Heterogeneous photocatalytic decomposition of benzene on lanthanum-doped TiO2 film at ambient temperature

Lanthanum-doped anatase TiO₂ thin films on glass prepared via a sol–gel process have been shown to have much higher photocatalytic activity for the degradation of gaseous benzene than pure anatase TiO₂ thin film. The photodecomposition of benzene on both types of TiO₂ films follows the first-order kinetics while the CO₂ and CO formation followed the zero-order kinetics. GC/MS identification of the intermediates produced during the photodegradation of benzene revealed that doping lanthanum into TiO₂ thin film favors a cleavage of benzene ring. An optimal lanthanum amount with respect to photocatalytic activity was about 2.5 wt% (La₂O₃/TiO₂).     

便携式气相色谱法测定室内空气中的苯系物

介绍了FFKM301便携式气相色谱仪在室内空气苯系物现场监测中的应用,通过对便携式气相色谱仪柱温、压力、泵抽时间和反吹时间等条件的讨论,确定了最佳的方法设置:柱温60℃、压力12psi、泵抽时间20s、反吹时间300s,该方法的检出限为10ppb(苯),精密度小于6%,与经典的气相色谱法进行对比试验,相对偏差不超过20%,能够满足室内空气苯系物的监测要求。     

Benzene degradation in waste gas by photolysis and photolysis-ozonation: experiments and modeling

A photochemical model of benzene degradation compares well with experimental data obtained in the Lab. 62 reactions were needed to fully describe benzene degradation. A feasibility study shows that the photolysis of benzene is a cost-effective process. Experimental data and modeling results show that the degradation efficiency will increase when the combination of UV light and ozone is used. The degradation of benzene, a carcinogenic air pollutant, was studied in a gas-phase photochemical reactor with an amalgam lamp emitting ultraviolet light at 185 and 254 nm. Efficient benzene degradation (>70%) was possible for benzene mass flow rates of up to 1.5 mg·min⁻¹. Adding ozone allowed benzene mass flow rates of up to 5 mg·min⁻¹ to be treated with the same efficiency. In terms of energy consumption, ozone doubles the efficiency of the process. A comprehensive mechanistic simulation model was developed incorporating a chemical kinetics model (62 reactions involving 47 chemical species), a material balance model incorporating diffusion and flow, a flow velocity model, and a light field model. The model successfully predicted the efficiency of the reactor, generally within 20%, which indicates that the model is sound, and can be used for feasibility studies. The prediction of the reactor efficiency in the presence of ozone was less successful, with systematically overestimated efficiency. Condensation of reaction products in the reactor is thought to be the main cause of model inaccuracy. Both experimental data and model predictions show that there is a synergistic effect between ozonation and ultraviolet degradation.     

西南某化工园区周边区域环境空气中苯系物和卤代烃的污染特征及健康风险研究

于2020年8月和11月,在中国西南某化工园区周边6个采样点采集环境空气样品,对5种典型苯系物(苯、甲苯、乙苯、邻二甲苯、间/对二甲苯)和7种典型卤代烃(三氯甲烷、三氯乙烯、四氯化碳、四氯乙烯、三溴甲烷、一溴二氯甲烷和二溴一氯甲烷)进行研究,明确了区域典型苯系物和卤代烃(BSHs)的污染特征,并评估其对人体的健康风险。结果表明:化工园区周边环境空气中苯系物检出率均 60%,卤代烃中除三溴甲烷、一溴二氯甲烷和二溴一氯甲烷外,检出率均 50%。苯系物和卤代烃的平均质量浓度分别为4.14～11.19μg/m~3和0.30～10.86μg/m~3。BSHs的浓度夏季低于冬季,这可能与人为的季节性燃烧源有关。苯、四氯化碳和四氯乙烯超过国际WELL建筑标准v2,全年超标率分别为3.33%,8.33%和11.67%。BSHs的非致癌和致癌风险均为成人儿童,成人和儿童的非致癌总风险分别为1.87×10~(-2)和1.26×10~(-2),处于可接受水平;成人和儿童的致癌风险分别为1.76×10~(-3)和1.19×10~(-3),处于不可接受水平。     

顶空气相色谱法快速测定土壤中苯、苯胺和硝基苯

采用顶空气相色谱法快速测定土壤中苯、苯胺和硝基苯,优化了试验条件.方法在0 mg/L～100 mg/L范围内线性良好,苯、苯胺、硝基苯的检出限分别为0.012 mg/kg、0.22 mg/kg、0.083 mg/kg,实际土样测定的RSD≤1.4%,加标回收率为94.0%～102%.     

预冷冻浓缩系统与气相色谱-质谱法测定空气中苯的测量不确定度评定

根据 Top－down技术中的控制图法，运用预冷冻浓缩系统与气相色谱－质谱联用对苯标准样气进行多次测定。通过计算和评定，得出当苯的测定浓度为100×10^－9时，不确定度为5．1×10^－9。     

焦化区苯污染状况及风险评价研究

采用顶空气相色谱法对焦化厂附近不同距离采集的土壤样品中苯含量进行了检测,分析了气象、地理位置等因素对苯含量的影响.结果表明,苯浓度值大小为南>北>东>西,在距离焦化厂200m左右处出现最大值,检测结果与当地风向(主导风向为南风)具有较好的相关性;采用大气污染扩散模型对焦化厂附近空气中的苯浓度和最大落地距离进行了计算,结果与土壤中苯的检出规律具有一致性.通过呼吸暴露法对焦化区居民进行了健康风险和泄漏风险评价结果表明,焦化厂的苯产生源直接排放会对附近居民造成严重的安全隐患(Risk=0.008,略小于警戒线0.01),而经过治理后对当地居民造成的致癌风险会大大减小(Risk=0.001);发生苯泄漏时,在E-F稳定度下,距离焦化区最近的村庄1处的浓度值超过中国居住区大气中有毒物质的最高允许浓度11.7倍,具有较大的风险性.