半导体光催化氧化法处理印染废水的研究

研究了用光催化氧化的方法实际印染废水的可能性，催化剂为TiO2，并将其制膜固定在光反应器内壁上，以125W高压汞灯为源，对某丝绸厂的印绸厂的印废水进行了处理实验，取得了脱色率100％，CODCr去除率85．6％的效果。     

Effects of Fe2O3, organic matter and carbonate on photocatalytic degradation of lindane in the sediment from the Liao River,China

Fourteen sediment samples with different content of Fe₂O₃ were collected from the lower reaches of the Liao River in China. The photodegradation of lindane on the surfaces of these sediments was investigated to observe the effects of Fe₂O₃ and other photoinducable substances, such as TiO₂ and organic substances, on photodegradation of lindane. A partial least-squares (PLS) analysis model was developed to find out the statistical relationship between the photodegradation and the contents of these photoinducable substances. It was concluded from the PLS analysis that inorganic carbon and organic carbon have negative effects, whereas Fe₂O₃ and TiO₂ accelerate the photodegradation of lindane in the sediment samples when 365 nm UV light was used as light source. In all cases of the experiments, the photodegradation of lindane in the sediment samples were fitted for pseudo-first-order kinetics.     

溶液中阴离子和腐殖酸对UV/H2O2降解2,4-二氯酚的影响

研究了UV/H2O2工艺对2,4-二氯酚(2,4-DCP)的去除效果和水中阴离子、腐殖酸对该工艺降解2,4-DCP的影响.结果表明:UV/H2O2工艺可以有效地去除水中2,4-DCP,光降解过程符合一级反应动力学模型;在H2O2投加量为8 mg/L、1个30 W低压汞灯照射下,2,4-DCP在蒸馏水和自来水中反应速率常数分别为0.023 2、0.016 2 min-1;NO-3、Cl-、HCO-3对2,4-DCP光降解有抑制作用,当3种阴离子摩尔浓度为0.5、10.0、20.0 mmol/L时,对2,4-DCP光降解的抑制程度为HCO-3＞NO-3＞Cl-;腐殖酸在低浓度时,促进光降解反应进行,在高浓度时,2,4-DCP的光降解受到抑制.自来水中的反应速率常数低于蒸馏水中的反应速率常数是由于水中多种阴离子和腐殖酸影响的结果.     

Evaluation and in situ assessment of photodegradation of polyaromatic hydrocarbons in semipermeable membrane devices deployed in ocean water

Semipermeable membrane devices (SPMDs) were deployed in water using four different methods: a typical SPMD cage with and without a mesh cover, a bowl chamber and without any protection. In addition to routinely used performance reference compounds (PRCs), perdeuterated dibenz[a,h]anthracene was added. Due to its high sampler to water partition coefficient no measurable clearance due to diffusion was expected during the deployment period, hence any observed loss could be attributed to photodegradation. The loss of PRCs was measured and SPMD-based water concentrations determined. Results showed that a typical SPMD deployment cage covered with mesh provided the best protection from photodegradation. Samplers which had undergone the highest photodegradation underestimated PAH water concentrations by up to a factor of 5 compared to the most protected SPMDs. This study demonstrates that the potential for photodegradation needs to be addressed when samplers are deployed in water of low turbidity.     

Removal of mixed pesticides from drinking water system by photodegradation using suspended and immobilized TiO2

Lindane (1α, 2α, 3β, 4α, 5α, 6β-hexachloro cyclohexane), methyl parathion (O,O-dimethyl-O-4-nitrophenyl phosphorothioate) and dichlorvos (2,2-dichlorovinyl-O-O-dimethyl phosphate) are removed from water individually and as a mixture by photo degradation using suspended and immobilized forms of TiO₂ (Degussa P-25). Studies were conducted to optimize the coating thickness of immobilized photo catalyst. The rate of degradation of pesticides was compared in both suspended and immobilized TiO₂ systems. Degradation studies of mixed pesticides were carried out with low concentrations (1.0 and 2.5 mg/L) of pesticides. Only three intermediate byproducts such as methyl paraoxon, O,O,O-trimethyl phosphonic thionate and p-nitrophenol were observed during the methyl parathion degradation in suspended, immobilized TiO₂ systems and mixed pesticides degradation studies. At the end of the reaction methyl parathion and its by-products were completely degraded. During lindane degradation hexachloro cyclohexane, pentachloro cyclohexane, hexachloro benzene, 1-hydroxy 2,3,4,5,6-chlorocyclohexane, 1-hydroxy 2,3,4,5,6-chlorobenzene, pentachloro cyclopentadiene, 1,2,3,4,5-hydroxy cyclopentene and 1,2,3-hydroxy cyclobutane were identified in suspended and immobilized TiO₂ systems, whereas only hexachloro cyclohexane, pentachloro cyclohexane, hexachloro benzene and pentachloro cyclopentadiene were observed during mixed pesticides degradation. No intermediate by-product was observed during the photo degradation of dichlorvos. Langmuir-Hinshelwood pseudo first order kinetic equation showed that there was not much change in the rates of degradation in both suspended and immobilized TiO₂ systems irrespective of the pesticide. During mixed pesticides degradation, the degradation pattern was not similar to that of single pesticide.     

Effect of transition metal ions on photocatalytic activity of ZnO in bleaching of some dyes

The photocatalytic bleaching of some dyes (erythrosin-B, fast green FCF and eosin Y) was carried in the presence of semiconducting zinc oxide and was observed spectrophotometrically. The effects of various operating variables like pH, concentration of dyes, amount of semiconductor and light intensity on the efficiency of the reaction were also observed. Attempts have been made to study the effect of the addition of other metal ions (Fe²⁺, Ni²⁺, Ag⁺, Cu²⁺, Co²⁺, V²⁺ and Mn²⁺). All the added metal ions increase the reaction rate to some extent. It was also observed that Fe²⁺ is most effective in photobleaching of erythrosin-B, whereas V²⁺ is more effective in the cases of fast green FCF and eosin Y. A tentative mechanism has been proposed.     

