焚烧飞灰熔融过程重金属迁移特性中试研究

通过中试试验研究垃圾焚烧飞灰熔融过程重金属Cd、Pb、Zn、Cu、Cr和Ni的迁移特性,着重研究重金属在熔渣中的固化效果,考察了温度（1 290℃、1 320℃、1 360 ℃）、助熔剂（10 %的玻璃粉）、冷却方式（水冷、空冷）对重金属固定率的影响.结果表明,温度的提高使Pb、Zn、Cu、Cr和Ni的固定率都有一定的提高;加入10%的玻璃粉使各种重金属的固定率都有显著提高,只有Zn例外;对Zn、Cu、Cr和Ni,空气冷却方式下的重金属固定率比水冷方式下的高.     

采用巯基捕收剂稳定化处理垃圾焚烧飞灰中的重金属

研究了3种巯基捕收剂,二乙基二硫代氨基甲酸钠（乙硫氮）、乙基黄原酸钾（乙基黄药）和二丁基二硫代磷酰铵（丁铵黑药）,对垃圾焚烧飞灰中重金属的稳定化效果。3种巯基捕收剂的用量均为62.5μmol?g-1飞灰。扫描电镜观察发现,飞灰经稳定化处理后,巯基捕收剂均匀地覆盖于飞灰晶体表面,使矿物晶体棱角变得模糊。利用酸浸提程序（TCLP法）和水浸提程序（水平振荡法）评价飞灰中重金属Cu、Pb、Cd、Cr和Zn的浸出毒性。在0.1mol?L-1醋酸浸提条件下,与Na2S相比,巯基捕收剂对Cu和Pb的稳定化效果较好,其中乙硫氮对Cu的稳定化比率接近100%,丁铵黑药对Pb的稳定化比率达到69.2%;在水浸提条件下,乙硫氮、乙基黄药和丁铵黑药对5种重金属的稳定化比率分别为72.6%、73.5%和76.8%,显著高于Na2S处理（52.4%）。三种巯基捕收剂对5种重金属亲和力的强弱顺序大致为Cu＞Pb＞Cr＞Cd＞Zn,并且超过60%的巯基捕收剂与酸可浸提重金属离子发生了螯合沉淀反应。重金属-巯基捕收剂絮凝物在中性和碱性条件下（pH>6）比较稳定,在酸性条件下（pH<6）可发生部分溶解。为获得较好的重金属稳定化效果,维持稳定化飞灰的高酸缓冲容量十分重要。     

Effects of metal cations on sorption-desorption of p-nitrophenol onto wheat ash

The mutual e ects of metal cations (Cu2+, Pb2+, Zn2+, and Cd2+) and p-nitrophenol (NP) on their adsorption desorption behavior onto wheat ash were studied. Results suggested that Cu2+, Pb2+, and Zn2+ diminished the adsorption and increased the desorption of NP remarkably, while Cd2+ had no such e ect. In contrast, NP diminished the adsorption of Cu2+, Pb2+, and Zn2+ onto ash, however, this suppression e ect depended on the initial concentrations of metal cations. NP had no e ect on Cd2+ adsorption on ash. Fourier transform infrared (FT-IR) and X-ray absorption spectroscopic (XAS) studies suggested the following mechanisms responsible for the metal suppression e ect on NP adsorption: (1) large hydrated Cu2+, Pb2+, and Zn2+ shells occupied the surface of ash and prevent nonspecific adsorption of NP onto ash surface; (2) Cu2+, Pb2+, and Zn2+ may block the micropores of ash, resulting in decreased adsorption of NP; (3) complexation of Cu2+, Pb2+, and Zn2+ was likely via carboxyl, hydroxylic and phenolic groups of wheat ash and these same groups may also react with NP during adsorption. As a “soft acid”, Cd2+ is less e cient in the complexation of oxygencontaining acid groups than Cu2+, Pb2+, and Zn2+. Thus, Cd2+ had no e ect on the adsorption of NP on wheat ash.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。     

生活垃圾焚烧飞灰制陶瓷砖表征

为了探索生活垃圾焚烧飞灰资源化利用途径,在对飞灰化学组成及矿物成分分析的基础上,利用飞灰、黄陶土、耐火砂及长石研制陶瓷砖,最佳配比方案为:飞灰20%,黄陶土60%,长石10%,耐火砂10%,分析了最佳配比制品的吸水率、抗压强度、微观结构及水平振荡浸出毒性。结果表明:飞灰属SiO2-Al2O3-金属氧化物体系,主要矿物成分是钙硅酸盐及铝硅酸盐等,可用于制陶瓷砖;最佳配比制品达MU15强度等级,满足抗风化的要求;随煅烧温度的升高,制品结构不断密实化,960℃烧成的制品显示出完全烧结的特点,960~1 000℃烧成的制品中出现明显的晶化、玻璃化过程。最佳配比制品重金属浸出毒性完全达标,重金属的浸出率与坯体相比大大降低。     

免烧粉煤灰陶粒作为BAF填料处理城市污水

以电厂粉煤灰为主要试验原料,辅以外加药剂(水泥、石灰、石膏、水玻璃),经混合、成球、陈化和养护等工序,制得免烧粉煤灰陶粒,并将其作为曝气生物滤池(BAF)工艺的载体填料处理城市污水.待挂膜启动成功后,考察了水力停留时间( HRT)、COD负荷、氨氮负荷对COD和氨氮去除效果的影响.实验结果表明:在温度为18～21℃、气...     

利用铜矿尾砂研制低强度可控性填料

利用铜矿尾砂、粉煤灰、水泥以及加气剂等,混合搅拌成泥浆体,振动成型,制备出低强度可控性填料(CLSM).试验表明:以水泥12.9％、铜矿尾砂(细集料)22.6％、加气剂3.2％、粉煤灰12.9％等工业废弃物,加水48.4％,固液比控制在(14～15):(15～16)之间,制得的CLSM制品,抗压强度0.35～2.00 ...     

粉煤灰对混合染料的吸附性能研究

以燃煤废弃物粉煤灰作为吸附剂,对活性红23和分散蓝56混合染料溶液进行吸附性能研究.实验结果表明:粉煤灰优先吸附离子型的活性染料,混合溶液中对活性红23的吸附能够在30 min达到平衡,而对分散蓝56的吸附则需要150 min才能够达到平衡,吸附动力学符合准二级吸附模型.在弱酸性环境中粉煤灰对分散染料的脱色高于碱性环境...     

垃圾焚烧飞灰中二噁英削减技术研究

二噁英(PCDD/Fs)是多氯代二苯并二噁英和多氯代二苯并呋喃的总称,因具有生物蓄积性、高毒性、难降解等特点而备受关注。垃圾焚烧是二噁英的重要来源,而其中超过50%的二噁英以飞灰形式排出。文章综述了热分解法、光降解法、机械化学法、生物降解法等飞灰二噁英毒性削减技术的国内外研究进展,并在此基础上对飞灰二噁英削减技术研究和管理提出了建议。