SO2在碳钢初期大气腐蚀中的作用

通过自建的模拟大气腐蚀系统,借助金相显微镜、扫描电镜(SEM/EDX)、X-射线衍射(XRD)和x-射线光电子能谱(XPS),研究了SO2对碳钢初期大气腐蚀行为的影响,并进一步用原子力显微镜从更微观的角度观察了在SO2环境中初期阶段腐蚀形貌变化.研究结果表明:在SO2污染大气环境中,随SO2浓度的升高碳钢腐蚀加快.在体积分数为5×10(-6)SO2的大气环境中,碳钢和耐候钢表面腐蚀主要以条状物生长,随着SO2浓度的升高,腐蚀产物的形貌发生改变,在体积分数为5×10(-5)SO2的大气环境中,条状锈和胞状锈同时生长.在锈层中S元素以FeSO4·4H2O的形式存在,腐蚀产物中还有γ-FeOOH.SO2在初期阶段加速了碳钢的腐蚀,降低了碳钢的耐蚀性.     

Treatment of 2-phenylamino-3-methyl-6-di-n-butylaminofluoran production effluent by combination of biological treatments and Fenton＇s oxidation

High strength refractory organic stream is produced during the production of 2-phenylamino-3-methyl-6-di-n-butylaminofluoran （One Dye Black 2, abbr. ODB 2）, a novel heat-sensitive material with a promising market. In this study, a combination of acidificationprecipitation, primary biological treatment, Fenton＇s oxidation and another biological treatment was successfully used for the removal of COD from 18000-25000 mg/L to below 200 mg/L from the ODB 2 production wastewater in a pilot experiment. A COD removal of 70%-80% was achieved by acidification-precipitation under a pH of 2.5-3.0. The first step biodegradafion permitted an average COD removal of 70% under an hydraulic residence time （HRT） of 30 h. By batch tests, the optimum conditions of Fenton＇s oxidation were acquired as： Fe^2＋ dose 6.0 mmol/L; H2O2 dose 3000 mg/L; and reaction time 6 h. The second step biological treatment could ensure an effluent COD below 200 mg/L under an HRT of 10 h following the Fenton＇s treatment.     

纳米TiO_2光催化降解酸性红B的实验研究

采用偶联剂法在聚丙烯多面球表面负载化纳米TiO2,在高压汞灯照射下,以酸性红B染料为研究对象,采用光催化氧化法进行降解处理;研究了溶液初始浓度、H2O2和Fe3+投加量、pH以及光照强度等因素对酸性红B染料降解效果的影响。     

天津市环境空气SO2污染现状及分析

天津环境空气SO2的年均浓度始终超过国家二级标准。年均浓度超标主要因为采暖期SO2浓度过高所至，采暖期SO2平均浓度是非采暖期浓度的3倍左右；在2002--2005年的三个采暖期里，SO2污染逐年加重，导致了年均SO2浓度的逐年升高。天津SO2污染与采暖期增多的低烟囱排放、不利的气象条件有关，也与流动源的隐性排放、能源利用效率低下有关。结合天津经济发展速度、每年煤耗增量、现有环境治理手段来做预测，空气SO2浓度要在未来几年内达到国家二级标准仍是不可能的。     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

考虑环空压力的生产套管CO2腐蚀速率预测

目的 预测考虑环空压力条件下不同产量、温度变化碳钢套管的腐蚀速率.方法 利用优化的经典半经验模型对碳钢套管的腐蚀速率进行预测.明确海洋环境碳钢套管CO2腐蚀的机理,找出海水中生产套管发生腐蚀的主要影响因素及腐蚀机理,通过CO2溶解度模型优化腐蚀速率预测模型,考虑温度、环空压力、产量等变化对腐蚀的影响规律,预测生产套管的腐蚀速率.结果 计算了产量变化后环空的压力分布,产量越大,环空压力相对越大,但产量增大到一定值后,环空压力的增加不再明显.产量会影响环空的温度分布,而温度的变化又关系着热膨胀压力,影响套管的腐蚀速率.通过高温高压室内腐蚀实验验证了腐蚀预测模型的可靠性,对比实验结果 ,模型的预测误差在10％以内,满足现场腐蚀预测需要.结论 产量、温度、CO2溶解度、环空压力等因素均对腐蚀有较大影响,考虑环空压力变化条件下生产套管总体的腐蚀速率远超NACE标准中度腐蚀的0.125 mm/a,需要采取一定的缓蚀措施.     

