气相和颗粒物中邻苯二甲酸酯的采样与检测技术

对邻苯二甲酸酯的性质及其在环境空气中的存在状态、样品采集技术与分析方法进行了综述,侧重介绍了样品的采集、净化、采样效率和采样与分析全过程的质量控制。     

液相色谱法测定环境空气中酞酸酯类

制作了半挥发性有机物中流量采样装置,使用超细玻璃纤维滤膜采样,反相液相色谱法测定环境空气中酞酸酯类,并对样品净化方式、目标化合物在气相和颗粒物上的分布规律及采样器的捕集效率进行了试验.方法在0.50 mg/L～50.0 mg/L之间线性关系良好,当浓缩体积为1.0 mL、采样体积为144 m3时,目标化合物的检出限为0.4×10-3 μg/m3～6.0×10-3 μg/m3;当采样体积为6 m3时,检出限为0.008 μg/m3～0.145 μg/m3.     

呼和浩特市大气中酞酸酯的初步研究

通过对呼和浩特市不同功能区和不同季度的大气中酞酸酯污染物的采样监测调查，证实了酞酯不仅存在于大气中，且浓度比较高，为５３１ｎｇ／ｍ＾３，是草原地区背景值（１０－３３ｎｇ／ｍ＾３）的１６倍以上。根据调查表明，不同功能区中大气中酞酸酯（ＤＮＢＰ和ＤＥＨＰ）的浓度差异较大；相同功能区的不同季节，酞酸酯浓度也存在较大差异，但酞酸酯浓度与大气颗粒物呈现出良好的相关性，冬、夏季的相关系数分别为０．９７１和０．     

酞酸酯对人与环境的危害

酞酸酯是一种增塑剂，随着时间的推移，可由塑料中转移到外环境，现已成为地球上最为广泛存在的环境污染物。该文较系统地介绍了酞酸酯的理化性质，毒性和致癌作用，以及其对环境的影响，环境行为，动物的吸收，分布、代谢和排泄等等，最后还对酞酸酯的有关毒性评价作了部分介绍。     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

Communication ecology of webbing clothes moth: 4. Identification of male- and female-produced pheromones

Summary. We investigated the hypothesis that aggregation signals produced by male webbing clothes moths (WCM), Tineola bisselliella (Hum.) (Lepidoptera: Tineidae), and close-range male attractant signals produced by females have a pheromonal basis, at least in part. Gas chromatographic-electroantennographic detection (GC-EAD) and GC-mass spectrometric analyses of bioactive methanolic extracts of male WCM disclosed three candidate pheromone components: hexadecanoic acid methyl ester (16:Ester), (Z)-9-hexadecenoic acid methyl ester (Z9—16:Ester), and octadecanoic acid methyl ester (18:Ester). In bioassay experiments in a large Plexiglas™ arena, a blend of synthetic 16:Ester plus Z9—16:Ester was attractive to male and virgin (but not mated) female WCM; the 18:Ester was inactive. GC-EAD analyses of pheromone gland extracts from female WCM revealed (E,Z)-2,13-octadecadienal (E2Z13—18:Ald) and (E,Z)-2,13-octadecadienol (E2Z13—18:OH) as candidate sex pheromone components. In arena bioassay experiments, 1—5 female equivalents of synthetic E2Z13—18:Ald (0.2 ng) and E2Z13—18:OH (0.1 ng) were more attractive to male WCM than were two virgin female WCM. We anticipate that the combination of aggregation and sex pheromones, male-produced sonic aggregation signals, and habitat-derived semiochemicals will be highly effective in attracting male and female WCM to commercial traps. Received 12 January 2001; accepted 8 June 2001.     

Pollution levels and characteristics of phthalate esters in indoor air of offices

The pollution status and characteristics of PAEs (phthalate esters) were investigated in indoor air of offices, and PAEs of both gas-phase and particulate-phase were detected in all the samples. The concentration (sum of the gas phase and the particulate phase) was 4748.24 ng/m³, ranging between 3070.09 and 6700.14 ng/m³. Diethyl phthalate, dibutyl phthalate, and di(2-ethylhexyl) phthalate were the most abundant compounds, together accounting for 70% of the Σ6PAEs. Dividing the particulate-phase PAEs into four size ranges (<2.5, 2.5-5, 5-10, >10 μm), the result indicated that PAEs in PM_2.5 were the most abundant, with the proportion of 72.64%. In addition, the PAE concentration in PM_2.5 correlated significantly with the total particulate-phase PAEs (R² = 0.85). Thus, the amount of PAEs in PM_2.5 can be estimated from the total amount of particulate-phase PAEs using this proportion. In a comparison between the offices and a newly decorated study room, it was found that pollution characteristics were similar between these two places. Thus, it is implied that the PAE concentration decreased by 50% 2 yr after decorating.     

