无火源施放后超细微粒灭火剂运动特性研究

超细微粒灭火剂施放后的运动过程直接影响其灭火效果。通过数值模拟及试验研究灭火剂微粒施放后的流动、扩散和沉降等运动特性。模拟结果表明,灭火剂微粒施放后,向下运动到灭火室底部并撞击后向侧壁运动,随后向顶部运动,易在壁面及壁面底角处聚集。试验表明,微粒的运动分喷射运动和沉降扩散2个过程。前者微粒在驱动气流作用下在灭火室顶部、底部及墙壁处积聚,浓度较高。后者微粒主要受重力作用发生沉降,并在湍流气流作用下进行无规则扩散运动,导致灭火室顶部浓度最低;在灭火室垂直方向的一半高度处,浓度较高但波动剧烈;在灭火室底部,当喷射结束后有一个短暂的浓度低谷,随着微粒发生沉降,浓度逐渐升高。喷射压力对灭火剂的运动及浓度分布影响很大,压力过高或过低都会影响灭火剂微粒的全淹没灭火效果。根据试验结果,喷射压力为1.0 MPa时灭火效果较好。     

球磨铝/聚四氟乙烯的热性能和失效研究

目的 研究高活性铝/聚四氟乙烯(Al/PTFE)含能材料在常温条件下的存贮能力.方法 采用高能球磨法,制备Al/PTFE复合物,对其进行温度加速老化试验.采用差热分析方法,研究该材料在不同老化时间段的放热性能,并对其失效时间进行评估.结果 球磨制备的样品组分间的反应模式为气固相反应.干法球磨制备得到的样品具有较高的放热量和较长的贮存寿命,放热量为1.82 kJ/g,在老化时间4 a以内的放热性能损失不超过20％.湿法球磨制备得到的样品具有很高的反应活性,放热量达到2.86 kJ/g,但是老化1 a后就发生明显失效.结论 以干法球磨的样品放热能力较低,但其能够在更长的时间内保持反应活性,更加适合于长期贮存.     

改性凹凸棒土及粉末活性炭助凝聚硅硫酸铝消除微污染水中有机氯

以硅酸钠和硫酸铝为原料制备了聚硅硫酸铝絮凝剂(PASS),采用强化混凝的处理方法,对微污染水中有机氯(OCPs)的消除进行了研究.同时,考察了混凝剂投加量、pH值、原水浊度、粉末活性炭和改性凹凸棒土助凝剂等因素对OCPs消除效果的影响.结果表明:PASS投加量为5 mg·L-1时,OCPs的去除率可以达到57%~87%,浊度去除率可以达到99.1%,其效果好于聚合氯化铝(PAC);PASS混凝处理OCPs的最佳pH值范围是6~7;OCPs的去除与浊度的去除具有显著相关性,原水浊度的大小会影响OCPs的去除,低浊条件下OCPs和浊度的去除率明显低于中浊和高浊条件;粉末活性炭和改性凹凸棒土作为助凝剂与PASS复配均可显著提高OCPs的去除率,分别达到78%~100%和72%~95%.相较而言,凹凸棒土储量丰富,廉价易得,因此,以改性凹凸棒土替代粉末活性炭更有优势.     

低粉尘浓度气体中细颗粒物（PM2.5）含量的测量

低粉尘浓度气体中细颗粒物（PM2.5）的测量用称重法和计数法都有困难,文章提出用稀释气体降低含尘浓度后,用激光尘埃计数器测量其中细颗粒物的数量,计算出质量浓度的办法。     

硫粉投加量与污泥含固率之比对生物淋滤过程的影响

通过接种污泥硫细菌混合菌液,研究了S粉投加量与污泥含固率之比(SA/TS)对城市污泥中重金属生物淋滤效果的影响.结果表明,增大SA/TS值能显著缩短淋滤时间,提高淋滤效果.当SA/TS为2.5,经过8 d生物淋滤,Cu和Zn的淋滤效果可达到最佳,溶出率分别为66.2%和63.9%.淋滤进行16 d后,Pb的溶出率为30.8%.对于Cu,不论淋滤前后有机态都是较强的结合态.Zn的溶出主要是由于结合能力强的铁锰氧化态在淋滤过程中被大量浸出.Pb经过16 d的淋滤,铁锰氧化态所占比例有所下降而有机态比例上升.加大SA/TS有利于提高S粉的利用率,对N的保存影响不大,但增加了P的流失.     

