阳澄湖水源中典型嗅味物质测定与来源分析

以阳澄湖水源为研究对象,采用固相微萃取-气质联用法测定水中2-甲基异莰醇(2-MIB)、土臭素(GSM)、2,4,6-三氯苯甲醚(2,4,6-TAC)、2,3,4-三氯苯甲醚(2,3,4-TAC)、2,3,6-三氯苯甲醚(2,3,6-TAC)、2-异丙基-3甲氧基吡嗪(IPMP)、2-异丁基-3甲氧基吡嗪(IBMP)、β-环柠檬醛、β-紫罗兰酮、异氟尔酮等10种典型嗅味物质,并分析可能的来源藻类.以2018年1月-12月阳澄湖水源中优势藻种为基础,建立以上述嗅味物质为变量的多元线性回归模型.结果表明,水源中2-MIB、GSM、β-环柠檬醛、β-紫罗兰酮、异氟尔酮5种嗅味物质与直链藻、针杆藻、鱼腥藻、色球藻、颤藻、微囊藻、束丝藻7种藻类有较强的相关性.     

大豆蛋白粉喷雾干燥塔尾气余热的回收与利用

针对大豆蛋白粉生产过程中喷雾干燥塔尾气温度较高,有回收利用价值的现实,也针对目前的节能需求,对现有的喷雾干燥塔的尾气排放部分进行改造,设计一个片状空气预热器,以利用高温的尾气与系统的进气做热交换,实现热量再利用,降耗和提高蛋白粉产率的目的,并对投资收益进行了分析。     

Sensitivity analysis of the two dimensional application of the Generic Ecological Model (GEM) to algal bloom prediction in the North Sea

Harmful algae can cause damage to co-existing organisms, tourism and farmers. Accurate predictions of algal future composition and abundance as well as when and where algal blooms may occur could help early warning and mitigating. The Generic Ecological Model is an instrument that can be applied to any water system (fresh, transitional or coastal) to calculate the primary production, chlorophyll-a concentration and phytoplankton species composition. It consists of physical, chemical and ecological model components which are coupled together to build one generic and flexible modelling tool. In this paper the model has been analyzed to assess sensitivity of the simulated chlorophyll-a concentration to a subset of ecologically significant input factors. Only a small number of approaches could be considered as suitable for several reasons including the model complexity, engagement of numerous interacting parameters and relatively long time of a single simulation. Thus, sensitivity analysis has been carried out with the use of the Morris method and later enriched by the computation of the correlation ratios of the selected parameters on the model response at more than a few locations in the modelled area. The obtained results are in agreement with expert knowledge of the ecological processes in the North Sea and correspond well with local characteristics.     

从粉煤灰中提取多种微细氧化物的研究

将粉煤灰与Na2CO3按一定的比例混合后焙烧,采用酸碱联合法提取粉煤灰中氧化硅、氧化铝和氧化铁,分析了工艺条件对粉煤灰中氧化物提取率的影响。实验结果表明,从粉煤灰中提取氧化物的最佳条件是:碳酸钠与粉煤灰的比例0.6∶1.0,焙烧温度850℃、盐酸浓度4 mol/L,氢氧化钠浓度2.6 mol/L,浸取时间约6 h。在此条件下得出微细氧化硅、氧化铝、氧化铁的晶体,其平均粒度分别为氧化硅1.107μm,氧化铝1.334μm,氧化铁0.783μm。     

藻类对污泥脱水性能的研究

选取了淡水藻水绵与啤酒厂污泥进行厌氧发酵,设计了测定污泥干燥性能、沉降性能、过滤性能等装置,观察并记录了其对污泥的絮凝效果。结果表明,水绵在厌氧发酵条件下能分泌出含有絮凝性的物质EOM（胞内多聚物）,有助于污泥更好的脱水。     

漂白粉用于治理石化企业硫化氢恶臭气体的研究

实验采用填料吸收塔对漂白粉用于石化企业硫化氢恶臭的治理进行了初步研究,系统研究了漂白粉投加量、硫化氢浓度、进气流量、吸收氧化温度、液气比等因素对处理效果的影响。结果表明：室温下,漂白粉投加量为0．2g／100mL,液气比20L／m^3,进气浓度控制在7800mg／m^3以内,调整适宜的进气量,对硫化氢恶臭的去除率可以达到99％以上。漂白粉吸收氧化硫化氢恶臭气体不仅技术可行,而且费用低廉,操作方便,可以进行深入的研究,进行工业化放大。     

