Sources of fine particles in the South Coast area,California

PM_2.5 (particulate matter less than 2.5 μm in aerodynamic diameter) speciation data collected between 2003 and 2005 at two United State Environmental Protection Agency (US EPA) Speciation Trends Network monitoring sites in the South Coast area, California were analyzed to identify major PM_2.5 sources as a part of the State Implementation Plan development. Eight and nine major PM_2.5 sources were identified in LA and Rubidoux, respectively, through PMF2 analyses. Similar to a previous study analyzing earlier data (Kim and Hopke, 2007a), secondary particles contributed the most to the PM_2.5 concentrations: 53% in LA and 59% in Rubidoux. The next highest contributors were diesel emissions (11%) in LA and Gasoline vehicle emissions (10%) in Rubidoux. Most of the source contributions were lower than those from the earlier study. However, the average source contributions from airborne soil, sea salt, and aged sea salt in LA and biomass smoke in Rubidoux increased.To validate the apportioned sources in this study, PMF2 results were compared with those obtained from EPA PMF (US EPA, 2005). Both models identified the same number of major sources and the resolved source profiles and contributions were similar at the two monitoring sites. The minor differences in the results caused by the differences in the least square algorithm and non-negativity constraints between two models did not affect the source identifications.     

Clogging of Filtering Material Systems Used for Disposable Respirators

The article shows the problem of clogging in connection with the parameters of filtering materials used in respiratory protective equipment. The results of investigations of airflow resistance changes during the depositing of dust inside the filtering material are presented. The configuration of layers differing in mass per unit area and the number of layers, were taken into consideration. For each configuration, the clogging abilities and the changes of airflow resistance as a reason of loading with dust were assessed. The analysis of tested materials confirms the hypothesis that there is an important coincidence between the properties of the material used in filtering equipment and the clogging coefficient. The results show that the filter should have a layered structure and that the outer layer should be made of a nonwoven of relatively high surface density.     

Aspects of Tests and Assessment of Filtering Materials Used for Respiratory Protection Against Bioaerosols. Part II: Sweat in the Environment,Microorganisms in the Form of a Bioaerosol

The second part of the article presents the results of a study of antimicrobial activity of filter nonwovens with an addition of biocides, as a function of the presence of sweat in the environment and the method of microbe deposition on a nonwoven in the form of a liquid and a bioaerosol. At the same time, the filtration efficiency of nonwovens against microorganisms in the form of a bioaerosol was tested with the dynamic method. The results showed that the addition of sweat on the surface of a nonwoven resulted in an insignificant decrease of biological activity that still remained high. Moreover, an active nonwoven showed biostatic and biocidal activity only when microbes were deposited on the surface in the form of a solution. The nonwoven did not show any biological activity after deposition of microorganisms with the dynamical method in the form of a bioaerosol.     

A Contribution to the Study of the Antidust Respirators’ Real Performance

In most industrial enterprises, hazardous factors are present in quantities exceeding permissible levels. Such a situation requires using antidust respiratory protection. It has been suggested, however, that filters for respirators are not assessed properly and that lab results might not be related to real filtering efficiency in industry. This article contains test results of some commercially available filtering half-masks, including the effect of loading with real dust, high humidity, high temperature, and a combination of loading with dust and high humidity on the half-masks’ performance. The results show that the effect of these factors is considerable and that a combination of loading with silica dust and exposing to high humidity can cause a complete loss of performance.     

The effect of the corticosteroid hormone cortexolone on the metabolites produced during phenanthrene biotransformation in Cunninghamella elegans

The metabolism of phenanthrene and the mammalian corticosteroid hormone cortexolone by the fungus Cunninghamella elegans was studied. The amounts of the cortexolone transformation products, cortisol and epicortisol, were affected by the presence of phenanthrene. Approximately 40% more cortisol was produced by C. elegans in cultures with phenanthrene. In contrast, epicortisol formation decreased. C. elegans transformed phenanthrene to phenanthrene trans-1,2-,3,4-, and 9,10-dihydrodiols, phenols, diphenols (diols) and glucoside conjugates of 1-, 2-, 3-, 4-, and 9-phenanthrols. Almost all of the phenanthrene initially added was metabolized to ethyl acetate extractable metabolites. In the mycelia and culture medium extracts, phenanthrol glucosides represented 80% and 94% of the total metabolites, respectively. The major metabolite was the glucoside conjugate of 1-phenanthrol. The presence of cortexolone affected the biodegradation of phenanthrene by decreasing the amounts of phenanthrene metabolites compared to control cultures.     

Snowpack-stored atmospheric surface-active contaminants traced with snowmelt water surface film rheology

Environmental Science and Pollution Research - The aim of the study was to quantify the adsorptive and thermo-elastic properties of snowmelt water surface films and their spatial-temporal evolution...     

