Reconsideration on the effect of nitrogen on mixed culture polyhydroxyalkanoate production toward high organic loading enrichment history

Effect of nitrogen on mixed culture PHA production was reconsidered. Enrichment history of PHA accumulating culture was discussed. Higher PHA content and biomass growth were achieved in presence of nitrogen. Enrichment strategy toward higher PHA accumulation was investigated. Microbial community succession in PHA accumulation phase was investigated. In most of the operating strategies for mixed microbial cultures polyhydroxyalkanoate (PHA) production, moderate organic loads and low nitrogen concentrations are used, however, the real waste streams contain variable concentrations of carbon and nitrogen. To evaluate the effect of enrichment history on PHA producer and production the various carbon and nitrogen levels were utilized during the accumulation phase. Different operating strategies were applied in three sequencing batch reactors (SBRs) subjected to aerobic dynamic feeding. The maximum PHA production of the enriched cultures under nutrient excess, limitation and starvation (Cmol/Nmol ratio of 8, 40 and ∞, respectively) was evaluated in batch assays. A higher PHA content and biomass growth were achieved in the nutrients presence in comparison to the nutrient starvation condition. The cultures from the SBR treated under short sludge retention time, high organic loading rate, short cycle length (SBR#3) and nutrient excess reached the maximum PHA content (54.9%) and biomass increase (38.9%). Under nutrient limitation, the negative biomass growth was observed under nutrient starvation because of the sampling loss. The succession of microbial communities in SBRs and batch assays was analyzed using terminal restriction fragment length polymorphism. The SBR#3 had the best overall PHA production performance considering its high PHA content and productivity in all nutrient content, it indicates that nitrogen has a substantial impact on PHA yield especially when high organic loading rate enrichment history is involved.     

Carbon nanotubes-incorporated MIL-88B-Fe as highly efficient Fenton-like catalyst for degradation of organic pollutants

CNTs were incorporated into MIL-88B-Fe to get a new Fenton-like catalyst (C@M). Fe(II) was introduced in C@M to get a fast initiation of Fenton-like reaction. Fe(II) content in C@M was related with oxygen-containing functional groups on CNTs. C@M shows efficient catalytic degradation of pollutants over a wide pH range. Iron-based metal organic frameworks have been verified to be efficient heterogeneous Fenton catalysts due to their open pore channels and highly uniform distribution of metallic centers. In these catalysts, however, the iron element is mainly in the form of Fe(III), which results in a process required to reduce Fe(III) to Fe(II) to initiate Fenton reaction. To address this problem, carbon nanotubes (CNTs) with electron-rich oxygen-functional groups on the surface were incorporated into the metal organic frameworks (MIL-88B-Fe) to improve Fe(II) content for an enhanced Fenton-like performance. The prepared CNT@MIL-88B-Fe (C@M) showed much stronger catalytic ability toward H₂O₂ than MIL-88B-Fe. The pseudo-first-order kinetic constant for phenol degradation by C@M (0.32 min^–1) was about 7 times that of MIL-88B-Fe, and even higher than or comparable to the values of reported heterogeneous Fenton-like catalysts. Moreover, the Fenton-like system could effectively degrade various kinds of refractory organic pollutants and exhibited excellent catalytic activity over a wide pH range (4–9). XPS analysis confirmed that Fe(II) content of the catalyst gradually increased with CNT loadings. Electron spin resonance analysis showed that the signal intensity (•OH) of C@M was much higher than MIL-88B-Fe, which was consistent with the degradation efficiency of pollutants. Furthermore, the Fe(II) content of the catalyst gradually increased along with the oxygen-functional group content of CNTs. The result demonstrated that oxygen-containing functional groups of CNTs have a significant impact on the enhanced catalytic performance of C@M. This study provides a new insight to enhance Fenton reaction by using nanocarbon materials.     

