新型生物流化复合反应器的设计及气含率测定

鉴于对传统内外筒结构三相内循环流化床存在的一些不足 ,提出了一种新型的基于循环流化床原理的生物流化复合反应器。新型反应器采用蜂窝状断面结构 ,机械分离与气浮原理相结合的三相分离器。为了减少反应器运行中的能耗 ,筛选出了一种新型轻质橡胶载体。并且针对这种新型反应器进行了气含率的测定 ,得出在实验范围内总平均气含率随进气量呈直线上升 ,还分别得出了上升区气含率和下降区气含率的变化情况     

治理橡胶废水的活性污泥模型研究

采用模拟曝气工艺研究了活性污泥对橡胶厌氧废水的CODcr,NH3-N的降解条件，确定了最佳的曝气时间，污泥浓度及溶解氧浓度与处理效果的关系。     

高温高压高含CO2环境下两种氟橡胶密封可靠性评价

目的 研究两种氟橡胶O型圈在总压为25 MPa,CO2体积分数为5%,温度为120 ℃,液相介质Cl^?质量浓度为7000 mg/L的高温高压高含CO2工况下的密封可靠性。方法 通过高温高压釜模拟井下实际工况,采用自研橡胶O型圈密封装置实现试样的承压状态,以物理性能、腐蚀形貌和抗渗透性能为考察指标,对两种氟橡胶O型圈的耐蚀性能和密封性能进行测试评价。结果 氟硅橡胶O型圈在承压状态下腐蚀后,拉伸强度由18.1 MPa下降为13.4 MPa,拉断伸长率由172.8%下降为151.9%。AFLAS橡胶O型圈在承压状态下腐蚀后,拉伸强度由21 MPa下降为14.6 MPa,拉断伸长率由277%下降为212.3%,硬度从84HA下降为75.5HA,表面破损严重。两种橡胶O型圈抗渗透性能随压差增大、温度上升而减弱。结论 承压状态下,两种橡胶O型圈性能衰减程度低于自由状态,氟硅橡胶O型圈在承压状态下表现出更好的密封可靠性。     

两相分配体系中硅酮母粒对氯苯降解菌Delftia sp. LW26的影响

将硅酮母粒作为两相分配体系中的固态非水相（SNAP）来处理氯苯废气,从细胞表面疏水性（CSH）、菌体表面胞外多聚物（EPS）和电子传递体系（ETS）来探究硅酮母粒的加入对微生物特性以及活性的影响.结果表明,硅酮母粒在1 h内可捕集70%左右的氯苯,5次回收再利用的硅酮母粒在两相体系中对氯苯的去除率仍在99%以上;在较高的初始氯苯浓度下（10 mmol·L^-1）,两相体系中的ETS活性可达到112 mg·g^-1·h^-1,而在单相体系中未检测到ETS活性;两相体系中EPS量较于单相体系也有所提高,并且EPS中的蛋白质与多糖的比值是单相体系的2.34倍,这在一定程度上提高了CSH,使菌体更趋向于粘附在固/液界面,提高了传质效率;CSH总体上随硅酮母粒比例的增加而增加,且在20%时达到最大值.     

某型橡胶密封圈加速贮存试验设计与实践

目的针对某型橡胶密封圈开展加速贮存试验设计,并通过试验预测产品贮存寿命。方法通过分析橡胶密封圈在贮存使用环境下的失效机理,结合橡胶材料性能老化模型,在不改变失效机理、又不增加新的失效机理的前提下,以密封圈整件作为试验对象,用加大温度应力的试验方法加速产品失效过程,根据试验结果预计正常环境应力下的产品贮存寿命。结果采用温度应力作为加速贮存应力开展密封圈加速贮存试验方案设计和验证工作,评估得到其在贮存温度为20℃的环境中,贮存寿命可以达到16.97年,置信度大于0.95。结论以密封圈整件作为试验件,采用温度应力作为贮存敏感应力开展加速贮存试验,所评估得到的贮存寿命与产品已有的自然贮存寿命结果吻合得较好,试验状态更加真实,为橡胶密封圈更换周期提供参考依据,并为密封圈贮存寿命的定量评估提供了一种参考方法。     

