电镀污泥处理技术的研究进展

电镀污泥中含有大量的铬、镉、镍、锌等重金属，是一种典型的危险废物。综述了近年来国内外对电镀污泥处理技术的研究进展，包括固化／稳定化技术、热化学处理技术、有价金属回收技术和材料化技术等。对主要处理技术的应用前景进行了分析，认为热化学处理技术将成为未来电镀污泥处理领域内的一个重要研究方向。     

沸石作稳定化剂固化/稳定化含汞危险废弃物试验

利用沸石对汞的吸附性,将沸石作为稳定化剂掺入水泥进行含汞危险废弃物固化/稳定化试验研究.同时,探讨了沸石作为稳定化剂的水泥固化技术处理含汞废弃物的影响因素,从而明确这种方法的可行性和最佳操作条件.结果表明,沸石的掺入能够促进汞的稳定,与单独使用水泥相比固化效率显著提高.当沸石用量为0.3g·g-1以上时,固化体浸出汞浓度低于国家标准(GB5085.3-2007),固化效率从单独使用水泥固化时的47%提高到95%以上.氯离子能够影响固化效率,即使在氯离子浓度为10mmo·lL-1时,含汞1000mg·kg-1以下的固体废弃物的固化效率仍能够大于90%.这说明即使存在氯离子干扰的情况下,沸石作稳定化剂固化含汞危险废物仍然是非常经济有效的方法.实验得到沸石作稳定化剂固化含汞危险废弃物的最佳操作条件为pH=6.0～7.0之间,沸石量为0.4g·g-1,水泥量为0.7g·g-1以上.     

钻井废泥浆固相物无害化处理试验研究

在国内现有的几种钻井泥浆固相物无害化处理方法基础上,本文提出了先破胶分离处理后,再分别对分离后的固相物进行焚烧、制作烧结砖和免烧砖的工艺并进行试验研究。通过对试验结果进行系统分析,指出了对泥浆固相物进行焚烧在设备选择、安置和尾气处理上存在难度,制作废泥浆烧结砖在能耗上的缺陷,确定了利用废泥浆回相物制作免烧砖的配方及处理工艺,并经测定,其机械强度符合蒸压加气混凝土砌块的抗压强度（GB11945—1989）,其浸毒液也能达到国家污水综合排放标准（GB8978—1996）一级标准。较好地满足了废弃泥浆的无害化处理,实现环境可持续发展的要求。     

水泥窑协同处置与水泥固化/稳定化对重金属的固定效果比较

危险废物水泥窑协同处置与水泥固化,稳定化对废物中重金属的固定机理不同,固定效果因而有所差异.针对含As、Cd、Cr、Cu、Pb、Zn等重金属离子的上述2类试样平行开展浸出实验及连续提取实验,以重金属浸出浓度及化学形态为指标,比较分析了水泥窑协同处置与水泥固化/稳定化对废物中不同重金属的固定效果的差异.结果表明,对于As、Pb、Zn等重金属离子,水泥窑高温煅烧及后续水化作用有助于其更稳定化学形态的形成,固定效果优于水泥固化,稳定化,说明含Ag、Pb、Zn的危险废物能够在水泥窑得到有效处置.Cr3 在水泥窑煅烧过程中易被氧化为迁移性和毒性更强的Cr6 ,因而含Cr的废物不适合采用水泥窑协同处置方式.该研究能为不同种类重金属危险废物处置方法的选取提供依据,并为水泥窑协同处置重金属类危险废物的应用和发展提供科学的决策依据.     

Leaching characteristics of heavy metals during cement stabilization of fly ash from municipal solid waste incinerators

The leaching characteristics of heavy metals in products of cement stabilization of fly ash from a municipal solid waste incinerator were investigated in this paper. The stabilization of heavy metals such as Cd, Pb, Cu, and Zn in fly ash from such incinerators was examined through the national standard method in China based on the following factors: additive quantity of cement and Na₂S, curing time, and pH of leaching liquor. The results showed that as more additives were used, less heavy metals were leached except for Pb, which is sensitive to pH of the leachate, and the worse effect was observed for Cd. The mass ratio of cement to fly ash = 10% is the most appropriate parameter according to the national standard method. When the hydration of cement was basically finished, stabilization of heavy metals did not vary after curing for 1 d. The mixtures of cement and fly ash had excellent adaptability to environmental pH. The pH of leachate was maintained at 7 when pH of leaching liquor varied from 3 to 11. __________ Translated from Environmental Science, 2006, 27(12): 2564–2569 [译自: 环境科学]     