High efficiency of the NH4H2PO4/Mg(OH)2 composite for guaranteeing safety of wood production

Currently, China's timber industry is in high demand with the development of real estate. However, there is a certain fire hazard in the production process of wood manufacturing. Once a fire occurs, the fire is violent and the spread is rapid. Therefore, to improve the safety of its production process, ammonium dihydrogen phosphate and magnesium hydroxide were selected to prepare a new composite superfine dry powder, which was denoted as the NH₄H₂PO₄/Mg(OH)₂ composite. Furthermore, to figure out dry powders' extinction effect on Class A fire, the wood-crib fire suppression effect of the NH₄H₂PO₄/Mg(OH)₂ composite was test, and then compared with that of ultrafine dry powder (UDP) and commercial ABC dry powder (C-ABC) in a 1 m³ chamber. Three parameters of the fire extinguishing process, namely flame extinction time, powder consumption and temperature drop were adopted to measure the fire suppression performance. The results demonstrated that UDP and C-ABC both had a larger flame extinction time and powder consumption than the NH₄H₂PO₄/Mg(OH)₂ composite. Besides, a fire (wood cribs) can be extinguished by the NH₄H₂PO₄/Mg(OH)₂ composite with the fastest temperature drop and a much-improved toxic gas suppression ability. In short, the NH₄H₂PO₄/Mg(OH)₂ composite can better guarantee the safety of the wood processing production process. Moreover, the reasons for performance advantages of the NH₄H₂PO₄/Mg(OH)₂ composite were discussed.     

The first fossil fungus gardens of Isoptera: oldest evidence of symbiotic termite fungiculture (Miocene, Chad basin)

Higher termites of the subfamily Macrotermitinae (fungus-growing termites) are known to build fungus gardens where a symbiotic fungus (Termitomyces sp.) is cultivated. The fungus grows on a substrate called fungus comb, a structure built with the termites’ own faeces. Here we present the first fossil fungus combs ever found in the world. They were extracted from 7-million-year-old continental sandstone (Chad basin). Fossilized fungus combs have an ovoid morphology with a more or less flattened concave base and a characteristic general alveolar aspect. Under lens, they display a typical millimetre-scale pelletal structure. The latter, as well as the general shape and alveolar aspect, are similar to the morphology of fungus combs from extant fungus-growing termites.     

生物活性炭在生活污水处理中的基础研究

探讨利用粒状生物活性炭（GBAC）和固定粉状生物活性炭（IPBAC）对人工废水CODMn处理的效果。结果表明,GBAC和IPBAC中微生物的生长（UV254）与运行周期密切相关。GBAC和IPBAC运行初期内,炭表面的生物膜逐步形成,微生物不稳定,从而导致UV254值波动较大。随着运行周期的延长,生物膜生长逐步趋于稳定。随着炭层高度的增长,生物活性炭对CODMn的去除率也越大。GBAC与IPBAC对CODMn都有很高的去除率,但GBAC对CODMn的去除率高于IPBAC。     

粉末冶金方法在块状雄黄制备过程As2O3气体污染防治中的应用

针对现有块状雄黄火法制备工艺As2 O3气体污染严重的情况 ,提出了利用粉末冶金方法热压工艺制备块状雄黄的“浮选 化学除杂 热压制块”新工艺流程。并对热压制块工艺进行了试验研究。试验结果表明 ,在较佳工艺条件下可以制备出符合药用要求的较致密的块状雄黄 ,且该工艺不会造成As2 O3气体污染。     

漂白粉和敌百虫对净化养鱼水生物膜活性的影响

以附着在固体表面的生物膜为材料,实验研究了渔药漂白粉和敌百虫对其菌类数量及活性的影响。通过分析生化需氧量(BOD5)的曲线,测定实验前后细菌、放线菌、真菌的数量和水中化学需氧量(CODMn)、铵氮(NH+4-N)的质量浓度,并用电子显微镜观察。结果表明:ρ(漂白粉)小于6 17mg L,生物膜的活性能够恢复;ρ(漂白粉)为0 7mg L时,15d后生物膜的活性可恢复80%以上。在实验浓度范围内,虽然敌百虫对生物膜的活性和水质净化能力影响不明显,但也应谨慎使用以防止污染环境。