Photodegradation of malachite green and malachite green carbinol under irradiation with different wavelength ranges

The dye malachite green (MG) is used worldwide as a fungicide in aquaculture. It is a toxic substance which in aqueous solutions is partly converted into its non-ionic colorless form (leucocarbinol). The equilibrium between these two forms is pH-dependent (pK = 6.9). To assess the photodegradation of MG under sunlight conditions, both species were irradiated separately in aqueous solutions with different pH values (4.0 and 12.0) using various ultraviolet and visible wavelength ranges (UV/VIS). A 700 W high-pressure mercury lamp with special filters was used. No artificial photooxidizers such as H₂O₂ or TiO₂ were added. MG leucocarbinol proved to be much more sensitive to irradiation than the dye form. Quantum yields Φ were calculated for some wavelength ranges as follows: MG carbinol: Φ_(280-312nm) is 4.3 × 10⁻³, Φ_(313-410nm) is 5.8 × 10⁻³, and MG dye: Φ_(280-312nm) is 4.8 × 10⁻⁵, Φ_(313-365nm) is 1.1 × 10⁻⁵, and Φ_(>365nm) is 0, respectively. Therefore, the solar photolysis of MG is an important sink and primarily depends on the photodegradation of the colorless leucocarbinol. During the irradiation of MG leucocarbinol with wavelengths >365 nm, an intermediate was formed which has photocatalytical properties.     

Sequential photochemical-biological degradation of chlorophenols

UV/TiO₂/H₂O₂, UV/TiO₂ and UV/H₂O₂ were compared as pre-treatment processes for the detoxification of mixtures of 4-chlorophenol (4CP), 2,4-dichlorophenol (DCP), 2,4,6-trichlorophenol (TCP) and pentachlorophenol (PCP) prior to their biological treatment. When each chlorophenol was initially supplied at 50 mg l⁻¹, UV/TiO₂/H₂O₂ treatment supported the highest pollutant removal, COD removal, and dechlorination efficiencies followed by UV/TiO₂ and UV/H₂O₂. The remaining toxicity to Lipedium sativum was similar after all pre-treatments. Chlorophenol photodegradation was always well described by a first order model kinetic (r² > 0.94) and the shortest 4CP, DCP, TCP and PCP half-lives of 8.7, 7.1, 4.5 and 3.3 h, respectively, were achieved during UV/TiO₂/H₂O₂ treatment. No pollutant removal was observed in the controls conducted with H₂O₂ or TiO₂ only. Inoculation of all the photochemically pre-treated mixtures with activated sludge microflora was followed by complete removal of the remaining pollutants. Combined UV/TiO₂/H₂O₂-biological supported the highest detoxification, dechlorination (99%) and COD removal (88%) efficiencies. Similar results were achieved when each chlorophenol was supplied at 100 mg l⁻¹. COD and Cl mass balances indicated UV, UV/H₂O₂, and UV/TiO₂ treatments lead to the formation of recalcitrant photoproducts, some of which were chlorinated.     

Photodegradation of 2,4-D induced by NO2- in aqueous solutions：The role of NO2

To elucidate the effect of nitrite ion （NO2^-） on the photodegradation of organic pollutants, a 300 W mercury lamp and Pyrex tubes restricting the transmission of wavelengths below 290nm were used to simulate sunlight, and the photodegradation processes of 2,4-dichlorophenoxyacetic acid （2,4-D） with different concentrations of NO2^- in freshwater and seawater were studied. The effect of reactive oxygen species （ROS） on the photolysis of 2,4-D was also demonstrated using electron paramagnetic resonance （EPR）. The results indicated that the 2,4-D photolysis reaction followed the first-order kinetics in freshwater and seawater under different concentrations of NO2^-. Meanwhile, the photochemical reaction rate of 2,4-D increased with increasing concentration of NO2^-. When the concentration of NO2^- was lower than 23 mg/L, the photodegradation rate of 2,4-D in seawater was higher than that in freshwater. However, when the concentration of NO2^- was reached 230 mg/L, 2,4-D degradation slowed down in seawater. It was important to note that EPR spectra showed NO2 radical was generated in the NO5 solution under simulated sunlight irradiation, indicating that 2,4-D photodegradation could be induced by NO2. These results show the key role of NO2^- in photochemistry and are helpful for better understanding of the phototransformation of environmental contaminants in natural aquatic systems.     

Study on photocatalytic degradation of gaseous dichloromethane using pure and iron ion-doped TiO2 prepared by the sol-gel method

The synthesis of TiO₂ and Fe–TiO₂ by sol–gel method is demonstrated and characterized. The characterization of TiO₂ and Fe–TiO₂ is performed with instruments, including TGA/DTA, FTIR, UV–Vis, N₂ adsorption and SEM. Dichloromethane is used for the photocatalytic activity test. From the results of dichloromethane photocatalyitc degradation, the calcined temperature of TiO₂ and the presence of water vapor influence the photocatalytic activity. The optimum doping amount of iron ions is 0.005 mol%, and this can enhance the photocatalytic activity, while too great an amount will make the iron ions become recombination centers for the electron–hole pairs and reduce the photocatalytic activity. UV–Vis diffuse reflectance spectra of Fe–TiO₂ show an increase in absorbency in the visible light region with the increase in iron ions doping concentration The intermediate of dichloromethane photodegradation includes CHCl₃, CCl₄, CH₂Cl₂ and COCl₂. The presence of iron ions may reduce the adsorption of Cl element on the surface of the photocatalyst.