生活垃圾焚烧飞灰固化体重金属动态浸出规律

为研究实际生活垃圾卫生填埋场中渗滤液长期作用于飞灰固化体的浸出行为,分别采用pH值为5.5的醋酸-醋酸钠溶液和pH值为7.0的去离子水作为初始浸提液,建立飞灰固化体的动态浸出试验.初始浸提液pH值的差异会影响飞灰固化体的结构完整性和固化体表面晶体的生成情况,当初始浸提液为醋酸-醋酸钠溶液时,实验过程中飞灰固化体会破碎;当初始浸提液为去离子水时,飞灰固化体表面生成的CaCO₃晶体可能会抑制重金属浸出.当实验进行至约120d时,2组实验浸出液的pH值和重金属浓度基本稳定,且pH值相差不大;但采用去离子水浸提时,Pb、Cr的累计浸出量明显更高,且Pb的浸出浓度（0.29mg/L）甚至一度超过填埋场入场限值,其潜在风险应受到关注.     

Environmental behaviour of a construction made of a mixture of hydraulic binders and air pollution control residues from municipal solid waste incineration Part 2. Simulation tests and validation of the source term modelling

The reuse of waste materials requires the development of assessment methods for the long-term release of pollutants (source term) from wastes (or materials containing wastes) in contact with water. These methods depend on the scenario conditions: characteristics of the materials (especially physical structure and composition), contact with water… The scenario studied here is a water storage reservoir for fire extinguishing. The reservoir construction is made of a mixture of hydraulic binders and air pollution control (APC) residues from municipal solid waste incinerator (MSWI). The modelling of the source term is performed in five steps ranging from the physico-chemical characterisation of the material to the validation of the proposed model by means of field simulation devices. This paper follows a first publication on source term modelling using laboratory tests which therefore concerns the comparison of the results obtained with the previously established model. The first laboratory scale simulation test aims at taking into account the role of the leachate carbonation in the leaching behaviour of the studied material. The results obtained show that air carbonation of the leachate does not fundamentally change mass transfer mechanisms of easily soluble species (especially for alkaline metals). For these species, the use of the apparent diffusional model (model proposed in the previous paper) is, therefore, at first, a satisfactory solution for the prediction of long term leaching behaviour. The field scale test enables us to validate and calibrate the release model determined on a laboratory scale basis.     

铬渣水泥固化体稳定性研究

采用水泥固化的方法对铬渣进行处理。在水泥与铬渣、砂、水、硅酸钠的质量比为1：0．6：0．45：0．15：0．1时固化效果较好。固化体经28d的养护后,表面Cr^6 的浸出率为10^-5数量级,即使破碎至5mm以下的粒度,其Cr^6 的浸出质量浓度仍在国家标准以下。模拟酸溶试验和固化体抗压强度测试结果表明,固化体用于填埋是长期安全的。     

粉煤灰固结技术及应用研究

为防治火电厂贮灰场扬尘污染对粉煤灰固技术进行了试验研究。目前已研制出２个系列的粉煤灰固结剂,固结后的抗压强度都在１６ｋｇ／ｃｍ２以上,最高达７０ｋｇ／ｃｍ２;水稳系数和冻稳系数都在０．９０—１．００。该项技术具有抑尘效果好、保持时间长、治理成本低、原料来源广泛、施工工艺简单和易于推广等待点。它可用于正在使用的灰场（包括中转灰场、碾压灰场）和贮满灰的灰场治理扬尘,还可用于灰场防渗和灰坝加固。     

长庆低渗透油田废弃钻井液处理探讨

通过对长庆低渗透油田废弃钻井液性能分析,确定了固液分离-固化一体化处理思路;研究了不同破胶剂体系、破胶剂加量、絮凝剂分子量等对固液分离及出水率的影响;处理结果表明:添加20%粘土同时加入6%固化剂时固化体针入度可降至0.5mm以下,达到强度要求,又可降低成本。现场试验证实固液分离析出水和固化体浸出液均达到GB8978-1996《污水综合排放标准》二级标准。