基于STAMP模型的核动力蒸汽发生器水位控制系统安全性分析

核电厂蒸汽发生器(SG)水位控制系统的安全可靠运行是保证核电厂安全性和经济性的关键因素,其控制对象具有高度复杂、非线性的特点。由于复杂系统的安全性是特定环境下由系统相关要素交互作用所产生的一种涌现特性,运用系统理论,以STAMP模型为基础对SG水位控制系统进行安全性分析,以利于在设计早期阶段发现影响该系统安全运行的潜在风险因素,预防危险事故。该方法将系统理论用于核电厂关键系统和设备安全性分析,为核电厂安全运行提供了新的技术手段支持。     

炼油厂IGCC电站NOx排放控制技术比较与工程实践

针对IGCC电站烟气排放ρ（NO_x）不达标的问题,分别采用燃气轮机注氮脱硝和余热锅炉（余热蒸汽发生器,HRSG ）SCR脱硝技术降低烟气的NO_x排放量。介绍了两种技术的原理,比较了两种技术的脱硝效果、运行成本及技术特点。实际运行结果表明：安装了注氮设备的燃气轮机可以控制排气的ρ（NO_x）小于90 mg/m³,但每年的运行成本较高（达2 250万元）;在余热锅炉中安装SCR脱硝设备,性能测试数据符合设计要求,SCR出口ρ（NO_x）小于50 mg/m³,且每年的运行成本较低,仅为422万元。     

城市污水处理厂沼气发电的两种方式

作为污泥厌氧消化处理的副产品,沼气是城市污水厂极具有使用价值的能源,本文主要介绍了城市污水处理厂沼气发电的两种方式：沼气发电机和沼气燃烧电池发电。     

用于有界波模拟器的紧凑型纳秒脉冲源

随着电磁武器的发展,核电磁脉冲及其工程防护技术受到各国的普遍关注。为模拟电磁脉冲环境,研制了一台紧凑型纳秒脉冲源,与有界波模拟器配合可产生的双指数波形前沿~1.6ns,脉宽42ns,幅值可达60kV。本文介绍了脉冲源的设计与调试结果。     

煤气发生炉在工业炉窑烟气治理中的应用

文章介绍了煤气发生炉在工业炉窑烟气治理中的应用，从减少环境污染和节能降耗两个方面客观实际地分析了不同的煤气发生炉在各种窑炉应用中的特点，对典型性和普遍性的内容予以概括，希望起到抛砖引玉的作用，以利用工业炉窑烟气治理工程的开展。     

蒸汽喷射离子发生器及其应用

介绍一种新型蒸汽喷射离子发生器，并将这种发生器作为预荷电器，在旋风除尘器上进行除尘增效改造应用的试验。结果表明粉尘的预荷电及静电凝并可以增加除尘效率。     

An experimental set up of a PAH vapour generator and its use to test an annular denuder

The aim of this work is to develop and test a dynamic gas generator for semi-volatile organic compounds (SVOC). A single compound, naphthalene, is used as a surrogate PAH to test the system. The dynamic generation of PAH is based on the permeation technique [Analyst 106 (1981) 817; Am. Ind. Hyg. Assoc. J. 38 (1977) 712]. Monitoring the temperature and measuring the mass of PAH present in the permeation chamber every 48 h gives a direct measurement of the sublimation rate of the PAH. Knowing the flow rate, gives an accurate value of the concentration of PAH from the generator. It was found stable over a period of time under constant operating conditions. This concentration is diluted down to between 0.3 and 30 ppbv by a controlled flow of pure air. The diluting airflow is a mixture of dry and wet air, making it possible to control the relative humidity of the flow from the generator as well as its concentration in PAH. We used this generator to calibrate an annular denuder tube, based on the study by Gundel et al. [Atmos. Environ. 29 (1995) 1719]. Although this technique has been shown to be artefact-free for sampling gaseous PAH [Polycyclic Aromatic Compounds 9 (1996) 67; Atmos. Environ. 28 (1994) 3083], its trapping efficiency still depends on environmental parameters (temperature, relative humidity and sampling duration). Accordingly, we used our generator to calibrate a single annular denuder under controlled conditions (T degrees C, HR%, CPAH, sampling duration). The trapping efficiency of the denuder was calculated by two independent methods. Firstly, by comparing the amount trapped on a denuder with the measured mass sublimated in the generator. Secondly, by putting two denuders in series and comparing the mass collected on the first and the second tube. These two methods gave similar results, within the 10% relative uncertainties of both methods. The first results obtained show that, in environmental conditions, the efficiency ranges between 90 and 100%.     

Effect of high-voltage direct current link on small signal stability of a power system with different penetration level of doubly fed induction generator and direct drive synchronous generator based wind farms

High penetration level of wind power has significant impact on the dynamic performance of power system. Power system with existing high-voltage direct current (HVDC) link may influence the stability of power system at high penetration level of wind power. This article investigates the stability issues of power system with existing HVDC link for different penetration level of doubly fed induction generator (DFIG) and direct drive synchronous generator (DDSG) based wind farms. The small signal stability analysis shows that power system with HVDC link has improved the stability of the power system for increased penetration of DFIG- and DDSG-based wind farms.     

蓄热式高温带压蒸汽发生器设计

介绍了自制蓄热式高温带压蒸汽发生器的工作原理及运行过程，对炉体结构进行了设计计算，设计并计算了保温层的厚度，通过部分热态实验，验证了高温带压蒸汽发生器设计的合理性和系统运行的可靠性。试验结果表明，经过高温带压蒸汽发生器蓄热室的换热，可以生产出压力在0.2～0.4 MPa、温度在650℃以上的高温过热水蒸气。从而说明系统的整体设计能满足要求。