Enhancing the adsorption function of biochar by mechanochemical graphitization for organic pollutant removal

• Mechanochemical treatment reduced the calcination temperature for biochar synthesis. • Biochar is converted to graphite after mechanochemical treatment. • Biochar was reduced to nanoscale after mechanochemical treatment. Biochar (BC) has been extensively studied as adsorbent for the treatment of water pollution. Despite the distinct advantages, the high calcination temperature and low adsorption capacity of pristine BC limit its practical applications. Most of the former studies focused on the structure and/or surface modification to improve the adsorption capacity of BC. However, the harsh experiment conditions involved in the biochar modification limited the application in industrial level. Herein, we introduced mechanical treatment into BC preparation to reduce the calcination temperature and improve the adsorption capacity simultaneously. The results indicated that the calcination temperature was reduced and the adsorption capacity of the treated BC was improved after mechanochemical treatment. Characterization of the samples disclosed that BCs were graphitized with the particle size reduced to nanoscale after treatment. Adsorption tests indicated that the mechanochemically treated BCs showed much better removal performance of organic contaminants than that of pristine BCs. For instance, among four pristine BCs (BC600, BC700, BC800, and BC900), only BC900 has strong adsorption capacity for MB, while BC600 has low adsorption capacity (1.2 mg/g). By comparison, the adsorption capacity of MB increased greatly to 173.96 mg/g by BC600-500/1 (treated at 500 r/min for 1 hour). To optimize the mechanochemical treatment, the effects of rotation speed and agitation duration were also investigated.     

基于VOCs有机废气处理技术研究进展

随着经济的不断发展,环境污染因素的种类越来越多,而且危害性也在逐渐提升。其中有机废气在人类社会不断发展的背景下产生量排放量都越来越高,如果不进行处理将对环境和人体都造成极其严重的影响。本文主要对基于VOCs有机废气处理技术的相关研究作了分析,希望对有机废气的处理有一定促进作用。     

有机物料与~(32)P标记过磷酸钙混合施用对磷有效性的影响

本试验利用~(32)P示踪法研究赤红壤上两种有机物料与过磷酸钙混合施用对磷有效性的影响。盆栽试验表明,纸厂废料蔗渣或猪粪与磷肥混合施用比磷肥单独施用更有利于提高格拉姆柱花草的含磷量和总吸磷量。单位施磷量引起的土壤有效磷和植株吸磷量的增加量也是有机物料单施或与磷肥混施高于磷肥单施。在前39d,~(32)P标记过磷酸钙的利用率在单独施用时为2.14％,比混合施用高一倍左右;在80d时,混合施用的磷利用率较快提高,蔗渣与磷肥混施处理超过单独施用,达22.88％。     

分光光度法测定水稻土中有机酸的研究

本文以三种有机酸为代表,研究并建立了测定水稻土中有机酸的分光光度法。结果表明,三种有机酸的有色络合物具有相同的吸收光谱,且具有相同的最大吸收波长(λ_(mss)=500um)和相近的表观摩尔吸光系数。水分对酯化反应影响很大,含水量达4ml时,吸光值下降85％。酯化温度在10℃以上时,酯化率达最大值且保持稳定。在25℃时,显色反应20min趋干稳定,且在1h内吸光值下降不超过1.2％。土样中的有机酸采用NaCl溶液为提取剂,以3:1的液土比振荡提取30min,NaCl溶液浓度为1％就能达到良好的提取、过滤效果。提取液在烘干前需进行碱化,否则有机酸将损失30％以上。本法平均回收率为92.2％(n=5),标准差为0-0.0478cmol k8~(-1)(n=2-6),平均0.0142cmol kg~(-1)(n=26);变异系数为0—10％(n=2-6),平均4.87％(n=26);线性范围为0—0.0018mol L~(-1)。     

It's a dirty job but someone has to do it: The role of marine benthic macrofauna in organic matter turnover and nutrient recycling to the water column

Benthic macrofaunal populations through their feeding, bioturbation, burrow construction and sediment irrigation activities have profound influences on organic matter inputs to marine sediments (biodeposition) and on the vertical distribution of deposited organic matter within the sediment. These effects in turn influence the rates and pathways of organic matter mineralisation, and element cycles. Similarly, bioturbation, burrow construction and burrow irrigation are major determinants of sediment-water column fluxes of oxygen and nutrients.

