一种有机硅改性丙烯酸防污涂料的研究

目的通过在丙烯酸树脂分子中引入有机硅,制备一种具有低表面能的有机硅改性丙烯酸树脂CP-CC021。方法探讨合成工艺中有机硅单体和引发剂含量以及添加纳米级Si O2粒子填料对涂层性能的影响规律。结果获得了最大接触角的最佳工艺条件,添加纳米Si O2粒子增大了涂层的表面粗糙度,在涂层表面形成了大量微-纳结构状的突起,显著提高涂层的疏水性能。结论有机硅单体(VTMS)质量分数为23.0%,引发剂(AIBN)质量分数为0.50%,纳米Si O2粒子添加量(质量分数)为7.4%,得到的涂层接触角为126.1°。     

含硫废水受控氧化及单质硫团聚过程研究

采用过氧化氢在常温常压下对模拟含硫废水进行受控氧化,探讨了受控氧化过程对单质硫收率的影响,并对氧化过程中固相产物的形态特性进行了研究.结果表明,在过氧化氢投加量为9 m L·L-1、初始p H为6、反应时间为10min条件下,将反应体系氧化还原电位(ORP)控制在(30±5)m V时能较好实现含硫废水的受控氧化,此时单质硫收率达76.35%,当体系ORP由(-50±5)m V升高至(50±5)m V时,副产物S2O2-3收率显著下降,由26.54%下降至5.32%.X射线衍射分析表明,氧化过程中的固相产物主要为正交晶系斜方硫;扫描电子显微镜分析表明,液相中的单质硫由多个极小的颗粒聚集而成,其粒径由纳米级逐渐增大至微米级.同时,通过向反应体系中加入分散剂证明了单质硫颗粒增大的主要原因是颗粒间发生了团聚.     

Transparent exopolymer particles (TEPs)-associated protobiofilm: A neglected contributor to biofouling during membrane filtration

• Bacteria could easily and quickly attached onto TEP to form protobiofilms. • TEP-protobiofilm facilitate the transport of bacteria to membrane surface. • More significant flux decline was observed in the presence of TEP-protobiofilms. • Membrane fouling shows higher sensitivity to protobiofilm not to bacteria level. Transparent exopolymer particles (TEPs) are a class of transparent gel-like polysaccharides, which have been widely detected in almost every kind of feed water to membrane systems, including freshwater, seawater and wastewater. Although TEP have been thought to be related to the membrane fouling, little information is currently available for their influential mechanisms and the pertinence to biofouling development. The present study, thus, aims to explore the impact of TEPs on biofouling development during ultrafiltration. TEP samples were inoculated with bacteria for several hours before filtration and the formation of “protobiofilm” (pre-colonized TEP by bacteria) was examined and its influence on biofouling was determined. It was observed that the bacteria can easily and quickly attach onto TEPs and form protobiofilms. Ultrafiltration experiments further revealed that TEP-protobiofilms served as carriers which facilitated and accelerated transport of bacteria to membrane surface, leading to rapid development of biofouling on the ultrafiltration membrane surfaces. Moreover, compared to the feed water containing independent bacteria and TEPs, more flux decline was observed with TEP-protobiofilms. Consequently, it appeared from this study that TEP-protobiofilms play a vital role in the development of membrane biofouling, but unfortunately, this phenomenon has been often overlooked in the literature. Obviously, these findings in turn may also challenge the current understanding of organic fouling and biofouling as membrane fouling caused by TEP-protobiofilm is a combination of both. It is expected that this study might promote further research in general membrane fouling mechanisms and the development of an effective mitigation strategy.     

Characteristics and mixing state of S-rich particles in haze episodes in Beijing

Direct individual analysis using Scanning Electron Microscopy combined with online observation was conducted to examine the S-rich particles in PM_2.5 of two typical polluted haze episodes in summer and winter from 2014 to 2015 in Beijing. Four major types of S-rich particles, including secondary CaSO₄ particles (mainly observed in summer), S-rich mineral particles (SRM), S-rich water droplets (SRW) and (C, O, S)-rich particles (COS) were identified.We found the different typical morphologies and element distributions of S-rich particles and considered that (C, O, S)-rich particles had two major mixing states in different seasons. On the basis of the S-rich particles’ relative abundances, S concentrations and their relationships with PM_2.5 as well as the seasonal comparison, we revealed that the S-participated formation degrees of SRM and SRW would enhance with increasing PM_2.5 concentration. Moreover, C-rich matter and sulfate had seasonally different but significant impacts on the formation of COS.

Open image in new window

     

基于PMF模式的南京市大气细颗粒物源解析

为研究南京市大气细颗粒物(PM2.5)污染来源,分别在3个点位、4个季节开展了PM2.5环境样品的采集,共获得170个有效样本.对样本进行了化学成分分析,包括Al、Fe、Na、Mg、K、Ba、Li、Tl、Mn、Co、Ni、Cu、Zn、Sb、Pb、Cr、Ce、Na+、NH4+、Mg2+、Ca2+、SO42-、NO3-、Cl-、以及OC、EC,共计26种.首先采用OC/EC最小比值法估算出二次有机气溶胶(SOA)的含量;然后利用正矩阵因子分解法(PMF)对PM2.5的非SOA部分进行来源解析,共解析出6类因子:二次无机气溶胶(SIA)、燃煤、机动车排放、地面扬尘、冶金和其它源,贡献率分别25.0%、23.5%、20.4%、17.1%、3.0%和11.0%;最后基于南京市SO2、NOx、VOCs三种主要前体污染物的排放量,分别对SIA和SOA在一次来源中进行再分配.最终结果表明,南京市PM2.5主要来源为燃煤、机动车、扬尘、工业和其它源,其贡献率分别为29.6%、22.4%、14.6%、18.7%和14.7%.     

