螺压机在焦化废水处理中污泥脱水的应用

对几种脱水设备的性能进行了分析比较,对一种新型螺旋式污泥脱水机在焦化废水过程中污泥脱水的研究及应用进行了探讨。     

污泥脱水性能的关键影响因素研究

针对目前污泥脱水性能影响因素不明的问题,研究通过对SBR在7种运行工况条件下活性污泥胞外聚合物(extracellular polymeric substances,EPS)的提取和测试,并采用SPSS软件分析,探讨MLVSS/MLSS、胞外蛋白质/胞外多糖、胞外蛋白质含量、胞外多糖含量、EPS总含量对污泥脱水性能的影响。研究结果表明,MLVSS/MLSS、胞外蛋白质/胞外多糖是影响污泥脱水性能的关键因素,并建立了脱水污泥含水率和污泥结合水含量的影响因素模型:脱水污泥含水率=0.229×(MLVSS/MLSS)+0.023×(胞外蛋白质/胞外多糖)+0.539、污泥结合水含量=2.876×(MLVSS/MLSS)+0.335×(胞外蛋白质/胞外多糖)-0.012,通过对7个城市污水厂污泥脱水性能测试比较表明,模型对脱水污泥含水率和污泥结合水含量预测值相对误差分别在±1%和±5%以内,对污泥脱水性能预测效果良好。     

高氨氮污泥脱水液短程硝化反硝化的启动及稳定

采用A/O-CSTR工艺处理高氨氮污泥脱水液。进水氨氮浓度浓度约为375 mg/L，C/N比小于1.0，反硝化碳源明显不足。A/O反应器完成短程硝化反应，CSTR定期投加初沉污泥作为碳源进行反硝化。两者联合达到总氮去除的目的。实验研究短程硝化反应的启动过程，以及CSTR出水回流对短程硝化和系统脱氮效果的影响。实验结果表明系统具有良好的硝化反硝化效果。A/O反应器亚硝酸盐积累率迅速提高并稳定在90%以上。CSTR有效利用初沉污泥实现了稳定的反硝化。出水回流有利于提高总氮去除率，在回流比为200%时，系统平均总氮去除率达到85%以上。     

污水污泥有机调质浓缩和无机调质脱水工艺研究

介绍了一种污水污泥有机调质浓缩和无机调质脱水工艺，它可有效提高污泥浓缩和脱水效率。含水率99％以上的剩余污泥经过有机调质后可快速浓缩至含水率93％左右，去除污泥中的间隙水和表面吸附水。浓缩污泥经过无机调质后可板框压滤脱水至含水率60％左右，脱除污泥中的毛细结合水和部分细胞水，而且实现了污泥重金属的稳定化。     

Improving situational awareness through the design of offshore installations

Maintaining the situational awareness of control room operators on offshore installations contributes to the timely diagnosis of conditions and making appropriate decisions. This is particularly important when dealing with events and incidents. Recent initiatives aimed at reducing operators’ exposure to the hazards of working on offshore installations may have a negative impact upon situational awareness within the control room environment.This paper discusses mitigation of the negative impact through the design and operation of the installation and control system; either by improving the general level of situational awareness or by specifically targeting the areas affected by these initiatives.     

新装修居室甲醛污染的危害与控制技术

综述了新装修居室的甲醛对人体健康的危害，通过分析污染的来源，提出了切实可行的控制方法。     

微波预处理对制革污泥絮凝脱水性能的影响

分别采用微波、絮凝剂和微波联合絮凝剂对制革污泥进行脱水预处理,考察不同处理条件下制革污泥沉降速率(SV30)、毛细吸水时间(CST)和污泥比阻(SRF)的变化,并通过粘度、水分分布和微观结构的变化探讨相关的脱水机理。结果表明,在微波输出功率为648 W、辐射时间为60 s的预处理条件下,阳离子聚丙烯酰胺(CPAM)投加剂量为8 mg/L时,污泥脱水性能达到最佳。与单独添加絮凝剂的污泥脱水相比,该条件下的SV30、CST和SRF分别降低了25.0%、48.9%和34.7%。污泥絮凝脱水前进行微波预处理能够进一步提高污泥的脱水性能,微波辐射联合CPAM进行污泥脱水时,CPAM则起主要脱水作用。微波辐射通过破坏污泥絮体结构,改变污泥中的水分分布,降低污泥的粘度,从而提高污泥的脱水性能。     

