复极性三维电极处理含酚废水的研究

实验研究了模拟含酚废水(100～500mg／L)在复极性三维电解槽中的电化学氧化过程。考察了电解时间、电解电压、支持电解质浓度、pH值及苯酚初始浓度对苯酚去除效果的影响，并确定适宜的反应条件。实验表明，在填充较少粒子的条件下，通入空气而处于分散悬浮状态的填充粒子可以综合利用阳极的直接氧化作用、阳极产生羟基自由基的间接氧化作用及阴极产生过氧化氢的间接氧化作用，从而在较低能耗的情况下，充分提高填充粒子的利用率，达到较好的苯酚降解效果。     

一种新型石墨电极的制备及其对苯酚的去除

为了探索一种对有机废水处理有效、廉价、来源广泛、环境友好的电极,以石墨、环氧树脂、固化剂和丙酮为原料,研究制备了一种新型石墨电极 (NGE). 分别采用热水浸泡、乙醇溶液回流、丙酮回流、超声-丙酮回流以及电化学法对制备的石墨电极进行预处理,前三者效果较差,超声-丙酮回流可改善处理效果,但不够理想,电化学法可取得满意的效果.苯酚降解的UV光谱分析表明,尽管商品石墨电极 (CGE) 比NGE具有更高的苯酚氧化效率,但其电解液积累大量的苯醌,而NGE电解液中苯醌积累量少,并且电解过程中逐渐降低. NGE比CGE具有更好的TOC去除效果,两者TOC去除率分别为40%和31%. SEM分析结果表明,CGE被严重腐蚀,NGE无明显变化,表现出良好的稳定性.     

聚噻吩改性阴极强化电极生物膜反应器去除硝酸盐机制研究

为进一步提高电极生物膜反应器的脱氮效能,采用导电聚合物聚噻吩(PTh)和电子穿梭体蒽醌-2,6-二磺酸二钠(AQDS)改性阴极材料石墨毡,系统研究了不同碳氮比(C/N)条件下,改性电极的应用对BER体系的脱氮效能、电极表面生物相和体系微生物群落结构等方面的影响.结果表明,应用PTh与AQDS协同处理石墨毡的BER体系的NO~-_3-N去除速率和效能均明显优于未处理电极体系,在HRT=4 h、C/N为2.0时NO~-_3-N的去除率达到90.0%以上.PTh/AQDS改性石墨毡电极的生物膜与电极的比重为0.26±0.04,其值为对照组的2.4倍,证明了PTh/AQDS改性后电极具有更优的生物相容性.应用PTh/AQDS改性电极的BER具有更好的微生物丰富度和多样性,AQDS促进了特定微生物Thauera_mechernichensis(24.6%)的富集和亚硝酸盐还原酶的活性,保障了BER体系的反硝化效能.     

利用玉米浸泡液产电的微生物燃料电池研究

以玉米淀粉生产过程中的浸泡液（玉米浸泡液）作为接种液和基质,利用“三合一”膜电极的单室空气阴极微生物燃料电池进行试验,采用在线监测电压和废水分析方法对产电功率和化学需氧量（COD）、氨氮进行测定,探讨高COD、高氨氮有机废水产电及废水处理的可行性.结果表明,经过94 d（1个周期）的连续运行（固定外电阻为1 000 Ω）,17 d时输出电压达到最大（525.0 mV）,稳定期最大输出功率可达169.6 mW/m²,此时电池相应的电流密度为440.2 mA/m²,内阻约为350 Ω,开路电压619.5 mV;但燃料电池电子利用效率较低（库仑效率为1.6%）;1个周期结束时浸泡液的COD去除率达到51.6%,氨氮去除率25.8%.本试验利用玉米浸泡液成功获得电能,同时对浸泡液有效地进行了处理,为其资源化利用提供新途径.     

Effects of particle thermal characteristics on flame microstructures during dust explosions of three long-chain monobasic alcohols in a half-closed chamber

To reveal clearly the effects of particle thermal characteristics on flame microstructures during organic dust explosions, three long-chain monobasic alcohols, solid at room temperature and similar in physical-chemical properties, were chosen to conduct experiments in a half-closed chamber. In the experiments, the dust materials were dispersed into the chamber by air to form dust clouds and the hybrids were ignited by an electrical spark. A high-speed optical schlieren system was used to record the flame propagation behaviors. A fine thermocouple and an ion current probe were respectively used to measure the flame temperature profile and the reaction behaviors of the combustion zone. Based on the experimental results, combustion behaviors and flame microstructures in dust clouds with different thermal characteristics were analyzed in detail. As a result, it was found that the dust flame surfaces were completely covered by cellular structures that significantly increased the flame frontal areas. Flame propagated more quickly and the number of the cellular cells increased as increasing the volatility of the particles. On the contrary, maximum temperature and the thickness of the preheated zone decreased as increasing the volatility of the particles. According to the ion current profile, the particles in the preheat zone were pyrolyzed to intermediate radicals and the radicals' fraction in the higher volatile dust flame was higher than that in the lower volatile dust flame.     