不同种类有机肥施用对稻田CH4和N2O排放的综合影响

以麦茬稻田为对象,研究基肥施用不同有机肥对稻田CH4和N2O排放的综合影响.结果表明:有机肥施用对稻田CH4和N2O排放的季节变化模式无明显影响,但影响其排放量.与施用化肥(化肥处理)相比,施用菜饼+化肥(菜饼处理)促进CH4和N2O的排放,其季节排放总量分别增加了252%和22%;施用小麦秸秆+化肥(秸秆处理)和牛厩肥+化肥(牛厩肥处理)明显增加CH4排放,增加量分别为250%和45%,同时却减少N2O排放,分别减少18%和21%;施用猪厩肥+化肥(猪厩肥处理)降低CH4和N2O的排放,分别降低4%和18%.对CH4和N2O排放的综合温室效应分析表明,菜饼和秸秆处理的全球增温潜势(GWP)约为化肥处理的2.5倍,牛厩肥和化肥处理基本持平,但施用猪厩肥可减少10%～15%.各处理的GWP从高到低依次为菜饼、秸秆、牛厩肥、化肥和猪厩肥.单位产量的GWP以秸秆处理最高,菜饼次之,牛厩肥比化肥处理略高,猪厩肥处理最低.从本生长季来看,猪厩肥的施用对于实现环境效益与生产效益的协调发展具有一定作用.     

太湖水-气界面CO2交换通量观测研究

基于2003-01～2005-06利用静态箱法对太湖水-气界面CO₂交换通量的观测,对太湖水-气界面交换通量的变化特征进行了分析研究.结果表明:太湖水-气界面CO₂交换通量存在明显的日变化,春、夏、秋、冬4季日平均通量分别为-0.79mg/(m²·h)、-4.89 mg/(m²·h)、-4.06 mg/(m²·h)和-2.56 mg/(m²·h),太湖均是CO₂的汇.一般污染越重的区域,CO₂通量值越大.藻型湖区水-气界面CO₂交换通量季节变化不明显,草型湖区水-气界面CO₂交换通量季节变化很明显,夏秋季高,冬春季低.CO₂通量变化的可能相关因子还有天气情况、太阳辐射、风速及水温、pH、TA、Chla、TC、TN和TP等.     

新型介孔薄膜涂层固相微萃取-气相色谱法测定塑料浸取液中的邻苯二甲酸二(2-乙基己基)酯

自制新型介孔薄膜涂层固相微萃取头,结合顶空固相微萃取-气相色谱法(HS-SPME-GC),测定水溶液中的邻苯二甲酸二(2-乙基己基)酯(DEHP)。结果表明,该方法具有良好的线性范围(0.1～2000μgL),检出限为0.08μgL,相对标准偏差为5.5%(n=3)。将该法应用于检测塑料浸取液中DEHP,结果令人满意。     

Enzymatic degradation of poly([R,S] β-hydroxybutyrate)

The synthetic analogue of a bacterially produced polyester, poly(-hydroxybutyrate) (PHB) was synthesized from racemic -butyrolactone using anin situ trimethyl aluminum-water catalyst. The polymer was fractionated into samples differing in molecular weight and isotactic diad content. The latter was closely related to degree of crystallinity. The biodegradation of these fractions were examined by monitoring mass loss over time in the presence of anAlcaligenes faecalis T1 extracellular bacterial poly(-hydroxybutyrate) depolymerase. The fraction with high isotactic diad tacticity content showed little or no degradation over a 50 hour incubation period, whereas the fraction of intermediate isotactic diad content degraded in a continuous steady fashion at a rate that was less than that for bacterial PHB. The low isotactic diad fraction underwent a rapid initial degradation, followed by no further mass loss. The presence of stereoblocks in the polymer structure of the various fractions was an influence on the degree of susceptibility towards degradation and is related to sample crystallinity.