Pollution levels and characteristics of phthalate esters in indoor air of offices

The pollution status and characteristics of PAEs(phthalate esters) were investigated in indoor air of offices, and PAEs of both gas-phase and particulate-phase were detected in all the samples. The concentration(sum of the gas phase and the particulate phase) was4748.24 ng/m3, ranging between 3070.09 and 6700.14 ng/m3. Diethyl phthalate, dibutyl phthalate, and di(2-ethylhexyl) phthalate were the most abundant compounds, together accounting for 70% of the ∑ 6PAEs. Dividing the particulate-phase PAEs into four size ranges( 2.5, 2.5–5, 5–10, 10 μm), the result indicated that PAEs in PM2.5were the most abundant,with the proportion of 72.64%. In addition, the PAE concentration in PM2.5correlated significantly with the total particulate-phase PAEs(R2= 0.85). Thus, the amount of PAEs in PM2.5can be estimated from the total amount of particulate-phase PAEs using this proportion. In a comparison between the offices and a newly decorated study room, it was found that pollution characteristics were similar between these two places. Thus, it is implied that the PAE concentration decreased by 50% 2 yr after decorating.     

Pollution levels and characteristics of phthalate esters in indoor air in hospitals

The concentrations of phthalate esters(PAEs) in Chinese hospitals were investigated by simultaneously determining concentrations of gas- and particle-phase PAEs. PAEs were detected in two third-class first-grade hospitals, two second-class first-grade hospitals, and a community health service center. Hospital drugstores had the highest concentration(24.19 μg/m3), which was 1.54 times that of newly decorated houses. The second highest concentration was found in the transfusion rooms, averaging 21.89 μg/m3; this was followed by the concentrations of PAEs in the nurse's workstations, the wards, and the doctor's offices, with mean concentrations of 20.66, 20.0, and 16.92 μg/m3, respectively. The lowest concentrations were found in the hallways(16.30 μg/m3). Of the six different kinds of PAEs found, major pollutants included diethyl phthalates, dibutyl phthalates, butylbenzyl phthalates and di(2-ethylhexyl) phthalates, comprising more than 80% of all PAEs present.Meanwhile, a comparison between different wards showed that PAE concentrations in the maternity wards were 1.63 times higher than in the main wards. Based on known health hazards, our results suggest that the PAEs seriously influence the health of the pregnant women and babies; therefore, it is of great importance to take the phthalate concentrations in hospitals into consideration. In addition, hospital indoor air was more seriously contaminated than the air of newly decorated houses.     

Occurrence and migration of microplastics and plasticizers in different wastewater and sludge treatment units in municipal wastewater treatment plant

● Reduce the quantifying MPs time by using Nile red staining. ● The removal rate of MPs and PAEs in wastewater and sludge were investigated. ● MPs and PAEs were firstly analyzed during thermal hydrolysis treatment. ● The removal of PAEs from wastewater and sludge was mainly biodegradation. Microplastics (MPs) and plasticizers, such as phthalate esters (PAEs), were frequently detected in municipal wastewater treatment plants (MWTP). Previous research mainly studied the removal of MPs and PAEs in wastewater. However, the occurrence of MPs and PAEs in the sludge was generally ignored. To comprehensively investigate the occurrence and the migration behaviors of MPs and PAEs in MWTP, a series of representative parameters including the number, size, color, shape of MPs, and the concentrations of PAEs in wastewater and sludge were systematically investigated. In this study, the concentrations of MPs in the influent and effluent were 15.46±0.37 and 0.30±0.14 particles/L. The MP removal efficiency of 98.1% was achieved and about 73.8% of MPs were accumulated in the sludge in the MWTP. The numbers of MPs in the sludge before and after digestion were 4.40±0.14 and 0.31±0.01 particles/g (dry sludge), respectively. Fourier Transform Infrared Spectroscopy (ATR FT-IR) analysis showed that the main types of MPs were polyethylene terephthalate (PET), polypropylene (PP), polyethylene (PE), and polystyrene (PS). Six PAEs, including phthalate (DMP), diethyl phthalate (DEP), diisobutyl phthalate (DIBP), ortho dibutyl phthalate (DBP), butyl benzyl phthalate (BBP), and bis(2-ethyl) hexyl phthalate (DEHP), were detected in the MWTP. The concentrations of total PAEs (ΣPAEs) in the influent and effluent were 76.66 and 6.28 µg/L, respectively. The concentrations of ΣPAEs in the sludge before and after digestion were 152.64 and 31.70 µg/g, respectively. In the process of thermal hydrolysis, the number and size of MPs decreased accompanied by the increase of the plasticizer concentration.