铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

谈谈英语学习方式的转变

很多学生现在对英语学习感到无所适从，他们觉得自己无论如何尽力也没有办法提高英语成绩。本文对这种情况的出现做了简单的分析，并提出了一些建议。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

用BaCl2滴定法快速测定硫酸盐的研究

用铬酸钡光度法、EDTA滴定法、间接原予吸收法、离子色谱法等方法测定SO4^2-检测上限都很低（12—200mg／L），且只适用于清洁水，若水样混浊则会引起较大的误差。有的地下水，SO4^2-浓度高迭44000mg／L，用BaCl2滴定法测定SO4^2-：测试水样，以溴酚蓝做酸碱指示剂，加1：50盐酸，调为pH=3．5，加入30ml异丙醇，以钍试荆做终点指示荆，滴加0．01mol／L BaCl2，砖红色为终点，根据BaCl2用量计算SO4^2-浓度。本方法快捷、准确、测定范围大，上限可迭2000mg／L，克服了光度法测定浑浊水样引起误差大的缺点。     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

地理变异系数法和Fisher最优分割法在环境空气监测优化布点中的应用

在环境空气监测点位优化中,为反映优化后点位的整体代表性,需要在允许的测定误差内以最少的测点反映区域内较长时期的整体污染水平、污染分布状况和污染趋势.本文以博山城区为例,利用地理变异系数法和Fisher最优分割法对所布设点位进行数理统计.该方法使用简便,分级自然,避免了诸多人为因素的影响,同时,优选结果具有较强的整体代表性.     

阳极溶出伏安法连续测定底泥中的总镉和总铅

底泥样品经盐酸-硝酸-氢氟酸-高氯酸消解后,用1 1盐政溶解残渣,以高氯酸做支持电解质,采用阳极溶出伏安法的标准加入法,连续测定样品中的总镉和总铅.该方法测定土壤标准样品中镉和铅的相对标准偏差分别为5.6%和4.6%,相对误差分别为2.4%和～1.7%;测定自采底泥样品中镉和铅的相对偏差分别为7.7%和8.1%,方法的重复性好;测定土壤标准样品中镉加标回收率为94.0%～106.8%,铅加标回收率为95%～103.8%;自采样品中镉加标回收率为93.0%～105.6%,铅加标回收率为90.0%～105.0%,方法的准确度较高.实验中,镉和铅的半波电位稳定,峰形对称.     

孔隙水压力消散试验在尾矿坝安全施工中的应用

尾矿库设计的主要控制条件是坝体的稳定性。在尾矿坝施工中还需要考虑强度、渗水性等影响因素。以锡冶山尾矿坝工程为例，探讨了数值法在尾矿库坝体岩土孔隙水压力消散试验中的应用。对提高试验精度、减少试验开支、指导工程安全施工具有现实意义。     

H型超薄板防渗技术在卫生填埋场中的应用

上海某生活垃圾卫生填埋场运营过程中发生堤坝渗漏,对周围环境造成了污染。经比选采用H型超薄板防渗技术处理,防渗薄板墙深18m,墙厚100mm。竣工后经CSAMT法、现场开挖取样等方式检测,超薄板墙各项指标均满足要求。有效治理了渗滤液渗漏,提升了区域环境质量。     

确定机动车排放因子的几种方法

介绍了确定机动车排放因子的几种方法,即台架测试法、模式计算法、实际行驶工况测试法、公路隧道法,并简要介绍了它们的特点、应用的范围.