焙烧温度对CeO_2(ZrO_2)/TiO_2选择性催化脱硝性能的影响

采用溶胶-凝胶法并以不同温度焙烧制备一系列CeO_2(ZrO_2)/TiO_2(CZT)催化剂,考察了CZT催化剂固相结构、酸量、比表面积等性能与催化活性的关系。采用XRD、BET、NH3-TPD、H2-TPR以及XPS等表征技术对催化剂进行表征。结果表明:焙烧温度为450℃时CZT催化剂具有最高的催化活性,其在240~400℃的温度窗口内活性均高于90%,且具有较好的抗水和抗硫中毒能力。随着焙烧温度的提高,催化剂表面的Ce和Zr原子进入体相晶格且Ce0.5Zr0.5O2向Ce0.75Zr0.25O2转变,导致催化剂的储释氧能力和氧化还原性能降低。另外,锐钛矿和金红石型TiO_2晶粒尺寸的增加,催化剂的有效比表面积和总酸量降低,因此CZT催化活性随着焙烧温度的提高而有所降低。换言之,大的比表面积、良好的氧化还原性能、表面Ce4+的富集以及酸性位的增多均有利于NH3-SCR活性的提高。     

Pd-MnO2 nanoparticles/TiO2 nanotube arrays (NTAs) photo-electrodes photo-catalytic properties and their ability of degrading Rhodamine B under visible light

Pd-MnO_2/TiO_2 nanotube arrays(NTAs) photo-electrodes were successfully fabricated via anodization and electro deposition subsequently; the obtained Pd-MnO_2/TiO_2 NTAs photo electrodes were analyzed by scanning electron microscopy(SEM), X-ray diffraction(XRD) and characterized accordingly. Moreover, the light harvesting and absorption properties were investigated via ultraviolet–visible diffuse reflectance spectrum(DRS); photo degradation efficiency was investigated via analyzing the photo catalytic degradation of Rhodamine B under visible illumination(xenon light). The performed analyses illustrated that Pd-MnO_2 codoped particles were successfully deposited onto the surface of the TiO_2 nanotube arrays;DRS results showed significant improvement in visible light absorption which was between400 and 700 nm. Finally, the photo catalytic degradation efficiency results of the designated organic pollutant(Rhodamine B) illustrated a superior photocatalytic(PC) efficiency of approximately 95% compared to the bare TiO_2 NTAs, which only exhibited a photo catalytic degradation efficiency of approximately 61%, thus it indicated the significant enhancement of the light absorption properties of fabricated photo electrodes and their yield of UOH radicals.     

氨对垃圾焚烧飞灰浸出特性的影响及地球化学模拟

垃圾焚烧飞灰可能因为选择性非催化还原法(SNCR)脱硝过程中氨泄漏、垃圾携带的渗滤液受热挥发等原因而吸附氨.本研究中采用人为添加氨水,在pH为3.66～12.44范围内,研究氨对飞灰中溶解性有机碳(DOC)和重金属浸出的影响,并利用地球化学模拟软件Visual MINTEQ从金属化学形态分布上分析氨对飞灰浸出的影响机制.结果表明,DOC在pH>9和有高浓度氨(≥1 357 mg·L-1)存在时,其浸出量大幅增加,而在浸出液中氨的水平不高于537 mg·L-1时则受氨的影响很小;在pH<6时,飞灰中各金属主要以自由态的金属离子和金属-氯络离子形态大量溶出,且受氨的影响较小;而在pH为8～12的碱性环境中和氨浓度较高时(≥3 253 mg·L-1),氨与金属生成了可溶性的金属-氨配合物,能显著增加Cd、Cu、Ni、Zn的浸出,且在pH=9附近时浸出量达到最大值,但氨对Al和Pb的浸出影响甚微;在pH>12时,Cd、Cu、Ni、Zn主要以羟基金属离子形式存在.在氨浓度为3 253 mg·L-1时,通过利用Visual MINTEQ模拟浸出值与试验数据的对比,发现Al、Pb、Zn的浸出主要由溶解/沉淀模型控制,而Cd、Cu、Ni由溶解/沉淀模型和表面吸附反应模型同时控制,且Visual MINTEQ模型能较好地预测飞灰中Al、Cu、Pb、Zn的浸出特性.     

适用于废水处理的DSA电极的研究进展

电化学氧化技术因其具有氧化能力强、可控性高、运行费用低及对环境友好的特点,引起了人们极大的关注.处于核心地位的DSA（Dimensionally Stable Anodes）电极是电化学工作者研究的重点.Ti基氧化铅、氧化铱、锡锑氧化物等电极是目前最有研究价值的DSA电极,文章介绍了这些电极的一些最新的研究成果.     

适用于废水处理的DSA电极的研究进展

电化学氧化技术因其具有氧化能力强、可控性高、运行费用低及对环境友好的特点,引起了人们极大的关注。处于核心地位的DSA（Dimensionally Stable Anodes）电极是电化学工作者研究的重点。Ti基氧化铅、氧化铱、锡锑氧化物等电极是目前最有研究价值的DSA电极,文章介绍了这些电极的一些最新的研究成果。