) at both 30°C and -7°C. The particulate emissions with all fuels increased significantly with decreased temperature. The PM emissions with E10 were only 48.0%–50.7% of those with gasoline at 30°C but increased to 59.2%-79.4% at -7°C. The PM emissions with M15 were comparable to those with gasoline at 30°C, but at -7°C, the average PM emissions were higher than those with gasoline. The variation trend of PN emissions was similar to that of PM emissions with changes in the fuel and temperature. At 30°C, the BC emissions were lower with E10 and M15 than with gasoline in most cases, but E10 and M15 might emit more BC than gasoline at -7°C, especially M15. The results of the transient PN and BC emission rates show that particulate emissions were dominated mainly by those emitted during the cold-start moment. Overall, the particulate emissions with E10 and M15 were more easily affected by ambient temperature, and the advantages of E10 and M15 in controlling particulate emissions declined as the ambient temperature decreased.