Kenaf/Ramie Composite for Automotive Headliner

An increasing industrial interest is applications of kenaf and ramie fiber nonwovens for making automotive interior trim parts because of their excellent strength and renewability. This paper presents a study on the manufacture and evaluation of the kenaf/ramie nonwoven composite for this automotive end use. Carding, needle-punching, and wet bonding were used to fabricate the composite. End-use performance of the composite, in terms of tensile strength, thermal conductivity, dynamic mechanical property, and bonding structure, was tested using a series of instruments in accordance with the ASTM methods. Bonding performance of the polyvinyl alcohol binder and acrylic copolymer binder was also compared. Research results revealed that the acrylic-copolymer bonded composite was significantly anisotropic in both tensile and bending deformation and the polyvinyl-alcohol bonded composite was significantly anisotropic only in bending deformation. For the acrylic-copolymer bonded composite, increase of padding times helped enhance tensile properties. The acrylic-copolymer bonded composite also exhibited a better performance in dynamic thermal mechanical deformation but indicated insignificant difference of thermal conductivity compared to the polyvinyl-alcohol bonded composite.     

Fenton试剂氧化—石灰法处理苎麻脱胶废水

采用Fenton试剂氧化一石灰法处理苎麻脱胶废水（简称废水）。在pH为8．3的废水中FeSO4·7H2O、H2O2、饱和石灰乳的加入量分别为1．5g／L、1．0mL／L和1．0mL／L的条件下对废水进行处理，废水COD由650mg／L降至200mg／L以下，COD去除率约为70％；色度由500倍降至70倍以下，色度去除率约为90％，出水COD和色度均达到GB8978-1996（污水综合排放标准）中的二级排放标准。     

苎麻麻骨水溶物的溶出影响因素及其组成

为探讨生物质材料吸附重金属过程中溶出物的溶出规律及成分,以苎麻麻骨为材料,在实验室模拟其吸附Cd2+废水条件下,考察溶出时间、温度、pH、苎麻麻骨粒径及ρ(Cd2+)对苎麻麻骨水溶物DOC溶出量的影响,通过气相色谱-质谱法对溶出物成分进行鉴定,并利用扫描电子显微镜(SEM)、红外光谱(FTIR)、热重分析(TGA)等技术对溶出物溶出前后苎麻麻骨表面物化性质进行了表征. 结果表明:在弱酸性(pH为5)条件下,苎麻麻骨DOC溶出量高于65.90 mg/L. 各因素对DOC溶出量的影响程度不同,以粒径及温度的影响最大,随着粒径由1 mm增至20 mm,DOC溶出量由78.37 mg/L迅速降至60.14 mg/L,降低了18.23 mg/L;升温可促进苎麻麻骨DOC溶出量的增加,随着温度由5 ℃升至55 ℃,DOC溶出量增加了13.63 mg/L. 提取液pH、溶出时间、ρ(Cd2+)对DOC溶出量的增加量分别为5.08、4.60、3.11 mg/L. 溶出物溶出前后苎麻麻骨表面无显著变化,但溶出后的苎麻麻骨表面易溶于水的官能团数量显著减少. 溶出物中鉴定出9类物质(共19种化合物),以酮类和酯类居多,表明苎麻麻骨表面不带电.      

螯合剂和泥炭对苎麻吸收土壤镉的影响

通过生物盆栽试验研究了施用螯合剂(EDTA、柠檬酸)与泥炭对强化苎麻修复重金属镉污染土壤的作用.结果表明,施加泥炭能改善土壤的理化性质,增加苎麻的生物产量,泥炭单施、螯合剂(EDTA、柠檬酸)和泥炭的组合措施的相对产量分别为1.23、1.13和1.41,因此泥炭和柠檬酸配施处理更有利于植物生长.就植物吸收镉能力来说,螯合剂(EDTA、柠檬酸)和泥炭的配施处理能更好地促进苎麻对镉的吸收,其土壤交换态镉所占镉形态质量分数为61.6%和58.3%,具有强化植物修复的效果.螯合剂(EDTA、柠檬酸)和泥炭2种组合方式的地上部富集系数分别为1.33和1.32,大于单施(EDTA、柠檬酸和泥炭)处理1.11、1.11和1.05,具有较好的富集效应,同时螯合剂(EDTA、柠檬酸)和泥炭的组合处理对土壤镉的净化率分别达到了1.13%和1.22%,而柠檬酸和泥炭配施具有较大的生物量,使植株总镉量略高于EDTA与泥炭的组合处理,因而更有利于镉污染土壤的修复.因此,利用螯合剂和泥炭的组合修复措施对强化苎麻修复镉污染土壤能取得更佳的效果.