污泥厌氧消化预处理技术综述

全球环境问题已成为国际社会关注的焦点,围绕全球气候变化,降低温室气体排放,寻求再生能源,节能减排已成为目前国际科技发展的方向。通过"十一五"污水处理厂的建设,每年污泥产量已接近3000万吨(含水率80%脱水污泥计)以上,且以每年10%的速度递增。其处理与处置是制约社会经济发展的重要问题。但是,城市污泥蕴含有大量生物质能,通过借鉴国外先进技术与经验,开发城市污泥生物质能提取和利用技术,对我国节能减排具有重要战略意义。由于细胞壁的存在,使得污泥水解成为限制厌氧消化效率的重要瓶颈,而污泥强化预处理可有效提高污泥细胞壁的破坏,溶出胞内有机物,最大化回收剩余污泥中的有机能源。目前,预处理技术较多,如超声波预处理、热处理、微波预处理、碱解处理、臭氧预处理等,本文从物理、化学等角度分析了不同预处理对厌氧消化技术的影响。     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水，研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下，处理后出水的浊度、色度和COD去除率分别为98.59%，97.62%，86.21%。处理后出水澄清透明，COD为50.34mg/L，满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。     

Microwave extraction of incurred salinomycin from chicken tissues

Abstract

A rapid, accurate, environmentally friendly and cost‐effective microwave extraction technique was developed for the extraction of spiked and incurred salmomycin from chicken tissues (kidney, liver, muscle, ovarian yolk and fat). Extraction of salinomycin from various tissues was achieved by irradiating the sample in absolute ethanol and 2‐propanol (15+2) for 9 sec. in a common household microwave oven. The extract was analysed without further cleanup by HPLC on a C₁₈ column (5 μm) and detected at 592 nm via post‐column reaction with 4‐dimethylaminobenzaldehyde (DMABA) in a heated reactor coil at 86° C. Recoveries of salinomycin from spiked tissues at 30 ng/g level ranged between 87 and 100%. The limit of quantitation was found to be 10 ng/g. The developed method was applied for the analysis of incurred tissues and ovarian yolk of laying chickens given sodium salinomycin in feed at different levels for 14 consecutive days followed by withdrawal periods. Residues were detected in all tissues and ovarian yolk at 0 withdrawal time but declined during the withdrawal period. Highest residue were found in fat and ovarian yolk.     

微波辐射回用活性炭对水中亚甲基蓝和Cd~(2+)去除效果的研究

考察了微波-活性炭联合处理技术对模拟染料废水中亚甲基蓝和Cd2+的去除效果。对于100 mL浓度为1 000 mg/L的亚甲基蓝溶液、活性炭用量为10 g时,新活性炭对亚甲基蓝的去除率为99.99%;采用700 W微波对吸附亚甲基蓝的活性炭辐射10 min进行再生并回用,经微波辐射再生10次后活性炭对亚甲基蓝的去除率为99.68%,未经微波作用反复使用10次的活性炭对亚甲基蓝的去除率为85.41%。结果表明:微波处理有效地减缓了活性炭吸附能力的下降速率,实现了活性炭再生和反复使用。在吸附过程中,Cd2+使活性炭对亚甲基蓝的吸附能力略有下降,而共存的亚甲基蓝则促进了活性炭对Cd2+的吸附,对新炭和再生后活性炭物理化学特性的表征证明了活性炭对亚甲基蓝的吸附为物理吸附,对Cd2+的吸附为化学吸附。     

微波诱导热解法制备落叶吸附剂及其工艺优化

采用微波诱导热解法制备低成本落叶吸附剂,以实现落叶的资源化利用.以碘吸附值为响应值,采用响应面分析法研究了微波诱导热解法制备落叶吸附剂的工艺条件.结果表明,热解时间与微波功率之间存在交互作用,当热解功率增加时,可适当缩短热解时间.落叶吸附剂的最佳制备工艺条件为:热解时间4.04 min,微波功率488.72W,氯化锌质量分数27％.落叶吸附剂以微孔吸附为主,BJH孔径分布较窄,孔容最高峰对应的孔径在1.9 nm左右,Langmuir比表面积为769.61 m2/g.     