Numerical simulation for impacts of hydrodynamic conditions on algae growth in Chongqing Section of Jialing River, China

Hydrodynamic conditions are important factors for planktonic algae growth, through introducing two parameters which express the optimal velocity and the velocity range for planktonic algae growth, a new velocity factor was put forward for the formula of growth rate. Therefore, the two-dimensional unsteady ecological dynamic model for algae growth was established to analyze the effects of hydrodynamic conditions on algae growth in Chongqing Reach of Jialing River in China. The temporal and spatial distribution of Chlorophyll-a (Chl-a) concentration was simulated numerically for various water levels, under climate conditions in period of high frequency for algae blooms of Three Gorges Reservoir and nutrition status at present in the research reach. The corresponding locations and areas of likely algae blooms were analyzed and forecasted. The results showed that about 0.04 m s⁻¹ was the optimal velocity for algae growth, and the occurrence of algae blooms in large scale is almost impossible because of relatively high water flow velocity for Jialing River.     

摩托车防盗器遥控引燃黑火药的实验研究

根据2013型铁将军牌摩托车防盗器工作原理,分析了连接左转向灯、起动继电器及电门锁的5条导线遥控引燃黑火药的方式.利用GOS-620型示波器,测得防盗器在设防、寻车、起动、振动1次、连续振动、解锁时这5根导线两两之间的电压.从60种组合中筛选出10种可能引燃黑火药的方式.通过引燃实验,验证了这10种引燃方式.以左转向灯...     

Understanding the role of nano-TiO2 on the toxicity of Pb on C. dubia through modeling–Is it additive or synergistic?

• A two-compartment model is able to quantify the effect of nano-TiO₂ on Pb toxicity. • Nano-TiO₂ reduces Pb tolerance level and increased the killing rate for C. dubia. • Thus, nano-TiO₂ synergistically enhances Pb toxicity. • Algae reduce Pb transfer rate to the body tissue and the killing rate. Nano-TiO₂ can remarkably increase lead (Pb) toxicity in aquatic organisms. However, the mechanism of this toxicity, additive or synergistic, is not well understood. To explore this mechanism, we inspected the role of nano-TiO₂ in the toxicity of Pb on Ceriodaphnia dubia (C. dubia), a model water flea species typically used for ecotoxicity studies. The effect of algae, a diet for aquatic organisms, on the effect of this binary mixture was also investigated. A two-compartment toxicokinetic (TK)-toxicodynamic (TD) modeling approach was used to quantify the Pb toxicity under these complex conditions and to develop critical parameters for understanding the mechanism of toxicity. This two-compartment modeling approach adequately described the Pb accumulation in the gut and in the rest of the body tissue under different nano-TiO₂ concentrations, with and without algae, and predicted the toxicity response of C. dubia. It indicated that increasing the nano-TiO₂ concentration reduced the Pb tolerance level and concurrently increased the killing rate constant of C. dubia. Therefore, nano-TiO₂ synergistically enhanced Pb toxicity. Algae remarkably reduced the toxicity of this binary mixture through reducing the Pb transfer rate to the body tissue and the killing rate, although it did not affect the Pb tolerance level. This two-compartment modeling approach is useful in understanding the role of nanoparticles when assessing the overall toxicity of nanoparticles and other toxic elements in the environment.     

不同聚合度的聚磷酸铵灭火性能研究*

为考察聚磷酸铵（APP）干粉灭火剂的聚合度对其灭火性能的影响,选用3种不同聚合度的APP,结合其晶体结构、粒度分布及热性能测试,并通过粉体杯式燃烧器进行小尺寸灭火实验,对比3种样品的灭火性能及灭火机理,研究聚合度与其灭火性能的关系。热性能测试结果显示,聚合度的升高会导致APP的热稳定性下降,随着聚合度从80升至1 500,其初始分解温度从326.11 ℃降低至321.54 ℃,失重率从75.21%增加至79.66%。实验结果表明:随着APP聚合度的增加,火焰降温速率升高,最小灭火浓度（MEC）降低,灭火性能增强,当聚合度为1 500时,MEC为118.143 g/m3。聚合度的升高有助于APP在进入火场后更早、更充分地与火焰发生反应,从而使灭火性能得到提升。