AC-13混合料路面在郑石高速公路的应用

本文针对郑州至石人山高速公路路面上面层施工的工程实践,论述了AC-13原材料的特点及质量控制要求,探讨了AC-13混合料的配合比设计方法,并总结了施工中的质量控制要点.该研究成果可为其他类似工程提供参考和借鉴.     

Leachability of dissolved chromium in asphalt and concrete surfacing materials

Leachate metal pollutant concentrations produced from different asphalt and concrete pavement surfacing materials were measured under controlled laboratory conditions. The results showed that, in general, the concentrations of most metal pollutants were below the reporting limits. However, dissolved chromium was detected in leachate from concrete (but not asphalt) specimens and more strongly in the early-time leachate samples. As the leaching continued, the concentration of Cr decreased to below or close to the reporting limit. The source of the chromium in concrete pavement was found to be cement. The concentration of total Cr produced from leachate of different cement coming from different sources that was purchased from retail distributors ranged from 124 to 641 μg/L. This result indicates that the potential leachability of dissolved Cr from concrete pavement materials can be reduced through source control. The results also showed that the leachability of dissolved Cr in hardened pavement materials was substantially reduced. For example, the concentration of dissolved Cr measured in actual highway runoff was found to be much lower than the Cr concentration produced from leachate of both open and dense graded concrete pavement specimens under controlled laboratory study. It was concluded that pavement materials are not the source of pollutants of concern in roadway runoff; rather most pollutants in roadway surface runoff are generated from other road-use or land-use sources, or from (wet or dry) atmospheric deposition.     

Characteristics of the event mean concentration (EMC) from rainfall runoff on an urban highway

The purpose of this study was to investigate the characterization of the event mean concentration (EMC) of runoff during heavy precipitation events on highways. Highway runoff quality data were collected from the 7th highway, in South Korea during 2007-2009. The samples were analyzed for runoff quantity and quality parameters such as COD_cr, TSS, TPHs, TKN, NO₃, TP, PO₄ and six heavy metals, e.g., As, Cu, Cd, Ni, Pb and Zn. Analysis of resulting hydrographs and pollutant graphs indicates that the peak of the pollutant concentrations in runoff occurs 20 min after the first rainfall runoff occurrence. The first flush effect depends on the preceding dry period and the rainfall intensity. The results of this study can be used as a reference for water quality management of urban highways.     

隧道内不同行驶工况下CO浓度分布及预测模式研究

本文通过现场实测,获取了在不同行驶工况下深圳市横龙山隧道内CO浓度分布情况.结果表明,在堵车、缓行及正常行驶3种情况下,隧道入口、隧道中及隧道出口的CO浓度均逐渐升高,堵车时隧道内CO浓度最高,正常行驶时的浓度最低.采用环保部机动车排污监控中心关于在用车综合排放因子的研究成果中第3阶段汽车尾气排放标准计算隧道内CO浓度,结果与实测数据相符,CO在纵向全射流通风隧道内扩散规律符合一维纵向空气质量扩散方程.     

汽车驾驶操作信息数据库与采集系统设计

为提高驾驶操作监控技术研究效率 ,对驾驶操作数据、影响因素、车辆状态运行数据等进行分析并在此基础上进行了驾驶操作信息数据库概念结构、逻辑结构以及物理结构的设计。同时为提高驾驶操作数据采集的真实性 ,设计由工业控制计算机、数据采集卡、视觉传感器、力传感器、光电编码器、节气门开度传感器、传感器电路等组成车载驾驶操作信息多传感器采集实验系统 ,并分析了驾驶操作信息管理软件模块构成。     

黑河机场公路建设对生态环境的影响及防治对策

以黑河机场路建设为例,分析、评价了公路建设在施工期和运行期造成的植被破坏、水土流失、土壤和农业生产破坏、湿地功能受损等生态环境影响,提出了防治对策与建议。     

湘境国道4项目危险品运输风险环境影响分析方法研究

根据具体范例，分析了公路项目危险品运输风险环境影响评价的分析方法，其研究成果对开展同类项目危险品运输风险环评有重要的参考价值。     

Using native plants as problem-solvers

The Federal Highway Administration encourages state highway agencies to use native plants in erosion control, revegetation, and landscaping solutions. This paper explains both policy reasons and technical reasons for the use of native plants. How native species can be used is shown through a roadside case study. Other applications of native plant use will be explained through a plant community approach.     

从竣工环境保护验收调查分析公路噪声环评的有效性

从所选的40条公路的竣工环境保护验收报告入手,对公路建成后与环境影响评价阶段噪声敏感点的数量变化、噪声实测值与环评预测值的差异、实际的噪声防治措施与环评确定措施的差异进行了对比分析.结果表明,以上3个方面在公路建成后与环评阶段均存在较大变化,公路噪声环境影响评价的有效性亟待提高.造成这一状况的主要原因包括项目投资机制、运营期相关条件变化等.通过分析,提出了实现全过程的环境影响评价与管理、提高预测的准确性及增强防噪措施的可操作性等促进环评有效性的相关对策建议.     

高速公路交通噪声经验预测模式探讨

通过对浙江省内各高速公路交通噪声实测数据的分析,总结和探讨较为简便的高速公路交通噪声经验预测模式,主要讨论车流量、受声点离公路距离和噪声等效声级的相关性,为高速公路交通噪声环境影响预测与评价提供参考。