新版GB/T28001的主要变化

介绍了GB／T28001—2001标准修订的背景及修订原则,解读了新版标准的主要变化。     

T型氧化沟工艺处理低碳源生活污水的效果研究

详细介绍了T型氧化沟工艺的特征,并考察研究了该工艺处理低碳源生活污水的长期运行效果。研究结果表明,工艺出水COD、BOD5、NH3-N、TN和TP年平均浓度分别为13.9、3.8、0.91、18.80和1.67 mg/L,去除率分别为88.99%、94.37%、96.74%、37.57%和41.58%,均能达到相应的排放标准。由于T型氧化沟中以好氧环境为主,缺乏厌氧和缺氧环境以及进水的BOD5/TN值低,工艺对有机物及NH3-N的去除效果较好,但TN和TP去除效果较低。提出了加强工艺脱氮除磷的措施,为同类型污水处理厂改造提供参考。     

Seasonal trend of ambient PCDD/Fs in Tianjin City, northern China using active sampling strategy

The spatial concentrations, seasonal trends, profiles and congener pairs of ambient polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) were investigated within a seasonally active sampling scheme during Jun 2008 and Jan 2009 in Tianjin City, northern China. The PCDD/F concentrations ranged 14.2-172 fg I-TEQ/m³ (average 69.3 fg I-TEQ/m³) in summer and (89.8-1.01) × 10³ fg I-TEQ/m³ (average 509 fg I-TEQ/m³) in winter, respectively, except for the E-waste dismantling site where much higher values were observed (1.04 × 10³ fg I-TEQ/m³ in summer and 7.123 × 10³ fg I-TEQ/m³ in winter). The results indicated a significantly seasonal trend with higher TEQ values in winter as compared with summer, which could be related to increased emission sources and seasonal variations of the atmospheric boundary layer height. 2,3,4,7,8-PeCDF was the dominant contributor to the total PCDD/F toxic equivalents, and 2,3,7,8-TCDD was detected at almost all the sampling sites in winter. Most of the similarly substituted PCDD/F congener pairs exhibited high correlations, suggesting that they might have similar environmental fate or sources. But different seasonal and spatial distributions of PCDD/F concentrations indicated that the emission sources might be intermittent.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.     

近期已实施及将实施的部分国家环境标准

<正>HJ 618—2011《环境空气PM10和PM2.5的测定重量法》、HJ 620—2011《水质挥发性卤代烃的测定顶空气相色谱法》、HJ 621—2011《水质氯苯类化合物的测定气相色谱法》、HJ 629—2011《固定污染源废气二氧化硫的测定非分散红外吸收法》、HJ 630—2011《环境监测质量管理技术导则》已于2011年11月1日起实施。GB 27631-2011《发酵酒精和白酒工业水污染物排放标准》、GB 27632-2011《橡胶制品工业污染     

超声波/零价铁协同体系作用机理探讨

在超声波/零价铁协同体系中,探讨了OH.的产生途径及其影响因素,并分析了Fe0表面形态变化。结果表明:在超声波/零价铁体系中,羟基自由基的产生途径主要有四种:声空化导致水分子热解、Fenton反应、超声波与类Fenton反应的复合效应、铁粉颗粒效应;pH值过低或过高都不利于羟基自由基产生;当铁粉投加量为2.0g/L时最有利于羟基自由基产生;超声波通过冲刷、碎裂、清洗、气蚀和熔合等多种效应,活化和增强铁粉的表面性能。     

空塔钠碱法烟气脱硫实验研究

在内径200mm,高度1100mm的喷淋塔内,采用Na2CO3作为吸收剂进行SO2吸收实验,重点研究了液气比(L/G)、空塔气速、进口SO2质量浓度、吸收液pH及初始浓度对脱硫效率的影响。通过实验得到该系统适宜操作条件:吸收液pH值在6.5～7.5之间,液气比在1～1.5之间,吸收液初始浓度5%,空塔气速1.6m/s,在此条件下,进口SO2质量浓度在3000mg/m3以内,脱硫效率可以达到80%以上。     

便携式GC/MS对空气中苯系物的定量分析方法研究

文章采用简单快速的采气袋配气方式,以苯系物为例,研究了便携式GC/MS对大气中痕量有机污染物的快速定量测定方法。分别在Full scan和建立的SIM扫描方式下对苯系物标准样品进行了测定。对比实验结果表明,Full scan和SIM两种扫描方式下苯系物测定结果的相对标准偏差分别在5.1%~28.4%和13%~19%之间,回收率范围分别为46%~186%和60%~110%,方法检出限范围分别为2.504~10.63μg/m3和0.494~2.399μg/m3。总体而言,SIM方式在测定结果的精密度与准确度上均优于Full scan方式。室内外空气样品的测试结果映证了SIM方式在对痕量有机污染物测定的优势。