两性高分子絮凝剂的制备及其应用研究

以天然植物粉Ｆ６９１为原料,通过羧甲基化、接枝共聚和曼尼期(Ｍａｎｎｉｃｈ)三步反应合成出两性天然高分子改性絮凝剂(ＣＧＡＡＣ),确定了其较佳的制备条件;ＣＧＡＡＣ对造纸抄纸白水和造纸混合污泥的絮凝脱水试验表明:１０ｍｇ·ｌ－１ＣＧＡＡＣ与４０ｍｇ·ｌ－１ＰＡＣ配合使用,ＣＯＤＣｒ去除率可达７２%,效果优于对比样ＰＨＰ;ＣＧＡＡＣ对造纸混合污泥的絮凝脱水性能优于对比样ＰＨＰ和ＰＡＭ－Ｃ．     

电动脱除孔隙水削减底泥内源磷的效果研究

选择污染严重的底泥为研究对象,采用基于孔隙水脱除的电动修复装置,进行了底泥脱水排磷实验,探究了电动脱除孔隙水的底泥减磷效果,分析了底泥各形态磷在电动脱除孔隙水中的迁移转化过程.结果表明：电动脱水过程中阴极总脱水量为5740mL,远大于阳极（2121mL）,但脱水中总磷浓度为阳极大于阴极,80%以上的磷从阳极排出,电迁移在电动脱水排磷中起主要作用,通电使排磷总量增加了70%以上,其中在0.25V/cm的电压梯度下修复18d的条件下,排磷量最大;电动脱水排磷效率在通电48h内达到最高[0.73mg/（kW·h）],随后急剧减小;经过电动脱水排磷后,底泥含水率下降了14.07%,底泥总磷降幅最高可达231.92mg/kg,底泥中交换态磷（Ex-P）、铁结合态磷（Fe-P）、闭蓄态磷（Oc-P）、钙结合态磷（Ca-P）平均脱除率分别为80.01%、14.75%、40.65%和19.22%,其中阳极酸化导致氧化铁的溶解和Ca-P的释放,故阳极附近Oc-P、Ca-P降幅较大,而阴极碱化使Fe-P释放,故阴极附近Fe-P降幅较大.经计算可知,通过电动脱除孔隙水,底泥中生物可利用性磷（Ex-P+Fe/Al-P）平均下降了14.12%,底泥内源磷释放的风险得以降低.     

Magnetic micro-particle conditioning–pressurized vertical electro-osmotic dewatering (MPEOD) of activated sludge: Role and behavior of moisture and organics

In this study, a magnetic micro-particle conditioning–pressurized vertical electro-osmotic dewatering (MPEOD) process with magnetic micro-particle conditioning–drainage under gravity–mechanical compression–electrical compression (MMPC–DG–MC–EC) stages was established to study the distribution and migration of water, extracellular polymeric substances (EPS), and other organic matter in the activated sludge (AS) matrix at each stage. Results showed that the MPEOD process could attain 53.52% water content (WC) in dewatered AS with bound water (BW) and free water (FW) reduction rates of 82.97% and 99.67%, respectively. The coagulation and time-delayed magnetic field effects of magnetic micro-particles (MMPs) along the MMPC–DG–MC stages initiated the transformation of partial BW to FW in AS. EC had a coupling driving effect of electro-osmosis and pressure on BW, and the changes in pH and temperature at EC stage induced the aggregation of AS flocs and the release of partial BW. Additionally, MMPs dosing further improved the dewatering performance of AS by acting as skeleton builders to provide water passages. Meanwhile, MMPs could disintegrate sludge cells and EPS fractions, thereby reducing tryptophan-like protein and byproduct-like material concentrations in LB-EPS as well as protein/polysaccharide ratio in AS matrix, which could improve AS filterability. At EC stage, the former four Ex/Em regions of fluorescence regional integration analysis for EPS were obviously reduced, especially the protein-like substances in LB- and TB-EPS, which contributed to improvement of AS dewaterability.