北京大气降尘中微量元素的空间变异

在北京市六环内均匀布点采集了城市核心区、城市扩展区、近郊区的大气降尘.对降尘中14种稀土元素(Y、Pm除外)以及Cr、Co、Mo、Cd、Pb等5种重金属元素的化学特征进行统计分析,并结合判别分析和Spearman相关分析方法阐释了影响各区域空间变异的主要元素.最后利用三角图解法揭示空间差异的成因.结果表明,各元素含量在空间上具有明显的阶梯变化,Cr、Mo、Cd、Pb含量沿城市核心区向近郊区方向呈递减趋势,Co与14种稀土元素含量的梯度变化特征则恰好相反,由市中心向外围郊区呈递增趋势.轻稀土富集程度表现为城市核心区>城市扩展区>近郊区,Eu亏损程度相反.Mo、Co、Pb元素可用来表征区域降尘的空间差异(68.2%).LaCeSm三角图解表明北京降尘主要来源于壳源物质.PbCoMo和CrCoMo三角图解可以很好地解释不同污染源贡献程度的差别是造成降尘中微量元素在空间尺度上的差异的原因.近郊区降尘受到土壤扬尘、燃煤的影响较大.城市核心区降尘主要受到交通排放的影响.城市扩展区处于过渡带,降尘受到交通、燃煤、土壤扬尘等的影响作用居中.     

黄山大气气溶胶新粒子生长特性观测分析

利用2012年9月22日~10月28日黄山地区大气气溶胶、二氧化硫和臭氧观测数据,结合气象数据,分析气溶胶新粒子的生成-增长特征.分析发现,在33个有效观测日中,有新粒子生成-增长的观测日占总数的18.2%,其中晴天的发生频率为37.5%,新粒子生成-增长都开始于晴天上午,与无新粒子观测日相比,太阳辐射量、风速、SO2及O3浓度较高,环境温度和相对湿度较低.气溶胶新粒子的增长具有由小及大的特点,核模态气溶胶粒子(10~20nm)数浓度最先增加,爱根核模态粒子(20~50nm)数浓度随着时间推移逐渐增大,但浓度峰值依次下降,平均增长率为3.58nm/h. SO2浓度先于核模态气溶胶数浓度到达峰值,其氧化后的产物H2SO4为新粒子的核化提供前体物,并且参与新粒子的增长过程,当SO2浓度较低时,不会发生新粒子生长事件.     

Optimizing synthesis conditions of nanoscale zero-valent iron (nZVI) through aqueous reactivity assessment

Nanoscale iron particles (nZVI) is one of the most important engineered nanomaterials applied to environmental pollution control and abatement. Although a multitude of synthesis approaches have been proposed, a facile method to screen the reactivity of candidate nZVI materials produced using different methods or under varying synthesis conditions has yet been established. In this study, four reaction parameters were adjusted in the preparation of borohydride-reduced nZVI. The reductive properties of the resultant nanoparticles were assayed independently using two model aqueous contaminants, Cu(II) and nitrate. The results confirm that the reductive reactivity of nZVI is most sensitive to the initial concentration of iron precursor, borohydride feed rate, and the loading ratio of borohydride to ferric ion during particle synthesis. Solution mixing speed, in contrast, carries a relative small weight on the reactivity of nZVI. The two probing reactions (i.e., Cu(II) and nitrate reduction) are able to generate consistent and quantitative inference about the mass-normalized surface activity of nZVI. However, the nitrate assay is valid in dilute aqueous solutions only (50 mg·L⁻¹ or lower) due to accelerated deactivation of iron surface at elevated nitrate concentrations. Additional insights including the structural and chemical makeup of nZVI can be garnered from Cu(II) reduction assessments. The reactivity assays investigated in this study can facilitate screening of candidate materials or optimization of nZVI production parameters, which complement some of the more sophisticated but less chemically specific material characterization methods used in the nZVI research.     

蒸汽相变促进可溶PM2.5凝结增长的数值分析

为利用蒸汽相变原理促进氨法脱硫系统排放细颗粒物(PM2.5)的脱除,建立多分散颗粒的凝结增长动力学模型,利用数值模拟方法研究了可溶硫酸铵颗粒的凝结增长规律,并将典型粒径可溶与不可溶颗粒的凝结增长过程进行对比分析.结果表明:不同粒径硫酸铵颗粒的增长速率相近,等温系统的凝结增长效果优于绝热系统;对于同一初始粒径分布下的可溶和不可溶颗粒,微米尺度可溶颗粒的增长速率始终大于不可溶颗粒,亚微米尺度可溶颗粒的增长速率先大于而后小于不可溶颗粒,使得二者的增长曲线存在一个交叉点;蒸汽饱和度增大能显著促进硫酸铵颗粒的增长;等温系统中温度对硫酸铵颗粒的增长影响显著,绝热系统中温度的影响较弱.     

Experimental investigation into the oxidation reactivity, morphology and graphitization of soot particles from diesel/n-octanol mixtures

Aiming to investigate the impacts of n-octanol addition on the oxidation reactivity, morphology and graphitization of diesel exhaust particles, soot samples were collected from a four-cylinder turbocharged diesel engine fueled with D100（neat diesel fuel）, DO15（85% diesel and 15% n-octanol, V/V） and DO30（70% diesel and 30% n-octanol, V/V）. All tests were conducted at two engine speeds of 1370 and 2150 r/min under a fixed torque of 125 N ·m. The soot properties were characterized by thermogravimet...