In this review, I discuss the influences of the different benthic macrofaunal feeding (functional) groups on mineralisation processes and sediment-water column fluxes of particulate and dissolved nutrients. How these effects influence diagenic processes, the balance between aerobic and anaerobic processes, and the redox status of the surficial sediments. Finally, I discuss some of the limitations of the predominantly laboratory techniques which have been used to study “macrofaunal effects” and how this hinders the inclusion of the effects in quantitative sediment biogeochemical models.     

Grazing as a measure against grass encroachment in Dutch dry dune grassland: effects on vegetation and soil

A grazing experiment was started in 1984 and 1989 respectively, in two parts of a dune grassland in the nature reserve ‘Zwanenwater’, North Holland; a third part with similar geology and topography was used as a control area and not grazed. An evaluation of the effects of grazing on vegetation patterns, species composition, vegetation structure and humus form was made with the help of vegetation maps from 1986 and 1992 as well as field surveys. Dense tall-grass communities dominated byAmmophila arenaria increased over the period 1986–1992 in the grazed areas, and especially in the non-grazed area (increase in area to 20%, 22% and 50%, respectively). Open communities decreased in the grazed areas, but are still prevalent, while in the ungrazed area they virtually disappeared, with the result that the present percentage areas are 53%, 38% and 17%. Field survey data were classified by TWINSPAN producing four vegetation types. These occur more or less equally in grazed and ungrazed areas, albeit with different percentage areas: (1) open vegetation dominated byCorynephorus canescens; (2) open vegetation characteized, byKoeleria macrantha; (3) heathland dominated byEmpetrum nigrum; and (4) tall-grass communities dominated byAmmophila arenaria. Within a vegetation type, species composition was only marginally affected by grazing regime. Within the open communities the number of species, vegetation height, vegetation cover and soil organic horizons were not affected by grazing. In the tall-grass communities the number of species was significantly larger and the height of the vegetation significantly lower in the area grazed since 1984. In the heathland community the number of species and cover of the moss layer were significantly higher in the 1984 area and ectorganic and endorganic horizons significantly thicker in the ungrazed area. It is suggested that these effects are the result of an increased availability of light, but possibly also of a decreased stock of organic matter and nutrients, due to a decreased input of litter and accelerated rates of decomposition.     

High Cu and Cd pollution in sediments from Sisimiut, Greenland. Adsorption to organic matter and fine particles

High concentrations of Cu of up to 200 mg/kg, and Cd of up to 4.0 mg/kg, were found in sediments from the aquatic environment around Sisimiut, Greenland. These concentrations are four times higher than the limiting concentration where toxicological effects are expected. The pollution could be linked to human activities in Sisimiut, a link that have not been investigated previously in Greenland. Except from the most polluted samples there was good correlation between heavy metal concentration and organic matter. Also some relationship between fine fraction and heavy metal concentration was observed.     

POLLUTION THREATS IN THE MEDITERRANEAN SEA: AN OVERVIEW

This overview summarises the present knowledge on major sources of pollution, which are of concern for the Mediterranean Sea. Eutrophication, red tides, organic loads, hydrocarbon spills, heavy metal contamination and their biological effects are described on the light of the ecological characteristics of the Mediterranean. In particular special attention is paid to the "new pollution" processes; i.e. , the introduction of novel substances with biological activity that might have synergetic effects with "classical pollutants". Different compartments and marine ecosystems are considered and compared. The degree of anthropogenic impact and its apparent trends are discussed. Possible monitoring plans and remedial actions for a sustainable management of coastal zones subjected to increasing pollution are also suggested.