回灌型准好氧填埋场渗滤液中COD浓度的预测模型探讨

基于进行的室内模拟试验，推导了回灌型准好氧填埋场COD浓度计算模型，并通过模拟试验结果确定了模型参数。结果表明，模型的相关系数为0．91，该模型可用于该类填埋场COD浓度的预测。本研究可为回灌型准好氧填埋场的设计提供依据。     

染料废水生化处理研究动态

生化法处理染料废水是近年来研究的热点。综述了近年来国内外染料废水生物处理研究的进展，特别对厌氧一好氧联合处理法在脱色和COD去除中的作用、高效菌种的筛选，及其应用方面的各种新技术进行了分析和评述。     

厌氧-好氧一体化反应器处理高浓度有机废水的运行特性研究

本实验采用新型厌氧—好氧一体化反应器处理高浓度有机废水,主要研究了系统的启动与运行性能,并对系统的NH3 N去除效果作了初步考察。实验结果表明:在16℃～24℃的自然温度下,采用递增负荷、厌氧和好氧分期启动的方式,系统可在38天内达到较好的启动效果;在系统负荷运行期内,当系统总进水COD浓度平均值为3601 8mg/L,总出水COD浓度平均值为384 0mg/L,系统容积负荷平均值为2 54kgCOD/(m3·d),系统总HRT平均值为35 1h时,系统总COD去除率平均值达90 6%。实验还发现:当进水NH3 N浓度为280 3～350 7mg/L,整个系统的NH3 N去除率在68 5%～91 7%,平均为81 0%。由此说明,本反应器具有很好的COD去除性能和NH3 N去除效果,适合于处理COD浓度高且含有中等NH3 N浓度的有机废水。     

高氯低COD值水样的无汞快速测定法

以硝酸银和硫酸铬钾代替硫酸汞来消除 COD 测定中的氯离子干扰，同时将重铬酸钾溶液的浓度降低为0.100 mol／L，并用硫磷混酸代替硫酸，该方法经过对标准样品和实际样品的测定，表现出对于测定氯离子含量低于25000 mg／L的高氯低 COD 值水样具有较好的准确度和精密度，同时可以实现银盐的回收再利用。     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

Valorisation of used cooking oil sludge by codigestion with swine manure

The addition of lipid wastes to the digestion of swine manure was studied as a means of increasing biogas production. Lipid waste was obtained from a biodiesel plant where used cooking oil is the feedstock. Digestion of this co-substrate was proposed as a way of valorising residual streams from the process of biodiesel production and to integrate the digestion process into the biorefinery concept.Batch digestion tests were performed at different co-digesting proportions obtaining as a result an increase in biogas production with the increase in the amount of co-substrate added to the mixture. Semi-continuous digestion was studied at a 7% (w/w) mass fraction of total solids. Co-digestion was successful at a hydraulic retention time (HRT) of 50 d but a decrease to 30 d resulted in a decrease in specific gas production and accumulation of volatile and long chain fatty acids. The CH₄ yield obtained was 326 ± 46 l/kg VS_feed at an HRT of 50 d, while this value was reduced to 274 ± 43 l/kg VS_feed when evaluated at an HRT of 30 d. However these values were higher than the one obtained under batch conditions (266 ± 40 l/kg VS_feed), thus indicating the need of acclimation to the co-substrate. Despite of operating at low organic loading rate (OLR), measurements from respirometry assays of digestate samples (at an HRT of 50 d) suggested that the effluent could not be directly applied to the soil as fertiliser and might have a negative effect over soil or crops.     

Production costs and operative margins in electric energy generation from biogas. Full-scale case studies in Italy

The purpose of this study was to observe the economic sustainability of three different biogas full scale plants, fed with different organic matrices: energy crops (EC), manure, agro-industrial (Plants B and C) and organic fraction of municipal solid waste (OFMSW) (Plant A). The plants were observed for one year and total annual biomass feeding, biomass composition and biomass cost (€ Mg^?1), initial investment cost and plant electric power production were registered. The unit costs of biogas and electric energy (€ Sm^?3_biogas, € kW h^?1_EE) were differently distributed, depending on the type of feed and plant. Plant A showed high management/maintenance cost for OFMSW treatment (0.155 € Sm^?3_biogas, 45% of total cost), Plant B suffered high cost for EC supply (0.130 € Sm^?3_biogas, 49% of total cost) and Plant C showed higher impact on the total costs because of the depreciation charge (0.146 € Sm^?3_biogas, 41% of total costs). The breakeven point for the tariff of electric energy, calculated for the different cases, resulted in the range 120–170 € MW h^?1_EE, depending on fed materials and plant scale. EC had great impact on biomass supply costs and should be reduced, in favor of organic waste and residues; plant scale still heavily influences the production costs. The EU States should drive incentives in dependence of these factors, to further develop this still promising sector.     

