Seasonal trend of ambient PCDD/Fs in Tianjin City, northern China using active sampling strategy

The spatial concentrations, seasonal trends, profiles and congener pairs of ambient polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) were investigated within a seasonally active sampling scheme during Jun 2008 and Jan 2009 in Tianjin City, northern China. The PCDD/F concentrations ranged 14.2-172 fg I-TEQ/m³ (average 69.3 fg I-TEQ/m³) in summer and (89.8-1.01) × 10³ fg I-TEQ/m³ (average 509 fg I-TEQ/m³) in winter, respectively, except for the E-waste dismantling site where much higher values were observed (1.04 × 10³ fg I-TEQ/m³ in summer and 7.123 × 10³ fg I-TEQ/m³ in winter). The results indicated a significantly seasonal trend with higher TEQ values in winter as compared with summer, which could be related to increased emission sources and seasonal variations of the atmospheric boundary layer height. 2,3,4,7,8-PeCDF was the dominant contributor to the total PCDD/F toxic equivalents, and 2,3,7,8-TCDD was detected at almost all the sampling sites in winter. Most of the similarly substituted PCDD/F congener pairs exhibited high correlations, suggesting that they might have similar environmental fate or sources. But different seasonal and spatial distributions of PCDD/F concentrations indicated that the emission sources might be intermittent.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.     

超声波/零价铁协同体系作用机理探讨

在超声波/零价铁协同体系中,探讨了OH.的产生途径及其影响因素,并分析了Fe0表面形态变化。结果表明:在超声波/零价铁体系中,羟基自由基的产生途径主要有四种:声空化导致水分子热解、Fenton反应、超声波与类Fenton反应的复合效应、铁粉颗粒效应;pH值过低或过高都不利于羟基自由基产生;当铁粉投加量为2.0g/L时最有利于羟基自由基产生;超声波通过冲刷、碎裂、清洗、气蚀和熔合等多种效应,活化和增强铁粉的表面性能。     

便携式GC/MS对空气中苯系物的定量分析方法研究

文章采用简单快速的采气袋配气方式,以苯系物为例,研究了便携式GC/MS对大气中痕量有机污染物的快速定量测定方法。分别在Full scan和建立的SIM扫描方式下对苯系物标准样品进行了测定。对比实验结果表明,Full scan和SIM两种扫描方式下苯系物测定结果的相对标准偏差分别在5.1%~28.4%和13%~19%之间,回收率范围分别为46%~186%和60%~110%,方法检出限范围分别为2.504~10.63μg/m3和0.494~2.399μg/m3。总体而言,SIM方式在测定结果的精密度与准确度上均优于Full scan方式。室内外空气样品的测试结果映证了SIM方式在对痕量有机污染物测定的优势。     

A GFP-based bacterial biosensor with chromosomally integrated sensing cassette for quantitative detection of Hg(II) in environment

A mercury biosensor was constructed by integrating biosensor genetic elements into E. coli JM109 chromosome in a single copy number, using the attP/attB recombination mechanism of λphage. The genetic elements used include a regulatory protein gene (merR) along with operator/promoter (O/P) derived from the mercury resistance operon from pDU1358 plasmid of Serratia marcescens. The expression of reporter gene gfp is also controlled by merR/O/P. Integration of the construct into the chromosome was done to increase the stability and precision of the biosensor. This biosensor could detect Hg(II) ions in the concentration range of 100-1700 nmol/L, and manifest the result as the expression of GFP. The GFP expression was significantly different (P ≤ 0.05) for each concentration of inducing Hg(II) ions in the detection range, which reduces the chances of misinterpretation of results. A model using regression method was also derived for the quantification of the concentration of Hg(II) in water samples.     

Operating condition influences on PCDD/Fs emissions from sinter pot tests with hot flue gas recycling

This study was designed to clarify the influence of operating conditions on the formation and emissions of polychlorinated-pdibenzodioxins and dibenzofurans (PCDD/Fs) from a sintering process with hot flue gas recycling. A pilot scale sinter pot with simulated flue gas recycling was developed, and four key operational parameters, including temperature, oxygen content of the simulated waste flue gas, the coke rate of the sintering mixture, and the quicklime quality, were selected for exploring PCDD/Fs formation. The results showed that the temperature of the recycled flue gas had a major affect on PCDD/Fs formation, and a high temperature could significantly increase their formation during sintering. A clear linear correlation between the temperature of recycling flue gas and PCDD/Fs emission (r = 0.93) was found. PCDD/Fs could be reduced to a certain extent by decreasing the level of oxygen in the recycled flue gas, while sintering quality was unchanged. The coke rate had no significant influence on the formation of PCDD/Fs, but the quality of quicklime used in the sintering mixture could affect not only the amount of PCDD/Fs emissions but also the sintering productivity. Compared with a benchmark sinter pot test, PCDD/Fs emissions markedly decreased with improvements to quicklime quality. However, the reduction in PCDD/Fs emissions realized by using high-quality quicklime was limited by the temperature of the inlet gas. The highest reduction achieved was 51% compared with conventional quicklime when the temperature of the inlet gas was 150°C.     

化肥污水处理工程实践

介绍了采用A/O一体生化工艺对化肥废水进行处理,设计水量720 m3/d,进水NH3-N质量浓度为300 mg/L.运行结果表明,该工艺处理效果好,出水水质为ρ(COD)≤150 mg/L,ρ(NH3-N)≤70mg/L,ρ(SS)≤100 mg/L达到了GB 13458-2001《合成氨工业水污染物排放标准》最高允许排放限值的要求.     

工业废水AO循环曝气工艺脱氨的理论模型研究

生物流化床处理污水的研究和应用始于20世纪70年代的美国。我国对生物流化床的研究始于70年代末。进入80年代后,我国己建成了不少中小型的生物流化床装置并投入生产,其中除电镀废水以外,也包括对印染、冶金、炼油、制药等废水处理。本实验采用将悬浮填料生物流化床工艺和同步硝化反硝化技术相结合,提出一种曝气推动频繁交替A/O工艺脱氮的设计思路并通过实验研究进行分析建立水力停留时间和曝气量的理论模型,为实践过程中有效调控起到重要作用。