Effect of 30 years of road traffic abandonment on epiphytic moss diversity

Road traffic emits a cocktail of pollutants that can influence the vegetation and plant diversity in neighboring areas. However, the recovery potential of bryophytes after traffic abandonment is still little explored. In addition, the effects of the main pollutants of road verges, such as metals and salinity, on moss flora need to be investigated. In our study, we compared the moss richness and diversity in two closely related veteran tree allees of high conservation importance. The allees in Gry?ów and Lubrza, Poland, were chosen because of their similarity in age, geographical location, type of surrounding areas, and tree species. The only difference was that the trees in Gry?ów had not been exposed to direct road pollution for almost 30 years. The moss richness and diversity differed significantly between the sites. Altogether, 20 moss species were recorded on 229 trees, 17 species in Gry?ów (abandoned road), and 13 in Lubrza (busy road). We found considerable differences between moss cover on the road-facing and opposite sides of tree trunks. In Lubrza, mosses on the road-facing side were very scarce. The moss cover in Gry?ów was highly balanced between trunk sides as well as among trunk heights. Typical epiphytic species such as Bryum moravicum, Dicranoweisia cirrata, Leskea polycarpa, and Orthodicranum tauricum preferred the Gry?ów tree stands, where they were present in numbers almost twice as high as that at Lubrza. The study shows that constructing a bypass road could be an effective conservation measure for veteran tree protection with their epiphytic moss flora.     

The field experiments and model of the natural dust deposition effects on photovoltaic module efficiency

Environmental Science and Pollution Research - The maximisation of the efficiency of the photovoltaic system is crucial in order to increase the competitiveness of this technology. Unfortunately,...     

Effect of Nb doping on structural, optical and photocatalytic properties of flame-made TiO2 nanopowder

TiO₂:Nb nanopowders within a dopant concentration in the range of 0.1?C15?at.% were prepared by one-step flame spray synthesis. Effect of niobium doping on structural, optical and photocatalytic properties of titanium dioxide nanopowders was studied. Morphology and structure were investigated by means of Brunauer?CEmmett?CTeller isotherm, X-ray diffraction and transmission electron microscopy. Diffuse reflectance and the resulting band gap energy were determined by diffuse reflectance spectroscopy. Photocatalytic activity of the investigated nanopowders was revised for the photodecomposition of methylene blue (MB), methyl orange (MO) and 4-chlorophenol under UVA and VIS light irradiation. Commercial TiO₂-P25 nanopowder was used as a reference. The specific surface area of the powders was ranging from 42.9?m²/g for TiO₂:0.1?at.% Nb to 90.0?m²/g for TiO₂:15?at.% Nb. TiO₂:Nb particles were nanosized, spherically shaped and polycrystalline. Anatase was the predominant phase in all samples. The anatase-related transition was at 3.31?eV and rutile-related one at 3.14?eV. TiO₂:Nb nanopowders exhibited additional absorption in the visible range. In comparison to TiO₂-P25, improved photocatalytic activity of TiO₂:Nb was observed for the degradation of MB and MO under both UVA and VIS irradiation, where low doping level (Nb?<?1?at.%) was the most effective. Niobium doping affected structural, optical and photocatalytic properties of TiO₂. Low dopant level enhanced photocatalytic performance under UVA and VIS irradiation. Therefore, TiO₂:Nb (Nb?<?1?at.%) can be proposed as an efficient selective solar light photocatalyst.     

Assessment of microbial contamination within working environments of different types of composting plants

The objective of the study was to determine the degree of microbiological contamination, type of microflora, bioaerosol particle size distribution, and concentration of endotoxins in dust in different types of composting plants. In addition, this study provides a list of indicator microorganisms that pose a biological threat in composting facilities, based on their prevalence within the workplace, source of isolation, and health hazards. We undertook microbiological analysis of the air, work surfaces, and compost, and assessed the particle size distribution of bioaerosols using a six-stage Andersen sampler. Endotoxins were determined using gas chromatography–mass spectrometry (GC-MS). Microbial identification was undertaken both microscopically and using biochemical tests. The predominant bacterial and fungal species were identified using 16S rRNA and ITS1/2 analysis, respectively.?The number of mesophilic microorganisms in composting plants amounted to 6.9 × 10²–2.5 × 10⁴ CFU/m³ in the air, 2.9 × 10²–3.3 × 10³ CFU/100 cm² on surfaces, and 2.2 × 10⁵–2.4 × 10⁷ CFU/g in compost. Qualitative analysis revealed 75 microbial strains in composting plants, with filamentous fungi being the largest group of microorganisms, accounting for as many as 38 isolates. The total amount of endotoxins was 0.0062–0.0140 nmol/mg of dust. The dust fraction with aerodynamic particle diameter of 0.65–1.1 μm accounted for 28–39% of bacterial aerosols and 4–13% of fungal aerosols. We propose the following strains as indicators of harmful biological agent contamination: Bacillus cereus, Aspergillus fumigatus, Cladosporium cladosporioides, C. herbarum, Mucor hiemalis, and Rhizopus oryzae for both types of composting plants, and Bacillus pumilus, Mucor fragilis, Penicillium svalbardense, and P. crustosum for green waste composting plants. The biological hazards posed within these plants are due to the presence of potentially pathogenic microorganisms and the inhalation of respirable bioaerosol. Depending on the type of microorganism, these hazards may be aggravated or reduced after cleaning procedures.

Implications:?This study assessed the microbial contamination in two categories of composting plants: (1) facilities producing substrates for industrial cultivation of button mushrooms, and (2) facilities for processing biodegradable waste. Both workplaces showed potentially pathogenic microorganisms, respirable bioaerosol, and endotoxin. These results are useful to determine the procedures to control harmful biological agents, and to disinfect workplaces in composting plants.