生活垃圾填埋场甲烷自然减排的新途径:厌氧与好氧的共氧化作用

采用暴雨过后垃圾填埋表层30～60 cm的覆土、表层1.5 m以下的垃圾,以及刚刚开挖出来的9年矿化垃圾进行硫酸盐还原菌阳性反应试验,结果表明生活垃圾填埋体不同填埋层都存在不同数量级的硫酸盐还原菌,且底层矿化垃圾中的硫酸盐还原菌的数量最多,表层覆土中最少.颗粒大小比例为50%:50%的垃圾样品表现出最佳的甲烷好氧与厌氧...     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

电渗析法再生CO_2电还原电解液的研究

探索了电渗析法再生CO2电还原电解液的可行性。以HCOOK溶液作为CO2电还原反应后的模拟液,采用单室电渗析装置对其进行再生,考察了电流、时间、温度等操作条件对电流效率和再生率的影响,研究结果表明:在常温条件下,操作电流低于极限电流时,采用电渗析法再生CO2电还原电解液具有高的电流效率和再生率。     

燃煤电厂烟气氮氧化物排放控制技术发展现状

在广泛查阅文献的基础上,对近年来国内外已成功应用和正在研究开发的一些主要的燃煤烟气氮氧化物控制技术进行了介绍。结合我国目前脱硝行业整体水平和国家环保政策要求,对我国脱硝行业技术研发方向提出了建议。     

无砾石微孔管地下渗滤系统试验研究

针对传统无砾石管式地下渗滤系统存在的处理性能差,渗滤通量低两个问题,通过去掉包裹织物,提高渗滤管开孔率、改变开孔方式,设计了无砾石微孔管地下渗滤系统。通过实验研究表明,无砾石微孔管地下渗滤系统对COD、氨氮的去除率比传统管式系统分别提高了10.8%、12.7%,总磷去除率并无显著差异,ORP值提高约85 mV,渗滤通量提高26.8%。在3.3 cm/d的水力负荷下,无砾石微孔管地下渗滤系统出水COD、氨氮、总磷平均浓度分别为19 mg/L,0.62 mg/L,0.048 mg/L。渗滤管下10 cm的土壤层去除了约70%的COD,80%的氨氮和91%的总磷,向下随着土壤深度的增加,单位厚度的土壤层去除的污染物量呈显著下降趋势。     

吸附树脂负载铁酞菁催化降解硝基苯的研究

在可见光照射下,采用吸附树脂负载铁酞菁催化过氧化氢降解硝基苯.考察了光照、催化剂投加量、双氧水投加量、温度及pH值等因素对催化效果的影响.结果表明,在功率为50W卤钨灯照射下,硝基苯溶液初始质量浓度为200 mg/L,初始pH值为3,催化剂投加量为1.5 g/L,双氧水投加量为1.0 mL/L,温度为35℃下反应10h,硝基苯去除率可达到79.9％.     

苯系化合物在硝酸盐还原条件下的生物降解性能

运用驯化的反硝化混合菌群进行了苯系化合物(BTEX)的厌氧降解试验.结果表明,混合菌群能够在反硝化条件下有效降解苯、甲苯、乙苯、邻二甲苯、间二甲苯和对二甲苯.BTEX的降解规律符合底物抑制的Monod模型,当初始浓度小于50mg·L^-1时,6种受试基质的厌氧降解速率顺序为:甲苯>乙苯>间二甲苯>邻二甲苯>对二甲苯>苯.整个试验过程中NO₃^-的消耗与苯、甲苯、乙苯、邻二甲苯、间二甲苯及对二甲苯生物降解之间的摩尔比分别为:9.47,9.26,1