Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

无砾石微孔管地下渗滤系统试验研究

针对传统无砾石管式地下渗滤系统存在的处理性能差,渗滤通量低两个问题,通过去掉包裹织物,提高渗滤管开孔率、改变开孔方式,设计了无砾石微孔管地下渗滤系统。通过实验研究表明,无砾石微孔管地下渗滤系统对COD、氨氮的去除率比传统管式系统分别提高了10.8%、12.7%,总磷去除率并无显著差异,ORP值提高约85 mV,渗滤通量提高26.8%。在3.3 cm/d的水力负荷下,无砾石微孔管地下渗滤系统出水COD、氨氮、总磷平均浓度分别为19 mg/L,0.62 mg/L,0.048 mg/L。渗滤管下10 cm的土壤层去除了约70%的COD,80%的氨氮和91%的总磷,向下随着土壤深度的增加,单位厚度的土壤层去除的污染物量呈显著下降趋势。     

等离子体催化降解有机废水研究

研究了多种因素对高压脉冲介质阻挡放电低温等离子体法处理印染废水效果的影响。通过实验得出结论:随着有效处理时间和峰值外施电压的增加,废水中的有机物的去除率增加;随着水样浓度的增加,废水中有机物的去除率降低;随着催化剂(TiO)2量的增加,废水中有机物的去除率先升高后降低,最佳催化剂的加入量为0.5 g/L TiO2悬浮液0.5 mL。     

有关斜管沉淀池的上升流速讨论

文章从理论上了分析斜管沉淀池上升流速对沉淀池处理效果的影响,及原水特性与斜管沉淀池上升流速取值的关系。讨论分析斜管沉淀池设计时,应根据原水特性不同选择不同的斜管沉淀池上升流速。     

静电除尘器的粉尘非稳态收集过程

为了全面揭示电除尘器粉尘非稳态收集过程,建立完整的非稳态静电收尘理论,根据静电学基本原理,研究了极板粉尘层电荷导人、积累、释放的过程,推导出随粉尘层厚度增长而改变的动态收尘电场强度计算公式,进而得到荷电粒子动态驱进速度公式,最终形成静电除尘非稳态收集理论.研究结果表明,在静电收尘过程中,粒子驱进速度与粉尘比电阻、工作电压、粉尘层厚度等多种因素有关;随粉尘比电阻的升高,收尘效率下降,当供电电压为最佳工作电压时收尘效率最高.针对不同比电阻粉尘进行了多项实验研究,实验结果与理论研究结果吻合.非稳态静电收尘理论成功地解释了实际静电收尘过程中与传统静电收尘理论相矛盾的地方,为静电除尘器的设计及其运行参数的选取提供了更为科学的理论基础.     

高浓度苯酚的MFC降解及产电性能

以铁氰化钾溶液作为电子受体,在阴阳两极室中分别填充石墨颗粒的基础上构建了填料型微生物燃料电池(Microbial Fuel cell,MFC),研究了苯酚为单一燃料和苯酚 葡萄糖为混合燃料条件下MFC的产电特性以及对苯酚和COD的去除效果.在1OOOΩ外电阻条件下,1000mg·L-1苯酚为单一燃料运行时,MFC在苯酚去除率达到约90%时输出电压达到最大值,最大输出电压为540mV,产电曲线存在单一极大值;以1000 mg·L-1苯酚 500 mg·L-1葡萄糖为混合燃料运行时,最大输出电压可达657mV,产电曲线存在2个峰值,第1峰值和第2峰值出现时对应的苯酚去除率分别约为20%和90%.混合燃料运行条件下,前后2个产电峰值出现时MFC的最大体积(面积)功率密度分别为28.3w·m-3(342.OmW·m-2)和12.6 w·m-3(152.2mW·m-2),内阻分别为194Ω和246Ω.在2种燃料情形下,MFC对苯酚和COD的去除率均可在60h之内分别达到95%和90%以上.试验结果表明,MFC能够利用高浓度苯酚作为燃料,在实现高效降解的同时稳定地向外输出电能,这为酚类难降解有机物的高效低耗处理提供了新的研究思路.     

中国污染征税体系的几个问题与解决思路

中国污染征税体系主要包括排放税、排污许可证、技术政策、命令和控制措施等.理论上各种减排工具的绩效比较以经济效率为标准,将私人成本与社会成本协调一致才能实现帕累托最优,实践中则存在税率过低、总量控制不严等问题.本文尝试以提高税率和排污交易制度化等思路解决上述弊病,实现节能减排,提高社会福利水平.     

煤矿矿井水中SO2-4的去除方法研究

制备了高效SO2-4吸附剂,用其对某煤矿矿井水进行了试验,对影响吸附剂吸附效率的各因素进行了研究,结果表明:吸附剂用量1.0 g/L时,去除率达到最高,为93.5%.溶液在酸性范围内吸附剂对SO2-4去除率明显大于碱性范围.随着SO2-4浓度的增加,吸附剂的去除率逐渐降低.试验水温选择为25℃,最佳吸附时间为40 min,最佳pH为7.0.     

低温等离子体技术处理烟草臭气

在烟草生产过程中产生的废气是一种臭气污染.利用低温等离子体技术处理烟草废气,使排放气体达到<环境空气质量二级标准>(GB3095-1996),为进一步提高等离子体设备的处理效率提供了依据.实验中还考察了气体流量及设备功率变化对处理效率的影响,结果表明,处理系统中等离子体反应器体积不宜过大,在今后的应用中可以考虑针对不同的处理气量,采用反应器并联的形式;设备功率为6kw时,处理效率较高.