Synthesis, crystal structure, photodegradation kinetics and photocatalytic activity of novel photocatalyst ZnBiYO4

ZnBiYO₄ was synthesized by a solid-state reaction method for the first time. The structural and photocatalytic properties of ZnBiYO₄ were characterized by X-ray diffraction, scanning electron microscopy, X-ray photoelectron spectroscopy and UV-Vis diffuse reflectance. ZnBiYO₄ crystallized with a tetragonal spinel structure with space group I41/A. The lattice parameters for ZnBiYO₄ were a = b = 11.176479 Å and c= 10.014323 Å. The band gap of ZnBiYO₄ was estimated to be 1.58 eV. The photocatalytic activity of ZnBiYO₄ was assessed by photodegradation of methyl orange under visible light irradiation. The results showed that ZnBiYO₄ had higher catalytic activity compared with N-doped TiO₂ under the same experimental conditions using visible light irradiation. The photocatalytic degradation of methyl orange with ZnBiYO₄ or N-doped TiO₂ as catalyst followed first-order reaction kinetics, and the first-order rate constant was 0.01575 and 0.00416 min^-1 for ZnBiYO₄ and N-doped TiO₂, respectively. After visible light irradiation for 220 min with ZnBiYO₄ as catalyst, complete removal and mineralization of methyl orange were observed. The reduction of total organic carbon, formation of inorganic products, SO₄^2- and NO₃^-, and evolution of CO₂ revealed the continuous mineralization of methyl orange during the photocatalytic process. The intermediate products were identified using liquid chromatography- mass spectrometry. The ZnBiYO₄/(visible light) photocatalysis system was found to be suitable for textile industry wastewater treatment and could be used to solve other environmental chemical pollution problems.     

微波在废树脂中的穿透厚度研究

通过对不同功率微波在不同规格钢桶中对不同含水率的树脂中的穿透厚度的研究可知,微波在树脂中的穿透厚度主要与树脂自身含水率有关,与钢桶的规格尺寸也有一定的关系,而微波功率的影响则可基本忽略不计;对于含水率50％左右的树脂,微波在12L钢桶中的穿透厚度是130 mm;在200L钢桶中的穿透厚度是70mm.该研究成果对微波干燥工艺的具体参数的选取和扩大规模台架装置的设计研究等有重要意义.     

微波消解－ICP－MS法测定土壤中稀土元素的研究

建立了电感耦合等离子体质谱（ ICP－MS）测定土壤中稀土元素的分析方法。采用HNO3＋HF酸体系用微波消解对土壤样品进行处理,以混合内标（ In、Bi）校正基体干扰和信号漂移,用ICP－MS对其中的16种稀土元素进行了测定。在优化的实验条件下,16种稀土元素标准曲线的相关系数r＞0．9999,检出限为0.012 ng／ml～0.069 ng／ml,加标回收率为84.0％～110％,相对标准偏差（n＝6）RSD均小于3.5％。该方法可用于四种不同类型土壤中稀土元素含量的测定。     

载体酸处理对CuMnCeOx/堇青石微波催化燃烧甲苯性能的影响

针对堇青石载体比表面积小、活性组分分散程度低等问题,本研究使用盐酸对蜂窝状堇青石载体进行酸蚀处理以增大其比表面积.在采用等体积浸渍法制备CuMnCeO_x/酸蚀堇青石催化剂的基础上,开展了微波催化燃烧甲苯试验以考察酸处理对催化剂活性的影响,同时对CuMnCeO_x/堇青石与CuMnCeO_x/酸蚀堇青石催化剂进行BET、SEM、PSDA和XRD等表征测试.结果表明,堇青石载体的比表面积由酸蚀前的0.153 m²·g^-1提高至酸蚀后的1.024m²·g^-1;酸蚀未改变堇青石载体的晶体结构,同时CuMnCeO_x/酸蚀堇青石活性组分的特征峰相较于CuMnCeO_x/堇青石催化剂有所增多.在处理气量为0.12m³·h^-1、甲苯初始浓度为1000 mg·m^-3和床层温度为160℃的反应条件下,CuMnCeO_x/酸蚀堇青石催...     

高能重离子辐照下国产RPV钢A508-3的硬化行为

目的 研究在563 K的温度条件下,高能重离子辐照导致国产RPV钢A508-3的硬化行为。方法 使用回旋加速器提供的352.8 MeV Fe²¹⁺对A508-3钢试样进行辐照,使其依次达到0.15、0.30、1.50 dpa的损伤水平。借助辐照终端的梯度减能装置,在样品表面至25 μm的深度范围内产生一个准均匀分布的原子离位损伤坪区,并使用纳米压痕仪和维氏显微硬度计测量了试样的硬度。结果 考虑到压痕尺寸效应的影响,采用Nix-Gao模型对硬度数据进行拟合,由于高能Fe离子产生了较厚的损伤区,辐照试样中的软基效应明显减弱。辐照后的试样出现明显的硬化现象,且随着辐照剂量的增大,硬化增量有饱和趋势。通过辐照前和辐照至0.15 dpa试样的微硬度数据,得出其与纳米硬度之间的线性关系(Hv0=0.85 H0)。结论 借助A508-3辐照前后的硬度数据,计算发现试样的屈服强度增量与辐照剂量之间存在一种幂函数关系,这为A508-3钢中子-离子辐照硬化的映射关系研究提供了基础数据。