Rubber cultivation and sustainable development in Xishuangbanna,China

SUMMARY

Xishuangbanna in southwest China is a tropical and subtropical region with extraordinary traditional cultures and attractive landscapes. Rubber cultivation is a key production source undergoing rapid growth. It contributes substantially to improvement of the local economic situation and partially replaces traditional slash-and-burn agriculture in the uplands, but it also results in biodiversity loss and environmental degradation and disturbs the peaceful life of the indigenous people. We discuss the traditional ecological knowledge (TEK) preserved in daily practices and the present types of rubber plantations and suggest the application of TEK, in particular, the indigenous land-use experience to rubber cultivation, in order to promote sustainability in local economic development and ecological well-being.     

基于加速老化和自然贮存数据的氟硅橡胶制品贮存寿命预估

目的准确评价氟硅橡胶制品的贮存寿命。方法利用G402氟硅橡胶制品自然贮存数据对加速老化试验数据进行检验。结果确认加速老化试验方法可行,数据可信,并根据加速老化试验中的模拟试验确定了贮存失效临界值。结论推测出G402氟硅橡胶制品的贮存寿命可以达到15年。     

空气涡轮制冷低温粉碎法回收废弃橡胶

利用带回冷循环的空气涡轮制冷系统，在低温条件下，将废旧橡胶进行冷冻、粉碎、制成６０目以上的精细胶粉。此法的冷冻能耗成本仅为国际上通用的液氮法的１／１０，整具工艺过程不产生二次污染，为废旧橡胶的综合利用提供了一条新途径。     

Some Rheological Properties of Latex from Parthenium argentatum Gray Compared with Latex from Hevea brasiliensis and Ficus elastica

Latex was purified from Parthenium argentatum Gray (guayule), Hevea brasiliensis Müll. Arg. (the Brazilian or para rubber tree), and Ficus elastica Roxb. (the Indian rubber tree) in ammonium alginate at pH 10. The rheological properties of the different latices (rubber particle suspensions) were determined and compared using flow temperature ramps. Latex from all three species became more viscous with increasing rubber particle concentration and decreasing temperature. At any particular temperature and concentration, latex from F. elastica was by far the most viscous, whereas the H. brasiliensis latex was the least viscous. In addition, the tendency for the latex to coagulate increased with increasing temperature and increasing particle concentration. F. elastica latex was highly sensitive to temperature, H. brasiliensis latex was the least sensitive, and P. argentatum latex demonstrated intermediate properties. The underlying causes of these differences in latex rheology are not clear but may partially relate to the particle size (largest in F. elastica and smallest in H. brasiliensis), the particle size distribution, and/or to the considerable differences in the biochemical components of the monolayer biomembrane that surrounds the various rubber particles. Differences in the molecular weight of the rubber contained within the rubber particles seem less likely to play a role because the particles remain intact in this study.     

Mexican High Rubber Producing Guayule Shrubs: A Potential Source for Commercial Development

Guayule is a shrub native to Mexico growing in semiarid lands, that may be incorporated into the semiarid region production system as a complement for annual crops. The possibility to develop this natural resource as a sustainable industrial source of natural rubber, may improve the socio-economical level of people living at the guayule region and favor the agricultural development near the US-Mexico border. Despite the existence of natural stands in Mexico with guayule plants of different rubber content, a program envisaging selection of plants with high rubber synthesis potential joined to agronomic management practices are required. This could achieve the rubber yield needed to guarantee a constant supply of raw material for an industrial processing plant. This paper reviews R&D work carried out in Mexico for the last 25 years, including genetic aspects and evaluation of guayule response to environmental and agronomic factors. Relevant results showed plants with up to 21% rubber content and the existence of diploid plants, which could facilitate future plant breeding programs.