不同运行模式下改良型CAST工艺处理生活污水的除磷性能

实验采用改良型CAST工艺,以生活污水为研究对象,考察了C/P、回流比及温度等不同运行模式对系统除磷性能的影响.结果表明,常温条件下进水C/P由50升至100,系统除磷率均值从15%迅速升至95.6%,除磷性能显著提高;继而降低C/P至75,除磷性能因进水碳源不足再度下降,除磷率均值为51.4%,且长期投加易降解碳源引发系统污泥膨胀并导致污泥大量流失.C/P较低情况下,回流比由25%降低至12.5%,除磷性能提高2.3倍,继续降低回流比至0,除磷性能反而下降;温度实验研究则表明,低温系统(14℃±1℃),除磷率稳定维持在90%以上,而高温短程硝化系统(27℃±1℃)除磷率仅为14.1%,可见低温更有利于系统磷的去除.吸磷小试发现,常温系统污泥以O_2、NO_3~-和NO_2~-为电子受体均能进行吸磷,而低温系统污泥能以O_2、NO_3~-为电子受体进行吸磷,高温系统污泥则仅能以O_2为电子受体进行少量吸磷.此外,实验还发现,系统短期闲置导致的污泥"饥饿"有利于系统除磷率的提高.     

去除城市生活污泥中有机络合态金属强化其厌氧生物制气

为提高城市生活污泥厌氧消化沼气产率,本文考察了通过金属络合剂EDTA预处理污泥,以去除城市生活污泥中有机络合态金属,强化其厌氧生物制气的效果.结果表明,经EDTA预处理去除金属后的污泥(实验组)较未预处理的污泥(对照组)的有机络合态金属含量减少[(5.09±0.57)%~(1.37±0.20)%,以TS计],溶解性有机质显著提高(SCOD提升627%),暗示该预处理方法能够极大地去除有机络合态金属并强化污泥有机质的溶出.通过测定污泥有机质溶出表观活化能发现,实验组污泥有机质溶出表观活化能比对照组降低36%,表明预处理能够有效降低有机质溶出反应的能量壁垒.污泥厌氧发酵研究发现,在16d的污泥厌氧产酸实验中,实验组VFAs浓度高于对照组,较对照组最大提升42%;在22 d的污泥厌氧产甲烷测试实验(BMP)中,实验组单位有机质累积甲烷产量比对照组增加48%,表明EDTA预处理对提高污泥厌氧消化产沼气具有重要的作用.通过进一步产沼气动力学研究发现,实验组的产沼气限速步骤在产甲烷阶段,而对照组限制于水解阶段,表明经EDTA预处理能有效地破除城市生活污泥厌氧消化过程的水解限速.     

高含固污泥厌氧消化中Fe/S及pH对原位抑硫效率影响及其交互作用

以城市污水处理厂高含固污泥为对象,分别进行了连续厌氧消化抑硫试验和消化污泥Fe(Ⅲ)投加抑硫试验,探讨不同Fe/S(摩尔比)对污泥厌氧消化中溶解态硫化物去除效率的影响以及Fe(Ⅲ)与pH的交互作用.结果表明,热水解污泥厌氧消化采用原位抑硫技术,在Fe/S(摩尔比)为7.75时沼气中H_2S含量可由170.4×10~(-6)降至14.09×10~(-6),无需进行后续处理;当pH为7.00~7.50、Fe/S为1~11时,pH为原位抑硫主要显著影响因子,提高消化池pH有利于降低Fe(Ⅲ)投加量;高含固污泥厌氧消化沼气满足H_2S利用标准时,所需最低Fe/S为7.0;当消化池pH低于7.30时,将无法通过调节Fe/S实现H_2S浓度达标排放.